Hama Universal Power Supply Unit 12W

Introduction

Thank you for choosing this Hama product! Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference.

1. Explanation of Warning Symbols and Notes

Risk of electric shock: This symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.

Warning: This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note: This symbol is used to indicate additional information or important notes.

2. Package Contents

• Universal switching power supply unit
• 2 USB adapters: micro-USB plug / USB Type-A socket
• 5 DC plugs: 1.35x3.5 / 1.7x4.0 / 1.5x5.5 / 2.1x5.0 / 2.5x5.5
• Adjusting key
• These operating instructions

3. Safety Instructions

• Protect the product from dirt, moisture, and overheating; use only in dry rooms.
• Do not drop the product or expose it to major shocks.
• Do not operate the product outside the specified power limits.
• Do not modify the device; this voids the warranty.
• Do not continue to operate the product if visibly damaged.
• Use the product only for its intended purpose.
• Keep out of reach of children, like all electrical products.
• Do not use near heaters, heat sources, or in direct sunlight.
• Route cables to prevent tripping hazards.
• Do not bend or crush the cable.
• Always pull the plug, not the cable, when disconnecting.
• If plug contact pins are damaged, discard the power supply plug.
• Dispose of packaging material according to local regulations.
• The product is intended for indoor use only.
• Use only under moderate climatic conditions.
• Do not use in areas where electronic products are not permitted.
• Do not use in damp environments and avoid splashing water.
• Do not open or continue to operate if damaged.
• Do not use if the AC adapter, adapter cable, or mains cable is damaged.
• Do not attempt self-service or repair; leave service to qualified experts.

4. Operation

Note - Mains Voltage 100-240 V

The charger is suitable for mains voltages of 100-240 V and can be used worldwide. A country-specific adapter may be necessary.

Warning - Connecting Devices

• Before connecting a device, check if it can be adequately supplied with the charger's current capacity.
• Check compatibility of the device with the universal power supply unit's pin assignment. Consult the dealer or manufacturer's support if necessary.
• Note the instructions in your device's operating manual.

Diagram Description: The diagrams illustrate connection types and polarity. Figure 2 shows reversible polarity symbols (+/- and -/+). Figure 3 shows a Micro USB plug, a USB-A socket, and the USB symbol indicating 5V.

General Connection Procedure:

• Ensure the device is compatible with the power supply's pin assignment.
• Use only approved sockets located near and accessible to the product.
• Disconnect the product from the mains using the on/off switch or by unplugging the power cord.
• If using multi-sockets, ensure connected devices do not exceed the total power rating.
• Disconnect the product if not used for a prolonged period.
• If device manuals provide no specific instructions, follow these steps:
• Check mechanical compatibility between the universal power supply adapter and the device's connection socket without connecting to the mains.
• Observe the polarity of the device's connection socket and insert the adapter accordingly (see Figure 2).
• Use the supplied adjusting key to set the voltage selector switch to the voltage required by your device.
• Plug the universal power supply unit into the designated socket.
• The terminal device can now be used and switched on.

5. Care and Maintenance

• Use only soft, dry towels for cleaning.

Note: Disconnect the device from the mains before cleaning and during prolonged periods of non-use.

6. Technical Data

7. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product, or failure to observe the operating instructions and/or safety notes.