Kogan Slide Out Rangehood

Safety & Warnings

This rangehood is a domestic product manufactured and tested in accordance with International Standard IEC 60335-2-31.

Read all safety instructions before use to avoid injury or damage. Keep this user guide for future reference.

• Young children must be supervised to ensure they do not play with the product.
• This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless supervised by someone responsible for their safety.
• Always switch off the rangehood before performing any maintenance to prevent electric shock.
• Never carry out flambe cooking under the rangehood.
• Do not use the rangehood above barbecues.
• This product is not designed for outdoor or external installation.
• Grease filters must be removed and cleaned at least every four weeks to reduce the risk of fire.
• Do not discharge exhaust air into a heating flue that may carry combustion products from other sources.
• Do not discharge exhaust air into a wall cavity unless it is specifically designed for that purpose.
• Ensure adequate room ventilation when using the rangehood alongside gas or fuel-burning appliances.
• Always cover lit gas burners with pots or pans when the rangehood is in use.
• Always turn off gas burners before removing pots or pans.
• Do not leave lit gas burners exposed beneath the rangehood due to fire risk.
• This appliance is intended to be used in household and similar applications such as:
• Staff kitchen areas in shops, offices and other working environments
• Farm houses
• By clients in hotels, motels and other residential type environments
• Bed and breakfast type environments

Electrical Connection

• Before connecting to the mains supply, check that the voltage matches the rating label inside the rangehood.
• Installation must comply with local building and electrical regulations. If the power cord is damaged, it must be replaced by Kogan.com or a similarly qualified person to avoid a hazard.

Installer warnings

• Minimum clearance from the cooktop to the rangehood must be maintained, as specified in the installation diagrams.
• If you are not confident with the installation, consult a qualified trade professional.

To ensure optimal air extraction:

• Keep the exhaust duct short and straight.
• Do not reduce or restrict the duct diameter.
• Minimise the number of bends in the duct.
• If using flexible ducting, install it with the helix fully extended to reduce pressure loss.
• Failure to follow these guidelines will reduce performance and increase noise levels.
• Exhaust air must not be discharged into a wall cavity or heating flue unless specifically designed for that purpose.

Note: In some installations, the telescopic exhaust cover may need to be cut to length. Use sharp tin snips or a fine-tooth hacksaw blade, taking care not to distort or dent the exhaust cover.

Components

The following components are included with your rangehood:

• Range Hood Body
• Mesh Filter (x2)
• Outler Cover
• Recycling Cover
• Charcoal Filter (x2)
• Damper (x2)
• Outler Adaptor
• Screws (x4)
• Washers (x4)
• User Guide

Overview

The rangehood consists of the following parts:

1. Range Hood Body (controls & lights)
2. Damper (flaps)
3. Outlet Adapter
4. Outlet Cover
5. Recycling Cover
6. Charcoal Filters (optional)
7. Mesh Filters

Installation

Before Installation

• Before installing the appliance, record the model and serial number from the rating plate located on the bottom of the appliance casing.
• The hood must be mounted onto the cabinet's mounting board. Once installed, the distance between the cooktop and the rangehood must be at least 650mm above electric burners or 750mm above gas or mixed-fuel burners. Refer to the image below.

Clearance Requirements:

Gas: 750mm

Electrical: 650mm

Location Diagram

Before installation, ensure the location complies with the following dimensions. All dimensions shown in millimeters.

Front View

Mounting Surface

60cm Model: >552mm width

90cm Model: >852mm width

60cm Model: 598mm depth

90cm Model: 898mm depth

Height: 175mm

Depth from front edge: <103mm

Side View

Mounting Surface

Wall

Door

Depth: >285mm

After Installation

Front View

[Diagram showing front view after installation]

Side View

[Diagram showing side view after installation]

Installation Steps

1. Drill a Ø140mm diameter hole for the exhaust outlet. Also, drill 4 Ø8mm mounting holes and an opening for the power cord, according to the dimensions shown below.

Dimensions for drilling:

60cm Model: 480mm width, 230mm height

90cm Model: 780mm width, 230mm height

Hole diameter for exhaust: Ø140mm

Mounting hole diameter: Ø8mm (x4)

Other dimensions: 92mm, 45mm, 199mm, 268mm, 27mm

2. Insert the 4 mounting screws with the four mounting gaskets to secure the hood to the cabinet.
3. The hood can be installed in either the filtering version or the ducting version. Refer to the diagrams below.
4. Refer to Figures 1 and 2 for the correct positioning of the circulation air door.

Filtering version vs. Ducting version

Filtering version: Air is purified through grease and charcoal filters, then recirculated.

Ducting version: Air is extracted outside through an outlet pipe.

[Diagram illustrating filtering and ducting versions with air flow arrows]

[Diagrams labeled Figure 1 and Figure 2 showing circulation air door positioning for filtering and ducting versions]

Ducting Version

In the ducting version, the hood extracts air from the kitchen that is saturated with fumes and odours. The air passes through the grease filters and is expelled outside through an outlet pipe (not supplied). Charcoal filters are not required in this version. For optimal performance, it is recommended to use the ducting version if possible.

Note: The recycling cover must be installed on the hood body when using the ducting version.

[Diagram showing ducting version with Ø125mm outlet pipe and Recycling Cover]

Filtering Version

In the filtering version, the hood draws in kitchen air saturated with fumes and odours. The air is purified through grease filters and charcoal filters, then recirculated back into the room as clean air. To maintain performance, the charcoal filters must be replaced periodically.

Notes:

• Charcoal filters must be used in the filtering version.
• The recycling cover must be removed in the filtering version.
• The outlet cover must be installed on the hood body in the filtering version.

[Diagram showing filtering version with Outlet Cover and Charcoal Filters]

Electrical Connection

• All electrical wiring must only be performed by a licensed professional in accordance with relevant electrical codes and standards.
• Before installation, turn off power at the main switch to prevent electrical hazards.
• If the power cord is damaged, it must be replaced by Kogan.com, an authorised service agent, or a qualified electrician to avoid safety risks. Cease use immediately and contact help.Kogan.com for support.
• Only use the original power plug and cord supplied with the appliance. Do not use extension cords or alternative power sources.

Operation

Controls

Fan Speed:

• Low
• On/off
• High

Light:

• Light

Cleaning & Care

Always disconnect the product from the power supply before performing any maintenance.

Cleaning the Range Hood

• Clean the exterior of the rangehood with a damp cloth and a solution of water and mild detergent.
• Do not use corrosive, abrasive, flammable cleaners, or products that contain bleach.
• Never insert sharp or pointed objects into the motor's protective grille.
• Only clean the filters with a damp cloth and mild detergent.
• It is essential to clean the unit and replace the charcoal filters at the recommended intervals. Failure to do so may result in grease build-up, posing a fire hazard.

Mesh Filters

Frequency: Every 3 weeks.

The mesh filters are designed to capture grease particles generated during cooking. They must always be used, whether the rangehood is set to ducting or filtering mode.

To remove the metal grease filters:

1. Pull down the latch on the filter.
2. Remove the filter from the hood body.

[Diagram showing removal of mesh filters]

Replace Light

1. Remove the lamp cover.
2. Turn the bulb anticlockwise to loosen and remove it.
3. Replace it with a 2W E14 LED bulb.

[Diagrams showing light replacement procedure]

Charcoal Filter (not applicable for ducted mode)

Frequency: Every 3 months.

• Charcoal filters are only required for use in filtering (recirculating) mode.
• These filters cannot be cleaned or reused.

Replacement Steps:

1. Ensure the rangehood is switched off and disconnected from the power supply before starting.
2. Slide out the front panel.
3. Remove the mesh filters.
4. Pull down the latch and remove the filters to expose the internal fan/motor housing.
5. Locate and remove old charcoal filters. The charcoal filters are usually mounted on either side of the motor casing or directly clipped to the fan housing.
6. Twist them counterclockwise or unclip them depending on the fixing type.
7. Align the new charcoal filters with the fan housing.
8. Secure by twisting clockwise or snapping them into place until firmly fixed.

[Diagram showing charcoal filter removal]

Note: Image is for illustrative purposes only. The actual product or component may differ.

Troubleshooting

Note: This product is fitted with a safety cutout device. If the rangehood is installed too close to the cooker top, flambe cooking, operating the cooktop without cooking utensils and blocked filters may activate the safety cutout device. If the hood stops during operation, correct the faults and allow time for the safety cutout device to reset. Then the rangehood will function correctly.

Dimensions

60cm Model

[Diagram showing dimensions for 60cm model]

Width: 598mm

Depth: 282mm

Height: 175mm

Exhaust Outlet Diameter: Ø122mm

Other dimensions: 26mm, 40mm, 42mm, 51mm, 83mm, 170mm

90cm Model

[Diagram showing dimensions for 90cm model]

Width: 898mm

Depth: 282mm

Height: 175mm

Exhaust Outlet Diameter: Ø122mm

Other dimensions: 26mm, 40mm, 42mm, 51mm, 83mm, 170mm

Notes

[Blank section for user notes]

Need more information?

We hope that this user guide has given you the assistance needed for a simple set-up.

For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.Kogan.com.