Minelab Metal Detector Safety, Warranty, and Regulatory Information
This document provides essential safety advice, warranty terms, and regulatory compliance information for Minelab metal detectors. For complete product specifications and operational guidance, please refer to the full Instruction Manual available at www.minelab.com/product-manuals.
Assembly Instructions
For guidance on detector assembly, please refer to the Getting Started Guide included with your product or visit the online knowledge base at www.minelab.com/product-manuals. The Minelab website also provides information on accessories available for your detector.
Warranty Terms
For full warranty terms and conditions, please visit www.minelab.com/support/product-warranty. You can register your product warranty online at register.minelab.com.
Safety Considerations
- Keep out of reach of children; small parts are a choking hazard.
- Do not mutilate the batteries.
- Dispose of batteries as per local regulations.
- Only charge the detector and accessories according to the instructions in the manual.
- Do not dispose of the detector or accessories in a fire.
- Disconnect coil before packing/storing as luggage.
- CAUTION — Risk of explosion if battery is replaced by an incorrect type.
- CAUTION — Only charge the battery in ambient temperatures between 0°C and 40°C.
- Headphone use at HIGH volume may cause reduced awareness of surroundings and could lead to hearing damage. Use at lower volumes is advised.
- Adult supervision is required when the product is used by children.
Regulatory Information
Federal Communications Commission (FCC) Statements (as applicable)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
US Responsible Party: MINELAB AMERICAS INC, 3565 Butterfield Rd. Unit 121 Aurora, IL 60502, USA. Contact: ComplianceManager@minelab.com.au
Canada Compliance Statements (as applicable)
This product meets the applicable Innovation, Science and Economic Development Canada technical specifications.
RSS-Gen notice: This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: 1) This device may not cause interference; and 2) This device must accept any interference, including interference that may cause undesired operation of the device.
Modification
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the device.
Simplified EU & UKCA Declaration of Conformity
Hereby, Minelab Electronics Pty Ltd declares that the radio equipment type [Refer to equipment listed in Table 1] complies with Directive 2014/53/ EU and The Radio Equipment Regulations 2017 (S.I. 2017/1206). Full text of the EU & UKCA declarations of conformity are available at the following internet address: www.minelab.com/compliance.
EU Importer: MINELAB ELECTRONICS PTY LTD, 2 Second Avenue, Mawson Lakes, SA 5095, Australia
EU Auth. Representative: Minelab International Ltd., Penrose Dock, T23KW81, Ireland | minelab@minelab.ie
License / Permit
The equipment operator is responsible for investigating and obtaining any required local license or permit for metal detecting activities.
WEEE Disposal Information
The [WEEE symbol] symbol indicates that the equipment and its electrical accessories should not be disposed of as household garbage. These items should not be disposed of as unsorted municipal waste and should be taken to a certified collection point for recycling and proper disposal. Refer 2012/19/EU (Waste Electrical and Electronic Equipment).
Technical Specifications (Table 1)
| Detector | Frequency Range | Max. Transmit Power | Bluetooth Frequency | Bluetooth Power |
|---|---|---|---|---|
| VANQUISH 340/440/540 | 5 to 143 kHz | < –30 dBm | 2.4 to 2.5 GHz | 0 dBm |
| EQUINOX 600/800 | 3.7 to 143 kHz | < –30 dBm | 2.4 to 2.5 GHz | –5.9 dBm / –0.5 dBm |
| EQUINOX 700/900* | 2.5 to 143 kHz | < –30 dBm | 2.4 to 2.5 GHz | +6.3 dBm |
| X-Terra Pro/Elite | 2.5 to 143 kHz | < -30 dBm | 2.4 to 2.5 Ghz | +6.3 dBm |
| CTX 3030 | 1.3 to 141 kHz | < –30 dBm | 2.4 to 2.5 GHz | 14 dBm |
| GO-FIND Series | 7.4 to 8.2 kHz | < –30 dBm | 2.4 to 2.5 GHz | 8.9 dBm |
| Excalibur II | 1.3 to 141 kHz | < –30 dBm | — | — |
| Manticore* | 2.5 to 143 kHz | < –30 dBm | 2.4 to 2.5 GHz | +6.3 dBm |
| PRO-FIND Series | 11 to 13 kHz | < –30 dBm | — | — |
| Gold Monster 1000 | 43 to 46.8 kHz | < –30 dBm | — | — |
| SDC 2300 | 3.5 to 146 kHz | < –30 dBm | — | — |
| GPZ 7000 | 1.18 to 147 kHz | < –30 dBm | 2.4 to 2.5 GHz | 0 dBm |
| GPX 5000 | 1.1 to 145 kHz | < –30 dBm | — | — |
| GPX 6000 | 1.18 kHz to 147 kHz | < –30 dBm | 2.4 to 2.5 GHz | +8 dBm |
| ML 80 | — | — | 2.4- to 2.485 GHz | +5 dBm |
| ML 100 | — | — | 2.4 to 2.5 GHz | +3 dBm |
| ML 85 | — | — | 2.4 to 2.5 GHz | +0 dBm |
| ML 105 | — | — | 2.4 to 2.5 GHz | +3 dBm |
| WM 09 | — | — | 2.4 to 2.5 GHz | +3 dBm |
* indicates use of e-labelling; follow instructions in Manual/carton to access.
Certification Scheme IDs (Table 2)
| Detector | FCC ID | Anatel | Japan MIC | KC | ISED | BIS/ETA |
|---|---|---|---|---|---|---|
| VANQUISH 540 | Z4C-0041 | 03956-21-11695 | 001-A16239 | R-C-Tej-0041 | 24927-0041 | ETA-SD-20210100676 |
| VANQUISH 340/440 | — | 17411-20-11695 | — | R-R-Tej-0041A | ICES-3(B)/NMB-3(B) | R-41220116 |
| EQUINOX 600/800 | Z4C-0022 | 04023-21-11695 | 003-180034 | R-CMM-Tej EQUINOX800 | 24927-0022 | ETA-SD-20210100634/636 |
| EQUINOX 700/900* | Z4C-0054A | 21898-22-11695 | 001-A19879 | R-R-Tej-0054A | 24927-0054A | ETA-SD-20221210452/465 |
| X-Terra Pro | Z4C-0054 | 21925-22-11695 | 001-A19879 | R-R-Tej-0054 | 24927-0054 | ETA-SD-20230301955 |
| X-Terra Elite | — | — | — | R-R-Tej-0054 | 24927-0054 | R-41206482 |
| CTX 3030 | Z4C-1010 | 16616-20-11695 | — | R-R-Tej-1010 | — | ETA-SD-20210100667 |
| GO-FIND 44/66 | Z4C-2660 | 17188-20-11695 | 003-180016 | R-CMM-Tej GO-FIND66 | 24927-2660 | ETA-SD 20210100638/640 |
| GO-FIND 11/22 | — | — | — | — | ICES-3(B)/NMB-3(B) | — |
| Excalibur II | sDoC | 04139-21-11695 | — | R-R-Tej-0454 | — | — |
| Manticore* | Z4C-0049 | 21899-22-11695 | 001-A19880 | R-R-Tej-0049 | 24927-0049 | ETA-SD-20221210303 |
| PRO-FIND Series | sDoC | 00108-21-11695 | — | R-R-Tej-0018 | ICES-3(B)/ NMB-3(B) | — |
| Gold Monster 1000 | sDoC | 06876-18-11695 | — | R-R-Tej-0019 | ICES-3(B)/NMB-3(B) | R-41206482 |
| SDC 2300 | sDoC | 05531-20-11695 | — | R-R-Tej-0012 | — | R-41206482 |
| GPZ 7000 | Z4C-7000 | 05965-18-11695 | — | — | — | ETA-SD-20230201248 |
| GPX 5000 | sDoC | 04112-21-11695 | — | — | — | — |
| GPX 6000 | Z4C-0039A | 03121-21-11695 | — | R-R-Tej-0039 | 24927-0039 | ETA-SD-20230201251 |
| ML 80 | 2APN8-ML80 | — | 204-B00553 | R-R-Tej-ML80A | 24927-ML80A | ETA-SD-20230201251 |
| ML 100 | Z4C-ML100A | — | 210-201818 | R-R-Tej-ML100A | 24927-ML100A | ETS-SD-20221210937 |
| ML 85 | Z4C-ML85 | 02940-23-11695 | 210-188906 | R-R-Tej-ML85 | 24927-ML85 | ETA-SD-20221210297 |
| ML 105 | Z4C-ML105 | 21929-22-11695 | 210-201902 | R-R-Tej-ML105 | 24927-ML105 | ETA-SD-20221210923 |
| WM 09 | Z4C-0061 | 23503-23-11695 | R210-221957 | R-R-Tej-0061 | 24927-0061 | ETA-SD-20231211207 |
