FIXED Matic XL Automatic Wireless Charging Car Holder
User Manual
Product Description
- 1. Sensing field for wireless charging
- 2. Touch sensor
- 3. Lever for attaching suction cup to dashboard/windshield
- 4. Suction cup
- 5. LED indication
- 6. USB-C input connector
- 7. Capacitor
Installation Procedure
- Unscrew the thread on the bracket and attach the bracket to the leg, then use the nut to fix the head in the position of your choice.
- Remove the protective film from the suction cup.
- Stick the suction cup to the dashboard or windscreen of your car and press the lever downwards. This will apply even more pressure to the suction cup.
- Plug the USB cable into the charging connector. Plug the USB cable into the car charger. A car charger with Fast Charge support (9V/2A output) is required to support Fast Charge.
- LED indication indicates the holder is plugged into the power supply.
- Insert your phone into the holder. The holder automatically closes and secures the phone in the holder and starts charging the phone at the same time. After inserting the phone, the LED indication turns off.
- To remove the phone from the holder, gently touch the sensor located on the back of the holder.
- The holder is equipped with a capacitor that, even after removing the USB cable from the holder and thus disconnecting it from the power supply, can provide the holder with enough power to open and the phone can be conveniently removed from the holder. However, the condition is that the holder must be energized long enough to sufficiently charge the capacitor of the holder.
Technical Specifications
| Parameter | Value |
|---|---|
| Input | 5.0V/2A; 9.0V/2A; 12V/2A (MAX) |
| Output | DC 5V/1A; 9V/1.1A |
| Power | 5W/7.5W/10W/15W |
| Weight | 160 g |
| Dimensions | 100x67x54 mm |
| Distance for wireless charging | <8mm |
| Frequency | 110-205 kHz |
| Material | ABS+PC, tempered glass |
| Efficiency | >73% |
| Battery capacity | 30mAh |
Notes
- When charging the phone in the holder, warm air must not flow out of the ventilation outlet.
- When heating the interior of the vehicle, close the air supply to the ventilation outlet with the holder in place.
- The product is warranted according to the legal regulations in the countries where it is sold.
- In case of service problems, contact the dealer from whom you purchased the equipment.
- FIXED assumes no responsibility for damages caused by improper use of the product.
Product Care and Maintenance
Use a soft cloth to clean the holder body.
Safety Precautions
- Do not expose the device to rain or snow or immerse it in water.
- Do not leave the holder in the car in the sun.
- Do not expose the device directly to sunlight or leave it near heat sources.
- Do not use the mount if it has been severely impacted, dropped, or damaged in any way.
- Do not disassemble the device; there is a risk of electric shock and/or burns.
- Do not modify the power cord.
- Keep the holder out of the reach of children.
- Unauthorized opening or modification of parts of the product will result in voiding the warranty.
- Product storage temperature: 0 to 35 °C
- Product operating temperature: 0 to 40 °C
- Keep the manual for later use.
Compliance
This product is CE marked in accordance with the provisions of EMC Directive 2014/30/EU and RoHS Directive 2011/65/EU. FIXED.zone a.s. hereby declares that this product complies with the essential requirements and other relevant provisions of EMC Directives 2014/30/EU and 2011/65/EU.
FIXED.zone a.s.
Kubatova 6
České Budějovice 37004
Czech Republic
