SIGMA STS Cadence Transmitter

Installation of Wireless Cadence Transmitter

Mounting the Transmitter:

• Attach the transmitter to the crank arm using the provided rubber bands.
• Ensure the transmitter is positioned correctly on the crank arm.
• The maximum distance between the transmitter and the crank magnet should be 10 mm (0.4 inches).
• The recommended distance between the transmitter and the crank arm is 6 mm (0.24 inches) and 8 mm (0.3 inches) for optimal performance.

Battery Change:

1. Locate the battery compartment on the transmitter.
2. Use a CR 2032 battery.
3. Replace the battery following the indicated polarity.

Compliance Information

Industry Canada Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure. Users can obtain Canadian information on RF exposure and compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 5 millimeters between the radiator and your body.

EU Declaration of Conformity

SIGMA-ELEKTRO GmbH, Dr.-Julius-Leber-Str. 15, D-67433 Neustadt/Weinstraße declares that the transmitter STS-C-3, when used as intended, complies with the basic requirements of RED Directive 2014/53/EU and RoHS Directive 2011/65/EU.

The CE declaration can be found at: ce.sigmasport.com/stsc3

Other languages for CE Declaration:

• French: La déclaration CE peut être consultée ici : ce.sigmasport.com/stsc3
• Italian: La dichiarazione CE è consultabile qui: ce.sigmasport.com/stsc3
• Spanish: Encontrarás la declaración de conformidad CE en: ce.sigmasport.com/stsc3
• Dutch: Je kunt de CE-verklaring hier inzien: ce.sigmasport.com/stsc3
• Polish: Deklarację CE znajdziesz tutaj: ce.sigmasport.com/stsc3
• Czech: CE prohlášení najdeš pod následujícím odkazem: ce.sigmasport.com/stsc3

UKCA Statement

SIGMA-ELEKTRO GmbH declares that the equipment has been tested and found in compliance with the requirement limits of applicable standards, in accordance with the Radio Equipment Regulations 2017 and the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012.

Federal Communication Commission (FCC) Statement

FCC ID: M5LCAD3STS

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices).

FCC Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Technical Information

• Battery type: CR 2032, 3 V
• Operation temperature: -10 °C to 60 °C
• Operation frequency: 112 kHz
• Transmission power: Max power < 11.37 dBm