iRobot Roomba 880 Cleaning Head Replacement

Introduction

This guide will show you how to replace the whole Cleaning Head in the Roomba 880, which houses the Debris Extractors.

Tools Required:

• Phillips #1 Screwdriver
• Flathead Screwdriver

Step 1: Prepare the Roomba

Begin by flipping the Roomba over so the wheel-side is facing up.

Using a Phillips #1 screwdriver, loosen the four 15 mm screws. Two of these screws are located on the battery door, and the other two are on the bottom panel.

Remove the battery door by pulling it straight up from the two indents located above the screws.

Step 2: Remove the Side Brush

Using a flathead screwdriver, loosen the screw on the top of the side brush.

Remove the side brush.

[Information] The bottom panel cannot be removed without first removing the side brush, so ensure this step is completed.

Step 3: Remove the Bottom Panel

Pull up on the bottom panel to remove it from the Roomba.

Step 4: Remove the Dust Bin

Reach underneath the dust bin, press the bin removal button, and pull the dust bin out.

[Information] The bin removal button is located on the top edge of the bin.

Step 5: Unscrew the Cleaning Head

Using a Phillips #1 screwdriver, remove the four 10 mm screws securing the cleaning head assembly.

Step 6: Remove the Cleaning Head

Remove the cleaning head by grabbing the two protruding tabs and pulling straight up.

Reassembly

To reassemble your device, follow these instructions in reverse order.