Hoco W35 Wireless Headphones Instruction Manual

Headphones Overview

A diagram shows the headphones with numbered parts:

• 1. LED indicator
• 2. Audio port
• 3. Type-C charging port
• 4. Microphone
• 5. TF card interface
• 6. Play/Pause/Off/On button
• 7. Next song / volume up button
• 8. Previous song/volume down button
• 9. Mode switch button

Specifications

Warning

1. Do not expose the product to high temperatures, corrosive or high-pressure environment.
2. Do not attempt to disassemble the headphones, or to replace any electronic components in it.
3. If the internal devices have fluid leakage, please stop use.
4. Do not expose the battery (battery or combined battery) to excessive heat such as sunlight, fire or similar.

How to use

1. Press and hold the power button for 3 seconds until the red and blue LED lights flash alternately.
2. Activate the BT function of the mobile device.
3. Search for "BT2212".

Headphones Controls

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.