MOTORISED ROUND BENDING MACHINE ASM 1550X3.5 MM
Article Number: 83117 | EAN Code: 9004853831171
Product Highlights
A photograph shows the ELMAG ASM 1550x3.5 MM Motorised Round Bending Machine, featuring its robust frame, rollers, and a connected control panel with a foot pedal.
Standard Features
- Robust machine body and cast iron roller frames
- High quality steel rollers with very high tensile strength
- Taper bending device for tapered workpieces
- Wire insert grooves on lower and rear roller
- Operating instructions [CE marking]
Special Accessories
- Induction-hardened steel rollers
- Control panel with rear roller control and digital display
Specifications
| Working length | 1550 mm |
| Sheet thickness prebending max. | 3 mm |
| Sheet thickness bending max. | 3.5 mm |
| Upper roll diameter | 110 mm |
| Bending diameter min. | 150 mm |
| Motor power | 2200 W |
| Voltage | 400/50 V/Hz |
| Operator column forward / return flow | Yes |
| Quality steel rollers | 3 Num. |
| Drive rollers (+) | 2 Num. |
| Cone bender | Yes |
| Wire core grooves lower roller / back roller | Yes |
| Length | 2320 mm |
| Width | 850 mm |
| Height | 1150 mm |
| Weight | 1250 kg |
ELMAG® - Start-up Service
An image depicts a technician performing a start-up service on machinery, symbolizing competent execution and quality assurance.
Competent execution guaranteed
- Depreservation, degreasing and de-securing
- Assembly until ready for use
- Oil filling of gearboxes, oil baths and central lubrication systems
- Testing of electrics, safety components and devices
- Test run on all shift and power levels
- 30-minute test run at the highest power level
- Checking and, if necessary, adjustment of machine tolerances, e.g. V-belt tension and spindle concentricity
- Testing of all machine functions
For lathes, in addition:
- Lathe chuck reassembly with marking of minimum tolerance
- Measurement of the spindle nose to tolerance < 0.01 mm
- Measurement of the lathe chuck
- Setting the tailstock parallelism
For MIG/MAG/MMA/WIG welding, plasma cutting & induction heating equipment (depending on the type of equipment):
- Assembly of the unit, chassis assembly
- Intermediate hose assembly
- Mains plug assembly and gas hose assembly
- Connection preparation for gas or compressed air
- Control cable plug Assembly on hose assembly
- Installation & activation of water cooling unit for modular systems
- Filling with cooling liquid for liquid-cooled units
- Short test run or test welding
Document Date: 04.04.2024
