TeckNet G-905-DSR Multimode Wireless Mouse

Product Overview

The TeckNet G-905-DSR is a multimode wireless mouse supporting USB receiver and Bluetooth (BT1, BT2) connections, allowing it to connect to three devices simultaneously.

Key Components:

• 1. Left Button
• 2. Scroll Wheel
• 3. Right Button
• 4. DPI Button
• 5. Charging Indicator
• 6. RGB Lighting
• 7. Forward Button
• 8. Back Button
• 9. USB-C Charging Port
• 10. Power Switch
• 11. USB Receiver
• 12. USB Channel Indicator
• 13. BT1 Indicator
• 14. BT2 Indicator
• 15. Channel Switch Button / Pairing Button

Connectivity

USB Connection:

1. Slide the Power Switch to "ON".
2. Press the Channel Switch Button to switch to USB mode (default). The USB Channel Indicator will turn off when the connection is ready.
3. If connection fails, refer to the "USB Receiver Reconnection" section.

Bluetooth (BT) Connection:

1. Slide the Power Switch to "ON".
2. To select a BT channel (BT1 or BT2), short press the Channel Switch Button. The corresponding BT indicator will flash.
3. If the BT indicator is flashing rapidly, proceed to Step 5.
4. If the BT indicator is flashing slowly or not flashing, press and hold the Channel Switch Button for 5 seconds until the indicator flashes rapidly, entering pairing state.
5. Turn on Bluetooth on your computer, search for and select "MS055 5.0" to pair.
6. The BT connection is established when the indicator light turns off.

Switching Connection Channels:

Short press the Channel Switch Button to switch between the three connected devices (USB, BT1, BT2).

Features

RGB Lighting Control:

Press the Forward Button + Scroll Wheel to cycle through lighting effects. To turn off lighting, keep pressing until it turns off.

Clear Pair Record:

1. Turn off the mouse.
2. Press and hold the scroll wheel, then turn on the mouse.
3. Wait for the indicator light of the currently connected channel to flash rapidly, then release the scroll wheel. This clears pairing records for both BT1 and BT2.

Switch DPI Levels:

Press the DPI button to cycle through DPI levels. The indicator light will flash the corresponding number of times for each level.

Low Battery Warning

• When the battery is low, RGB lighting will automatically turn off (if enabled).
• The indicator light on the bottom will flash red slowly.
• Recharge the mouse using the supplied charging cable.

Charging Indicator:

• Solid Red: Charging in Progress
• Light Off: Fully Charged

USB Receiver Reconnection

If the mouse disconnects, follow these steps:

1. Unplug the USB receiver and ensure the mouse is charged.
2. Turn on the mouse and switch to USB channel.
3. Press and hold the Left, Middle (scroll wheel), and Right buttons simultaneously for 3 seconds. The USB Channel Indicator will flash quickly.
4. Quickly plug the USB receiver back into a USB port while keeping the mouse within 30 cm of the receiver. Complete within 20 seconds.
5. Pairing is successful when the indicator light turns off.

Important Safety Instructions

1. Retain these instructions.
2. Read all instructions and caution markings before use.
3. This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless supervised.
4. Supervise children to ensure they do not play with the appliance.
5. Keep the product away from fire to avoid explosion.
6. Do not place the product near inflammable, explosive, or hazardous objects.
7. Do not operate with a damaged cord or plug.
8. Do not operate if damaged.
9. Do not disassemble the product.
10. Do not throw or shake the product.
11. Do not place in or near water, rain, excess moisture, or extreme heat.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

If this equipment causes harmful interference to radio or television reception, try to correct the interference by:

• Reorienting or relocating the receiving antenna.
• Increasing the separation between the equipment and receiver.
• Connecting the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consulting the dealer or an experienced radio/TV technician.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

The device has been evaluated to meet general RF exposure requirement and can be used in portable exposure condition without restriction.

Simplified EU Declaration of Conformity

Shenzhen Unichain Technology Co., Ltd. declares that the product type TK-MS055 is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at: https://teckneteu.com/

Specifications

• Connectivity Channels: USB Receiver/ BT1/ BT2
• Charging: 5V
• Operating Voltage: 3.7V
• Operating Current: <5.5mA (light off)

Package Contents

• Multimode Wireless Mouse x1
• USB Receiver x1
• USB-C Charging Cable x1
• User Manual x1