DieseRC 2201H Relay Remote Control Switch

Product Information

Type: 2201H

Working Voltage: AC 85V~250V

Input/Output Voltage: AC 85V~250V

Output Type: Active output

Technical Data

• Quiescent Current: <5MA
• Max Current: 30A
• RF Frequency: 433MHz
• Working Temperature: -30~+80°C
• Receiving Sensitivity: >97dbm
• Amount of Storage: 20 remote controls
• Support Encoding: 1527 Leaning code, 2262 fixed code
• RF Operating Mode: ASK superheterodyne wireless reception
• Receiving Range: Open space is more than 50 meters

Product Detail

The product features an antenna and a protective shell.

Wiring Diagram

The wiring diagram shows connections for AC 85V~250V input and output, with a relay and a pump.

Operating Modes & Programming

Warning:

• Usually, the receiver and transmitter are pre-paired. If not, reprogram them.
• Reset before changing operating modes.
• After reset, all remote controls will no longer function until reprogrammed.
• Replace the remote transmitter battery when low for stronger signal transmission.
• Slightly stretch the antenna on the receiver for better signal reception.
• The remote transmitter needs 2 or more buttons for Latched Mode.

Momentary Mode

Operation: Press and hold the button, the relay turns on; release the button, the relay turns off.

Programming:

1. Press the learning button (on the receiver) 1 time. The indicator LED on the receiver will light up.
2. Press one button on the remote transmitter. The indicator LED on the receiver will flash several times and then light down.

Toggle Mode

Operation: Press button "A", the relay turns on; press button "A" again, the relay turns off.

Programming:

1. Press the learning button (on the receiver) 2 times. The indicator LED on the receiver will light up.
2. Press one button on the remote transmitter. The indicator LED on the receiver will flash several times and then light down.

Latched Mode

Operation: Press button "A", the relay turns on; press button "B", the relay turns off.

Programming:

1. Press the learning button (on the receiver) 3 times. The indicator LED on the receiver will light up.
2. Press button "A" on the remote transmitter. The indicator LED on the receiver will flash several times and then light up.
3. Press button "B" on the remote transmitter. The indicator LED on the receiver will flash several times and then light down.

Reset

Press the learning button (on the receiver) 8 times. The indicator LED on the receiver will flash several times and then light down.

Troubleshooting

• Issue: Receiver and transmitter not operating normally.
• Solutions:
  1. Check battery power. The indicator LED on the remote transmitter may not light up or be dimly lit.
  2. Verify receiver wiring is correct.
  3. Reprogram the receiver and transmitter.
  4. If the problem persists, contact customer service.

Customer Service

For any questions about the products, please contact DieseRC.

Email: dieseelectronic@163.com

WhatsApp: +86 13502278583 / +86 18138805271

Company: Huizhou Wenqiao Electronic Technology Co., Ltd.

Address: 1203, Building T19, Fangzhilonghuwan, Sanhuan South Road, Huicheng District, Huizhou City, Guangdong Province, China 516000

CE FC