Braun Air Styler AS4.2
Model: BRAS420E
Safety Instructions
Please read the safety instructions carefully before using the device.
Features
- Power: 1000W
- IONTEC Technology
- 3 style settings, including cool air setting
- Interchangeable attachments with lock:
- Concentrator
- 42mm thermal brush
- 195cm cord
Use
Mount the attachment of your choice on the handle.
To start the air styler, set the switch to a temperature that is appropriate for your hair type. The unit has two temperature settings and a cool-air button.
- For the cool-air function select "✱".
- For moderate heat select the second setting "I".
- For intense heat select the third setting "II".
If your hair is fine, sensitive, coloured or bleached, set the unit to a moderate temperature. If your hair is thicker, use the high temperature.
After use, turn the unit off by setting the switch to the "0" position. Then unplug the power cord. Allow the unit to cool before storing.
To change the attachment, first read the section on "Changing the attachment".
IONTEC Technology
This Braun brush has cutting-edge ionic technology for hair that is soft, shiny and frizz-free.
Changing the attachment
To change the attachment:
- Press the release button downwards (refer to Figure 1).
- While holding the button down, gently turn the attachment to the right until the markings on the attachment and the brush are aligned.
- The attachment can then be removed.
- To fit a new attachment, position it on the handle (refer to Figure 2).
- Turn gently to the left until you hear a click.
Description of Figure 1: Shows a hand pressing a button on the handle and rotating an attachment to remove it.
Description of Figure 2: Shows a new attachment being aligned and pushed onto the handle until it clicks into place.
Attachments
Concentrator
Use the drying nozzle to eliminate excess dampness and prepare for styling by directing the air flow at the hair, all around your head.
42mm Round Thermal Brush
Place the brush under a section of hair, near the roots. Use the brush to lift the hair at the roots to create volume. Slowly slide the brush along the section from roots to tips. Repeat for each section. Finishing: roll the ends of the hair either under or out.
Cleaning & Maintenance
General Information
- Ensure the unit is switched off, unplugged, and has cooled down.
- Use a damp cloth to clean the exterior of the unit.
- Make sure no water seeps into the unit and that it is completely dry before use.
- Do not wrap the cord around the unit; instead, leave it loosely coiled to the side.
- Do not pull on the power cord while using the unit.
- Always unplug the unit after use.
Cleaning the Rear Filter
- Ensure the unit is switched off, unplugged, and has cooled down.
- To maintain the efficiency of the Air Styler, clean the rear grille regularly using the brush provided.
- To remove the filter, hold the handle firmly and gently turn the filter downwards (refer to Figure 3). Then pull it out.
- When finished cleaning the filter, replace it before using the unit (refer to Figure 4).
Description of Figure 3: Shows the filter being turned downwards to detach it from the back of the device.
Description of Figure 4: Shows the filter being reinserted into the device.
Warranty
2 years. For more information, please contact the after-sales service.
