HAVSEN Kitchen Sink Installation

Before You Begin

The HAVSEN kitchen sink is made of fine fire clay and complies with requirements for durability and cleanability. Ensure you have all the necessary tools and materials before starting the installation.

Tools Required:

• Screwdriver
• Pencil
• Measuring tape
• Jigsaw
• Drill with Ø 35 mm (1 3/8") drill bit
• Drill with 10 mm (3/8") drill bit
• File
• Silicone sealant (not included)

Note: Silicone sealant is not included. To prevent water from penetrating the countertop in case of leakage, the cut edges must be sealed with silicone.

Installation Steps

Step 1: Prepare the Countertop

Place the sink upside down on the countertop to trace its outline. Ensure the sink is positioned correctly.

Diagram shows a person tracing the outline of the sink onto a countertop.

Step 2: Mark the Cutout

Mark the cutting line for the countertop based on the sink's dimensions. Typically, this involves marking the inner edge of the sink's flange.

Diagram shows marking the countertop for the cutout.

Step 3: Cut the Countertop Opening

Using a jigsaw, carefully cut along the marked line to create the opening for the sink. Ensure the cut is precise.

Diagram shows a jigsaw cutting the countertop opening.

Step 4: Smooth the Edges

Use a file to smooth the cut edges of the countertop opening. This ensures a clean fit for the sink and helps with sealing.

Diagram shows filing the edges of the countertop opening.

Step 5: Drill Holes for Fixtures

Drill pilot holes for any fixtures or accessories that will be mounted on the countertop, such as a faucet or soap dispenser. Use the specified drill bit sizes (e.g., Ø 35 mm for a faucet hole).

Diagram shows drilling holes in the countertop for fixtures.

Step 6: Prepare the Sink

Ensure the underside of the sink and the countertop edge are clean and dry. Apply a continuous bead of silicone sealant around the underside of the sink's rim.

Diagram shows applying silicone sealant to the rim of the sink.

Step 7: Install the Sink

Carefully lower the sink into the countertop opening. Press down firmly to ensure the silicone sealant creates a watertight seal.

Diagram shows lowering the sink into the countertop opening.

Step 8: Secure the Sink

From underneath the countertop, attach the provided mounting clips or brackets to secure the sink in place. Follow the specific instructions for the clips.

Diagram shows securing the sink from underneath with mounting clips.

Step 9: Connect Plumbing

Connect the drain assembly and any plumbing fixtures (faucet, water supply lines) according to standard plumbing practices. Refer to the specific instructions for your faucet and drain components.

Diagram shows connecting plumbing to the sink drain.

Step 10: Final Check

Check all connections for leaks. Turn on the water supply and run water into the sink, checking for any drips or leaks at the faucet, drain, and around the sink rim.

Diagram shows checking for leaks after installation.

Care and Maintenance

Clean the sink regularly with mild soap and water. Avoid using abrasive cleaners or scouring pads that could scratch the surface.