Hama Universal Notebook Power Supply

Introduction

This document provides operating instructions, safety information, and technical data for the Hama Universal Notebook Power Supply.

Explanation of Warning Symbols and Notes

• ⚡ Risk of Electric Shock: Indicates a risk of electric shock from touching product parts carrying hazardous voltage.
• ⚠️ Warning: Used to indicate safety instructions or to draw attention to specific hazards and risks.
• ℹ️ Note: Used to indicate additional information or important notes.

Package Contents

• Universal notebook power supply unit
• 7 notebook connectors
• Power cord
• Operating instructions

Safety Instructions

• Use the product only for its intended purpose.
• Do not use the product near heaters, heat sources, or in direct sunlight.
• Ensure adequate heat dissipation and ventilation.
• Use only under moderate climatic conditions.
• Do not use in areas where electronic products are not permitted.
• Avoid damp environments and splashing water.
• Do not short-circuit the battery of an opened terminal device (risk of explosion).
• Protect from dirt, moisture, and overheating; use only in dry environments.
• Do not drop the product or expose it to major shocks.
• Do not operate outside specified power limits.
• Always pull the plug, never the cable, when disconnecting.
• Ensure cables do not pose a tripping hazard or block emergency exits.
• Do not bend or crush the cable.
• Keep out of reach of children.
• Do not modify the device; this voids the warranty.
• Keep packaging material away from children (suffocation risk).
• Dispose of packaging material according to local regulations.
• Do not open or operate if damaged.
• Do not use if the AC adapter, adapter cable, or power cable is damaged.
• Do not attempt self-service or repair; leave to qualified experts.

Start-up and Operation

Mains voltage: 100 – 240 V

The power supply unit is suitable for mains voltages of 100-240V and can be used worldwide. A country-specific adapter may be necessary.

• Ensure your notebook requires a supply voltage of 15V/19V (+/- 1 Volt). This information can be found on the original power supply unit or in your terminal device's operating manual.
• Set the voltage selector switch to the voltage required by your terminal device.
• ⚠️ Warning: Do not use if you cannot definitively determine your terminal device's supply voltage.
• Do not change the voltage during operation.
• Ensure the notebook's total power consumption does not exceed the power supply unit's rated output of 45 W. Failure to comply may cause damage.

Connecting the Notebook Connector:

• Do not use force to connect the notebook connector.
• Missing or lost connectors can be requested via www.hama.com/adapter-service.
• Select the appropriate connector based on the original power supply unit's connector.
• Without connecting to the power supply, check mechanical compatibility between the notebook connector and the terminal device's socket.
• The connector should slide easily into the socket but without excessive play.

Connecting to Power:

• Operate only from an approved, accessible socket near the product.
• Disconnect the product using the On/Off switch, or unplug the power cord if no switch is available.
• If using a multi-socket power strip, ensure total power consumption does not exceed its rating.
• Connect the appropriate notebook connector to the DC connection cable.
• Connect the power cord to the power supply unit and your terminal device.
• Connect the mains plug to a properly installed socket.
• The terminal device can now be used and switched on/charged.

ℹ️ Note: Disconnect the product from the mains after use.

Care and Maintenance

ℹ️ Note: Disconnect the product from the mains before cleaning.

• Clean with a slightly damp, lint-free cloth. Do not use aggressive cleaning agents.
• Ensure no water enters the product.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability or warranty for damage resulting from improper installation, mounting, improper use, or failure to observe operating instructions and safety notes.

Technical Data

Ambient temperature: 0° – 40° C

Specifications in accordance with Regulation (EU) 2019/1782