Panorama 3 Wall Bracket Installation Instructions
Parts Included
- Component a: Wall Bracket (1x)
- Component b: Screws (2x)
- Component c: Fixing Tool (1x)
Installation Steps
Step 1: Position Wall Bracket
Place the wall bracket (a) against the wall at the desired height. Ensure it is level.
Step 2: Mark Drilling Points
Using the bracket as a template, mark the positions for drilling on the wall.
Step 3: Drill Holes
Drill pilot holes at the marked positions. The size of the drill bit will depend on your wall type and the fixings you use (not included).
Step 4: Insert Wall Fixings
Insert appropriate wall fixings (not included) into the drilled holes.
Step 5: Attach Bracket to Soundbar
Turn the soundbar over. Locate the mounting points on the rear of the soundbar. Align the wall bracket (a) with these mounting points. Secure the bracket (a) to the soundbar using screws (b). Important: Refer to the visual guide for correct screw insertion (indicated by a checkmark ✔️, not a cross ❌).
Step 6: Mount Soundbar to Wall (Two Person Lift)
This step requires two people. Lift the soundbar with the attached bracket. Align the soundbar's bracket with the wall-mounted bracket and slide the soundbar onto it until fully engaged.
Step 7: Secure Soundbar
Use the fixing tool (c) to secure the soundbar to the wall bracket. Ensure the locking mechanism is engaged. Important: The gap between the soundbar and the wall must be less than 50mm (<50mm) for the locking mechanism to function correctly. The locking mechanism is engaged by turning screw (b) with tool (c) to secure the soundbar.
Important Information
As wall materials vary, screws for fixing to the wall are not included. If you have any doubt over fixing choice or your ability to attach the bracket securely, you should engage specialist help. Bowers & Wilkins will not be held responsible for any damage or injury caused by insecure attachment of the bracket.
