Braun AS2.2 Air Styler with IONTEC Technology

Safety Instructions

Please read the safety instructions carefully before using the device.

Features

• Power: 700W
• IONTEC Technology
• 3 style settings, including cool air setting
• Interchangeable attachments with lock:
  • Concentrator
  • 40mm thermal brush
• 195cm cord

How to Use

Mount the attachment of your choice on the handle.

To start the air styler, set the switch to a temperature appropriate for your hair type. The unit has two temperature settings and a cool-air function:

• Cool-air setting: select "*"
• Moderate heat: select "I"
• Intense heat: select "II"

For fine, sensitive, coloured, or bleached hair, use a moderate temperature. For thicker hair, use the high temperature.

After use, turn the unit off by setting the switch to the "0" position. Then unplug the power cord. Allow the unit to cool before storing.

IONTEC Technology

This Braun brush features cutting-edge ionic technology for soft, shiny, and frizz-free hair.

Changing the Attachment

To change the attachment:

1. Press the release button downwards (see Figure 1: Diagram illustrating the attachment release mechanism) and hold it in this position.
2. Gently turn the attachment to the right until the markings on the attachment and the brush are aligned.
3. The attachment can then be removed.
4. To fit a new attachment, position it on the handle (see Figure 2: Diagram showing how to attach a new accessory) then turn gently to the left until you hear a click.

Attachments

Concentrator

Use the drying nozzle to eliminate excess dampness and prepare for styling by directing the air flow at the hair, all around your head.

40mm Round Thermal Brush

Place the brush under a section of hair, near the roots. Use the brush to lift the hair at the roots to create volume. Slowly slide the brush along the section from roots to tips. Repeat for each section.

Finishing: roll the ends of the hair either under or out.

Cleaning & Maintenance

General Information

To keep your Air Styler in the best possible condition, follow these instructions:

• Ensure the unit is switched off, unplugged, and has cooled down.
• Use a damp cloth to clean the exterior of the unit.
• Make sure no water seeps into the unit and that it is completely dry before use.
• Do not wrap the cord around the unit; leave it loosely coiled to the side.
• Do not pull on the power cord while using the unit.
• Always unplug the unit after use.

Cleaning the Rear Filter

• Ensure the unit is switched off, unplugged, and has cooled down.
• To maintain the efficiency of the Air Brush, clean the rear grille regularly using the brush provided.
• To remove the filter: hold the handle firmly, gently turn the filter downwards (see Figure 3: Diagram showing the filter being turned downwards for removal), and then pull it out.
• After cleaning the filter, replace it before using the unit again (see Figure 4: Diagram showing the filter being replaced).