Your baby will sleep tight and safe with the Team Monkey Nursery Collection. The 8 Piece Nursery Set was designed to help you create a beautiful nursery, while offering a safer solution for crib bedding. Please read the Safe & Sound Sleep Guide for more information on keeping your little one sleeping safe.
Tools Required: 2 Nails and Hammer / 2 Screws and Phillips or Flathead Screwdriver (Not Included)
⚠ WARNING: Failure to follow these warnings and the instructions could result in death or serious injury.
CRIB SNUGWRAP™:
To prevent entanglement or strangulation, position ties to outside of crib and be sure they are secured. Remove Crib SnugWrap™ when child can sit up unaided or can pull to a standing position. This product is intended for, and is designed to fit, a standard infant's crib. If the crib is any size other than standard, do not use. Please take the time to install correctly. When fastening this product to the crib, ALL TIES SHOULD BE SECURELY TIED TO THE OUTSIDE OF THE CRIB SLATS OR POSTS.
Please check periodically to see that ALL ties remain firmly tied. Failure to install properly and keep ties securely tied to the outside of the crib could cause injury to infants.
SOLID SIDE CRIBS:
Do not use Crib SnugWrap™ panel that cannot be properly secured to crib. Tuck panel underneath mattress.
Remove adult bedding and stuffed toys from crib.
DO NOT USE Crib SnugWrap™ if all ties cannot be securely attached to the crib.
DO NOT add makeshift ties.
COMFORTER:
To prevent suffocation, do not put comforter in a crib or near an area where an infant may sleep. Comforters are a decorative item only and are not intended for an infant's use. Infant should never be placed to sleep on top of quilts, comforters or other soft bedding.
CRIB SHEET:
Prevent possible strangulation or entanglement. Never use crib sheet unless it fits securely on crib mattress.
SWADDLEME®:
Baby should be lightly clothed for sleep at room temperature comfortable for a lightly clothed adult (67°F to 72°F). Baby should not feel hot to the touch. Do not use SwaddleMe with an undersized infant around whom the wings cannot be snug. Do not allow fabric to cover infant's mouth or nose. Discontinue use if:
- The fastenings are damaged.
- Baby is able to roll from back to stomach position while swaddled.
- Baby is able to break free of SwaddleMe.
Swaddling Simplified!
- Align baby's shoulders with top of open wrap. Tuck legs inside leg pocket then open tab at top of leg pocket. (Visual: Baby lying on open swaddle wrap, arms and legs extended.)
- Wrap left wing over baby's torso and tuck under baby's opposite arm. Secure tab to top of leg pocket. (Visual: Baby with left wing wrapped across torso, right arm free.)
- Place right wing over left and secure opened tabs to fabric patch on left wing. Wings should be snug over baby's chest. Always place babies on their backs to sleep. (Visual: Baby fully swaddled, arms tucked in.)
How to properly install Crib SnugWrap™ on a standard crib with fully open sides:
- STEP 1: Remove crib mattress from crib. (Visual: Crib with mattress being lifted out.)
- STEP 2: Place Crib SnugWrap™ in crib with platform resting on mattress base.* (Visual: Crib SnugWrap™ panel being lowered into crib.)
- STEP 3: Proceed to tie corners of each side of Crib SnugWrap™ panels to corner posts, ensuring that all ties are facing out. (Visual: Hand tying a bow on a crib post.)
- STEP 4: Tie rest of Crib SnugWrap™ ties to crib slats, ensuring that all ties are facing out. (Visual: Top-down view of crib with ties secured to slats.)
- STEP 5: Insert crib mattress into place. (Visual: Mattress being lowered into crib.)
- STEP 6: Ensure that all ties are securely fastened. If ties have loosened, re-tie. (Visual: Hand tightening a tie.)
*Warning label on base must face up.
How to properly install Crib SnugWrap™ on a crib with solid sides and open sides:
- STEP 1: Remove crib mattress from crib. (Visual: Crib with mattress being lifted out.)
- STEP 2: Place Crib SnugWrap™ in crib with platform resting on mattress base.* (Visual: Crib SnugWrap™ panel being lowered into crib.)
- STEP 3: Proceed to tie corners of each side of Crib SnugWrap™ panels to corner posts, ensuring that all ties are facing out. (Visual: Hand tying a bow on a crib post.)
- STEP 4: Crib SnugWrap™ panels that face a solid side should be laid flat on platform to be tucked under mattress. (Visual: Top-down view of crib with solid side panel tucked.)
- STEP 5: Tie rest of Crib SnugWrap™ ties to crib slats, ensuring that all ties are facing out. (Visual: Top-down view of crib with ties secured to slats.)
- STEP 6: Insert crib mattress into place. Make sure that the unused panels are properly tucked under mattress. (Visual: Mattress being lowered into crib.)
- STEP 7: Ensure that all ties are securely fastened. If ties have loosened, re-tie. (Visual: Hand tightening a tie.)
*Warning label on base must face up.
How to properly install Comforter Clips:
(Mounting Hardware Not Included)
- STEP 1: Determine where to install the comforter clips so that they can hold the comforter up at each upper corner. IMPORTANT: When determining the location, mount on a wall clearly out of a standing baby's reach. (Visual: Corner of a room with two plus signs indicating clip placement.)
- STEP 2: Place your nails or screw (not included) into the wall at a 45 degree angle. IMPORTANT: If nail or screw is not at a 45 degree angle, the clip may slip off the nail/screw. (Visual: Hammer hitting a nail into a wall at an angle, and screwdriver turning a screw into a wall at an angle.)
- STEP 3: Hang the comforter from the clips by opening the clips and sliding the comforter in between the clip mechanism. Close the clips around the comforter to finish. (Visual: Two clips hanging from the wall.)
Care Instructions:
CRIB SNUGWRAP™:
Machine wash cold, gentle cycle. Use only non-chlorine bleach when needed. Tumble dry low, remove promptly. Do not iron.
COMFORTER:
Machine wash cold, gentle cycle. Use only non-chlorine bleach when needed. Tumble dry low, remove promptly. Do not iron.
CRIB SHEET:
Wash before first use. Machine wash cold with like colors, gentle cycle. Use non-chlorine bleach only if needed. Tumble dry, low heat. Iron if needed.
CRIB SKIRT:
Machine wash cold with like colors, gentle cycle. Use non-chlorine bleach only if needed. Tumble dry low. Cool iron. Do not iron platform.
SWADDLEME®:
Wash before first use. Close the three tabs before washing. Machine wash cold, gentle cycle with like colors. Use non-chlorine bleach only if needed. Tumble dry, low heat.
VALANCE:
Machine wash cold with like colors, gentle cycle. Use non-chlorine bleach only if needed. Tumble dry low. Iron if needed.
