First Alert ReadyGuard Quick Start Guide

Introduction

This guide provides essential steps for a swift and straightforward installation of the ReadyGuard security system, utilizing its built-in default settings. For comprehensive details and important considerations, please consult the full ReadyGuard Installation Instructions.

Installation Overview

The following steps are designed for installations using one of the system's pre-defined default tables. For programming data and Powerline Carrier Devices not covered in the default tables, refer to the detailed Installation Instructions.

Key Installation Steps

1. Preparation: Separate the front assembly from the back plate and mount the back plate. Ensure the ribbon cable is disconnected only from the front assembly board.
2. Wiring: Connect the incoming phone line, handset phone lines, optional piezo sounder or bell, Powerline Carrier Devices, and the AC transformer to the appropriate terminals.
3. Power Up: Reconnect the ribbon cable, snap the front assembly to the back plate, and plug the transformer into a 24-hour, 110VAC unswitched outlet. Install batteries as required.
4. Default Programming: Enter programming mode using the installer code + 800, then select a default table using *97.
5. Variable Data Programming: Program essential fields such as RF House ID, phone numbers, and account numbers using the specified codes.
6. Transmitter Enrollment: Enroll transmitter serial numbers by entering programming mode and following the prompts for each zone.
7. Keypad Configuration: Set the RF House ID on wireless keypads to match the system's programmed ID.
8. Clock Setup: Enter time/date setting mode using the installer code + 63 to set the system's real-time clock.
9. System Testing: Test the system's functionality by entering installer code + 5.
10. User Codes: Assign user codes by following the procedures outlined in the User Guide.
11. Downloader Session: Initiate a site-initiated downloader session to load the central station ID.

Keypad Functions

The ReadyGuard system offers various keypad functions for security and system management:

• Security Functions: Arm in STAY or AWAY modes, disarm the system, and bypass zones.
• Message Center: Record, stop, and play back messages.
• Volume Control: Adjust message playback and system announcement volume.
• Other Functions: Set time and date, activate/deactivate devices, add/delete user codes, and enter test mode.

For detailed information on specific functions and limitations, refer to the complete Installation Instructions and Warranty Information.