SAL PAR 20BT Portable Party Sound Box

Product Overview

The SAL PAR 20BT is a portable, two-way, bass-reflex active sound box designed for hobby and party entertainment. It features a built-in rechargeable Li-ion battery, offering approximately 10 hours of operation. The unit includes a built-in amplifier and a multimedia player supporting Bluetooth, USB, FM radio, and external devices via AUX input. It also has a 6.3mm microphone input with karaoke function.

Key Features:

• LED light effects
• Wireless BT connection for music playback from mobile phones, computers, etc.
• MP3 playback from USB devices
• FM radio with automatic station search
• Microphone socket (6.3mm)
• Karaoke function
• 3.5mm AUX audio input
• Built-in Li-ion accumulator with automatic charging (red LED indicator)
• Expected operation time: ~10 hours
• Digital, red LED display
• Compact and portable design
• Includes remote control (CR 2025 3V battery) and microUSB charger (5V/2A)

Usage

The sound box can be operated from its built-in battery, which must be fully charged before first use. Connect the supplied power adapter to the sound box (CHARGE DC 5V microUSB socket) and then to the mains. The red LED will light up during charging. Charging is complete when the red LED turns off, or after approximately 3-3.5 hours for a fully discharged battery. Charging while the device is on may increase charging time.

Important Notes on Charging:

• Only use the supplied adapter. Using a lower-power adapter (e.g., a mobile phone charger) may damage the unit.
• Disconnect the adapter from the mains and the device after charging or use.
• Charging can cause noise in the loudspeakers.
• For extended battery life, keep the battery charged even when not in use.

Installation and Setup

All connections should be made with the system powered off. Ensure correct wiring and polarity. Keep microphone and audio cables away from power cords. Connect the power adapter first to the sound box, then to the power socket.

Set the VOLUME control to the minimum position before switching on. Press and hold the POWER button for 2 seconds to turn on the unit. Gradually increase the volume. Always set VOLUME to minimum before switching on/off to prevent speaker damage from noise impact.

Controls and Functions

Volume can be adjusted using the VOLUME rotary knob or the remote control's VOL+/VOL- buttons. After powering on, the wireless BT function activates automatically if a previously paired device is nearby. Functions can be selected by pressing the INPUT button (or MODE on the remote control): BT USB LINE FM BT.

Maximum Volume

Allow speakers to break in for the first 30-50 hours of operation, using only up to 50% capacity. At higher volumes, distorted sound may occur due to excessive input signal. Reduce the external equipment's signal level or the main volume (VOLUME) if necessary. The system's maximum volume is achieved when sound is clear and undistorted. Increasing volume beyond this point does not increase output power but increases distortion, which can harm the loudspeakers.

When using a microphone, place it as far as possible from the sound box to avoid feedback. Do not point the sound box towards the microphone, as feedback can damage the speakers. Increase volume gradually and reduce it immediately if noise occurs.

Wireless BT Connection

The device can be paired with other BT-enabled devices within a 10-meter range. After successful pairing, you can listen to music from your mobile phone, tablet, or notebook hands-free. Select BT mode (display shows BLUE text). Search for devices on your phone/tablet and select the speaker. A short beep confirms successful connection. Music playback can generally be controlled via the playback device's player (e.g., mobile phone's buttons).

• For older BT2.0 devices, the password may be "0000".
• Only one BT device can be paired at a time.
• The unit automatically reconnects to the last paired device if it's on and nearby.
• If the wireless connection is interrupted, press the INPUT button until BT function and pairing mode reactivate.
• Incoming phone calls will pause music playback.
• BT function performance may vary depending on the external device and environmental conditions (walls, human bodies, other electrical devices).
• Nearby electrical appliances may cause abnormal operation or noise, which does not indicate a device malfunction.
• Network noise may occur in speakers during charging.

MP3 Playback from USB Mass Storage

Insert a USB storage device to automatically switch to USB playback mode. The display shows elapsed time and song number. Playback starts automatically or by pressing the play button (▶️). Press the same button to pause (PAUSE). Use the scroll buttons (▶️▶️ / ◀️◀️) to select tracks or perform a quick search by holding them down. The remote control's RPT button allows repeating the current song (ONE) or all songs (ALL). The EQ button on the front panel can select EQ1-EQ2-EQ3 sound modes.

• The last played track can restart upon power-on.
• Recommended file system: FAT32. Do not use NTFS formatted memory units.
• If no sound is emitted or the USB memory is not recognized, remove and reconnect the memory, then re-select with the INPUT button. Switch the device off and on if necessary.
• Remove external memory only after changing the source or switching off the player to avoid data corruption. Do not remove during playback.
• Insert USB devices carefully; do not force them. Do not touch contacts.
• Be careful not to damage protruding USB devices.
• Abnormal operation may be caused by the mass storage device's features, not a device malfunction.
• Do not charge devices (e.g., mobile phones) from the USB socket.

Radio Usage

Select FM radio mode using the INPUT button. The display shows the reception frequency. Press and hold the play/pause button (▶️) to start automatic tuning and storing. After tuning, the device selects the first found station. Use the scroll buttons (▶️▶️ / ◀️◀️) to access other stations. The display shows program positions P 01...P 50. Holding the scroll buttons starts station search, stopping at the first found signal. Search may stop on variable signal strength, not always indicating a radio program. Radio reception quality depends on location and conditions. Keep the device away from large metal objects or other electrical appliances. Carefully extend the telescopic antenna and adjust for best reception.

Wired Audio Inputs (MIC INPUT, AUX INPUT)

Connect external devices with headphone or audio output via:

• MIC INPUT: 6.3mm socket for handheld microphone (not included).
• AUX INPUT: 3.5mm socket for headphone output or LINE output (mobile phone, tablet, computer, multimedia player).

Sound quality depends on the external device's audio signal quality and its volume/tone settings. It is recommended to switch off the equalizer on the playback device and use the EQ on the sound box only. Low input signal can cause noise; too high a signal can cause distortion. Maintain signal level at medium.

Remote Control

To use the remote control, pull out the insulating board from the battery compartment. If operation becomes uncertain or the range decreases, replace the battery (CR 2025, 3V button cell). Point the remote towards the control panel from 2-3 meters away. To replace the battery, turn the remote upside down, pull out the battery holder, and insert the new battery with the positive side facing up. Remove the battery if the unit will not be used for an extended period. Do not mix battery types or used/new batteries. Battery replacement should be done by an adult. Keep batteries out of reach of children. If battery liquid leaks, wear protective gloves and clean the holder with a dry cloth.

Warning: Risk of explosion if the battery is replaced incorrectly. Use only the same or equivalent battery type. Do not expose batteries to heat or direct sunlight. Do not open, burn, or short-circuit batteries. Do not charge non-rechargeable batteries. Do not use accumulators instead of batteries due to lower voltage and efficiency.

Button Cell Battery Warning: DO NOT SWALLOW THE BATTERY. RISK OF CHEMICAL BURN. Ingestion can cause severe internal burns within 2 hours and may lead to death. Keep new and used batteries out of reach of children. If the battery compartment cover does not close properly, discontinue use and keep away from children. If you suspect a battery has been swallowed or entered any body part, consult a doctor immediately.

Cleaning

Before cleaning, power off the device and unplug it from the mains. Use a soft, dry cloth. Do not use aggressive cleaners or liquids.

Maintenance

Periodically check the power adapter/connection cable and the unit's casing for integrity. If any malfunction occurs, immediately power off the device and contact a specialist.

Troubleshooting

If a malfunction occurs, switch off the device and try turning it back on later. If the problem persists, consult the following notes. This guide can help identify the problem if the device is correctly connected.

Basic Issues

• Device not working, display not lighting: Check if the POWER button was pressed correctly. The built-in battery may be depleted; connect the power adapter and charge it.
• Device operating but no sound: Volume controls might be set too low (check VOLUME knob and remote VOL+/VOL- buttons). Audio cables may be connected incorrectly; check connections and polarity.

MP3 Player Issues

• Not playing from the correct source: Ensure the correct source/device is selected using the INPUT or MODE button.
• MP3 playback not working: Check for file writing errors or incompatible MP3 format. Ensure the MP3 format is appropriate. Check for contact problems with the USB socket; clean if necessary. Ensure the USB device is inserted correctly. Defective or non-standard memory units may cause issues.
• Noisy playback: Check for file writing errors or incompatible MP3 format. Verify data carrier compatibility and connection. Check for data copy errors.

Microphone Issues

• Wired microphone not heard: Check the VOLUME control setting (not at minimum). Ensure the microphone is switched on.

Warnings

Read instructions carefully before use and keep them for future reference. Do not connect cables during operation. Never turn the system on or off at full volume to avoid damaging speakers. Route audio cables away from power cables to protect against external noise. Do not obstruct cooling; keep a distance of at least 20 cm from walls. Warm-up of the casing is normal. Switch off and unplug the adapter after use. Ensure easy access to the power plug and route the power cable safely. Comply with electrical safety rules; do not touch the unit or cable with wet hands. Connect only to 230V~/50Hz outlets with double insulation. Protect from dust, moisture, heat, liquids, frost, impact, and direct sunlight. Use only indoors in dry conditions. Ensure no foreign objects enter openings. Do not expose to splashing water or place liquid-filled objects on the unit. Do not place open flames (e.g., candles) on the unit. Do not disassemble or modify the unit, as it can cause fire, accident, or electric shock. In case of malfunction, power off and contact a specialist. Do not charge mobile phones from the USB socket. Improper operation may occur due to compressed files, software, or USB memory quality, which is not a device defect. Playback of DRM-protected files is not guaranteed. Playback of supported files may be affected by software/hardware conditions. Differences in audio file parameters may cause volume/sound quality variations. The manufacturer is not responsible for lost or damaged data. Backup your data. Do not use USB memory larger than 32 GB, as it may slow down operation. Store only playable files on external memory. Speakers contain magnets; keep sensitive items (e.g., credit cards, compasses) away. Incorrect use or installation voids the warranty. This product is for residential use only. Dispose of the product as hazardous waste according to local regulations. Somogyi Elektronic Ltd. certifies compliance with Directive 2014/53/EU. Technical data and design may change without notice. The latest manual is available at www.somogyi.hu.

Caution: Risk of electric shock! Do not attempt to disassemble or modify the unit or its accessories. In case of damage, power off immediately and seek specialist assistance.

To prevent hearing impairment, do not listen at high volume for extended periods.

Dispose of waste equipment separately from household waste. Contact local waste management organizations for proper disposal. Batteries must not be disposed of with household waste; return them to collection centers or retail shops for environmentally friendly neutralization.

Technical Specifications

Distributor Information

Manufacturer: SOMOGYI ELEKTRONIC®, H-9027 Győr, Gesztenyefa út 3. www.somogyi.hu

Slovakia Distributor: SOMOGYI ELEKTRONIC SLOVENSKO s.r.o., Ul. gen. Klapku 77, 945 01 Komárno, SK. Tel.: +421/0/35 7902400. www.somogyi.sk

Romania Distributor: S.C. SOMOGYI ELEKTRONIC S.R.L., Cluj-Napoca, Str. Prof. Dr. Gheorghe Marinescu, nr. 2. Tel.: +40 264 406 488. www.somogyi.ro

Serbia Distributor: ELEMENTA d.o.o., Jovana Mikića 56, 24000 Subotica, Srbija. Tel:+381 (0)24 686 270. www.elementa.rs

Slovenia Distributor: Elementa elektronika d.o.o., Cesta zmage 13a, 2000 Maribor, Slovenija. Tel.: 386 59 178 322. www.elementa-e.si

Croatia Distributor: ZED d.o.o., Industrijska c. 5, 10360 Sesvete, Hrvatska. Tel: +385 1 2006 148. www.zed.hr

Bosnia and Herzegovina Distributor: DIGITALIS d.o.o., M.Spahe 2A/30, 72290 Novi Travnik, BiH. Tel: +387 61 095 095. www.digitalis.ba