Liebherr SmartCoolingHub

Materials Required

Included in the delivery

• SmartCoolingHub
• Power supply unit with adapters for EU, UK and USA
• 2x RS485 connectors
• 1.5 m cable
• Other connectors and cables are available as Liebherr accessories.

Not included in the delivery

• Liebherr networkable appliance
• Computer or tablet with internet access
• Compatibility check on SmartMonitoring website
• Slotted screw driver size: 2.5 mm
• LAN cable (if there is a LAN network connection)

Preparation

For assistance with set-up, please contact Liebherr Service (see contact info in the full manual or on the Liebherr website).

The plug-in power supply must be assembled for the local socket standard. Select an adapter and slide onto the power supply unit until it clicks into place. A power connection designed for the power supply unit should be located near the SmartCoolingHub.

A broadband Internet connection is required, either with a wireless network (WLAN 2.4 GHz) or a wired connection (Ethernet/LAN). For a WLAN connection, the SSID must be visible.

Share the following network ports within your network and at the Internet transition point (keyword: Firewall):

• DNS: Port 53 (OUT) UDP/TCP
• NTP: Port 123 (OUT) UDP
• HTTPS: Port 443 (OUT) TCP
• Secure MQTT: Port 8883 (OUT) TCP, 8884 (OUT) TCP

WiFi standard: IEEE 802.11 b/g/n 2.4 GHz, WPA2-PSK. Alternatively, automatic UPnP port sharing (Universal Plug and Play) can be used.

Ensure DHCP mode is active (automatic IP address assignment). If your network uses a MAC filter, the MAC address of the SmartCoolingHub (found on the label on the back) must be shared in the network.

An Internet-enabled device with a current browser version and a minimum resolution of 1024x768 pixels is required to access SmartMonitoring.

For your convenience, make a note of the serial numbers of your refrigeration appliances in advance.

A MyLiebherr customer profile is required to log in to the SmartMonitoring dashboard (registration is possible during set-up).

Additional accessories are needed to set up other appliances. Recommendation: one SmartCoolingHub per room.

If the distance between the SmartCoolingHub and the appliance is greater than 50 m, consult a qualified technician for installation.

Getting Started

Start the set-up process at the following address: smartmonitoring.liebherr.com/setup or scan this QR-Code: [QR Code for setup]

On the setup page, you will also find:

• Set-up videos
• Appliance instruction manual
• SmartMonitoring instruction manual

LED Status Description

Further Information

For more information, refer to the SmartMonitoring instruction manual.