Hama USB Hub - Operating Instructions

1. Package Contents

• USB-A Hub
• USB-C Adapter
• USB-C Power supply unit
• These operating instructions

2. Safety Notes

General Safety

• Do not operate the product outside the power limits given in the specifications.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep this product, as all electrical products, out of the reach of children!
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
• The product is intended for indoor use only.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
• Do not use the product in moist environments and avoid splashes.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Dispose of packaging material immediately according to locally applicable regulations.

Risk of Electric Shock

• Do not open the device or continue to operate it if it becomes damaged.
• Do not use the product if the AC adapter, adapter cable or power cable is damaged.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

Power Consumption

• Ensure that the total power consumption of all connected terminal devices does not exceed 2.4 A.
• Bus-powered operation (without power supply unit): USB 2.0 max. 500 mA / USB 3.0 max. 900 mA / USB-C max. 3000 mA

Consult the operating instructions or the technical specifications of the connected devices and your computer. It is essential that you observe these specifications and the safety instructions regarding the power supply of your devices.

3. Startup and Operation

Warning

• Only operate the product from a socket that has been approved for the device. The socket must be installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/Off switch – if this is not available, unplug the power cord from the socket.
• If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the power strip’s maximum throughput rating.
• If you will not be using the product for a prolonged period, disconnect it from mains power.

Note

• Run USB receivers (radio / 2.4 GHz wireless) if possible directly on the computer / notebook.
• Switch on your computer and boot the system.
• First connect the enclosed power supply unit to a socket and then to the hub. (USB-C power supply unit can alternatively also be used to charge a smartphone / tablet)
• Connect the product to a free USB port on your computer.
• You do not have to install drivers; the computer will automatically recognise the product.
• If necessary, follow the instructions for your operating system.
• In order to use your devices, plug them into the product one after the other.

4. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

5. Technical Data

Note: If there is interference or the product no longer responds, unplug the product, wait a few seconds and then plug it in again.