S SERENITY

Safety

• Read the instructions and keep them for future reference. By following these safety instructions, you can use the device safely and prevent damage to the device or injury to persons.
• Before use, ensure that the package contains all parts listed in the technical specifications and that the device parts are intact. Do not use the appliance if any parts are missing or damaged.
• Do not attempt to repair the device parts yourself. Take the device to the retailer or an authorised service centre if any parts are faulty.
• Remove all protective plastics and stickers from the device.
• Use the appliance only in dry indoor environments at room temperature.
• Do not expose the appliance to water or other liquids.
• Do not expose the device to fire, direct sunlight, or other heat sources, excessive cold, or corrosive substances.
• The device can also be used by children over 8 years old and persons with physical or mental limitations, or persons without experience or knowledge of how to use the device, provided they have been instructed on its safe use or are under appropriate supervision and understand the risks associated with it. Children should not play with the device. Children should not clean or maintain the device without supervision.
• Charge the device's battery full whenever the battery level is low. Regularly charge the battery even if you are not using the device frequently.
• Charge the device's battery in a dry area free from easily flammable or explosive substances, with a temperature between +5 °C and +40 °C.
• Ensure that the charging port, charger, and socket are dry before charging. Do not charge the device if the charging port, charger, or socket is wet.
• Charge the device's battery on a flat, stable surface. Do not let the device or charging cable hang over the edge of high surfaces during charging. Do not place the device or charging cable in walkways where they could pose a tripping hazard.
• Use only a compatible CE-marked charger with a USB output voltage of 5 V and output current of 500 mA. No charger is included in the package.
• The power delivered by the charger must be between min 0.2 Watts required by the radio equipment, and max 3.3 Watts in order to achieve the maximum charging speed.
• Plug the charger into a socket that is easily accessible.
• Do not leave the device charging unattended.
• If the device emits unusual smells or light during charging, stop charging immediately and contact service.
• Grip the plug when disconnecting the charging cable from the device or power source. Do not pull the charging cable.
• Disconnect the charging cable from the device and power source once the battery is fully charged.
• Never puncture the device's battery.

Visual description for page 5: Two icons are shown. The first is a plug symbol with a red cross through it, indicating not to use a wet plug. The second is a box with "0.2-3.3 W" inside, indicating the required power range for the charger.

Technical Information

Parts

The keyboard has the following key parts:

• 1. Charging port: Located on the keyboard for connecting the charging cable.
• 2. Connection selector: A switch on the keyboard to choose between 2.4GHz wireless, OFF (wired), or Bluetooth modes.
• 3. Indicator lights: Located near the ESC key, providing status information.

Visual description of parts: A diagram shows the top-left area of the keyboard. Number 1 points to the USB-C charging port. Number 2 points to the connection selector switch labeled "2.4G", "OFF", "B". Number 3 points to a cluster of four indicator lights labeled "N", "C", "W", "G" from top to bottom.

Indicator Lights

The keyboard features four indicator lights located to the right of the ESC key:

• 1. (N): The highest indicator light is on when Caps Lock is active.
• 2. (C): The second-highest indicator light is blue and indicates an active wireless connection.
• 3. (W): The second-lowest indicator light flashes yellow when the battery is low.
• 4. (G): The lowest indicator light is white and indicates that the keyboard is charging.

Charging

Fully charge the keyboard battery before the first use. Continue to charge the battery even when it is low. The battery is considered low when the indicator light next to the ESC key flashes yellow.

To charge the battery:

1. Plug the USB-C connector into the keyboard's charging port.
2. Plug the USB-A connector into a USB port on your computer or a power adapter.
3. If using a power adapter, plug it into an accessible electrical outlet.

Note: The package does not include a power adapter; it must be purchased separately.

Confirm charging status:

• The indicator light turns white while the battery is charging.
• The indicator light turns off when the battery is fully charged.

When the battery is full:

1. Disconnect the USB-C connector from the keyboard.
2. Disconnect the USB-A connector from the computer or power adapter.
3. If using a power adapter, unplug it after use.

How to Use

The keyboard can be used wirelessly via Bluetooth or a 2.4 GHz connection. Alternatively, it can be used in wired mode by connecting it to your computer with a USB cable.

Note: For a 2.4 GHz wireless connection, plug the included USB receiver into a USB-A port on your computer. The receiver can be found under the lid located below the keyboard.

Wireless Connection

Connection Selector

The keyboard features a connection selector switch at the top with three settings: G (2.4 GHz), OFF (Wired), and B (Bluetooth).

2.4 GHz Connection:

1. Plug the receiver into a USB port on your computer.
2. Move the connection selector to the left (setting G).
3. Press the Fn key and the Q key simultaneously. The blue connection light will begin to flash.
4. The blue connection light turns off once the connection is successfully completed.

Bluetooth Connection

The keyboard can store up to three different Bluetooth devices. To connect to a device, use the following key combinations:

• Fn + E: Connection to device 1.
• Fn + R: Connection to device 2.
• Fn + T: Connection to device 3.

1. Move the connection selector to the right (setting B).
2. For the first connection to a new device, press and hold the desired key combination (e.g., Fn + E). The blue connection light will start flashing.
3. On your device, select "Serenity KB" from its Bluetooth pairing list. The blue connection light will turn off when the connection is completed.
4. The keyboard saves the device to the selected key combination. You can reconnect to this device by pressing the same key combination again.

If a Bluetooth connection is not established within two minutes, pairing mode will deactivate. Press any key to re-enable pairing mode.

Wired Connection

1. Move the connection selector to the middle (setting OFF).
2. Connect the USB cable to the keyboard's USB port and your computer's USB port.

In wired mode, the keyboard charges automatically. The white indicator light remains on during charging and turns off when the battery is fully charged.

Light Settings

You can adjust the lighting for the W, A, S, and D keys, as well as the arrow keys.

To adjust light settings:

1. Press the Fn key and the apostrophe key (located next to the Enter key) simultaneously to begin adjustment.
2. Adjust the light settings for a specific key by pressing it. Press the key repeatedly to cycle through the seven available color options.
3. Press the Fn key and the apostrophe key simultaneously again to save your changes.
4. To clear all settings, press the Fn key and the apostrophe key twice in rapid succession.

Key Combinations

The keyboard offers various key combinations to customize lighting or control computer functions. Refer to the table below for details.

Verkkokauppa.com Oyj guarantees that the radio device Blackstorm Serenity TKL complies with Directive 2014/53/EU.

Maintenance, Storage and Recycling

• Clean the device with a soft dry cloth. Do not use other cleaning tools, detergents, or sharp objects.
• Store the device only in dry indoor environments at room temperature.
• Store the device in its original package if it is not used regularly.
• Safe disposal of the product: The device or its accessories must not be disposed of with regular household waste at the end of their life cycle. Take the device for recycling to the retailer or a local waste disposal facility responsible for recycling. For more information, contact your retailer or waste management company.

Contact information:

Verkkokauppa.com Oyj
Tyynenmerenkatu 11, 00220 Helsinki, Finland
https://asiakaspalvelu.verkkokauppa.com