Hama USB-C Docking Station

Package Contents

• USB-C Docking Station
• These operating instructions

Safety Notes

• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not operate the product outside the power limits given in the specifications.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep this product, as all electrical products, out of the reach of children!
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
• The product is intended for indoor use only.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
• Do not use the product in moist environments and avoid splashes.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Dispose of packaging material immediately according to locally applicable regulations.

Important Notes

• To be able to use the charging function, the device must support Power Delivery (PD) or Thunderbolt-3/4.
• To use the HDMI™ or DisplayPort function, the device must support DisplayPort Alternate Mode or Thunderbolt 3/4.
• Support of MST (Multi-Stream Transport) is a requirement for the use of multiple monitors displaying different contents.
• For MST, passive HDMI™ / DisplayPort cables (without chipset / signal converter) must be used.
• The MST function is dependent on the graphics card, operating system and monitor used. For more information, consult the operating instructions or contact the manufacturer.

Diagram Description

The docking station features the following ports:

• 2x HDMI™ (Max. 3840x2160@60Hz)
• 1x DisplayPort (Max. 3840x2160@60Hz)
• 1x USB-C – PD (Power Delivery, 5-20V, max 5A / 100W)
• 1x USB-C (USB 3.2 Gen1, Max. 5 Gbps)
• 1x USB-A (USB 3.2 Gen1, Max. 5 Gbps)
• 3x USB-A (USB 2.0, Max. 480 Mbps)
• 1x LAN/Ethernet (10/100/1000 Mbps)

Startup and Operation

• Switch on your computer and boot the system.
• Connect the product to a free USB port on your computer.
• You do not have to install drivers; the computer will automatically recognise the product.
• If necessary, follow the instructions for your operating system.
• In order to use your devices, plug them into the product one after the other.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical Data

Troubleshooting

If there is interference or the product no longer responds, unplug the product, wait a few seconds and then plug it in again.