Manual Registration of WTW-NV4044GP5/NV4044GP6 Camera

Step 1: Open Settings

Right-click on the live screen and open the Settings menu.

Visual Description: The user is instructed to right-click on the live view screen to access a context menu, from which they should select 'Settings'.

Step 2: Change to Manual Mode

From the channel screen, left-click the 'Exchange Mode' icon and change it to 'Manual Mode'.

Visual Description: The interface shows a channel list. The user needs to locate and click the icon labeled '交換モード' (Exchange Mode) and select '手動モード' (Manual Mode) to switch the camera's connection method.

Step 3: Select Camera for Addition

When changed to manual mode, a green ➕ icon will appear on the screen. Left-click the ➕ icon for the desired channel (e.g., CH1).

Visual Description: After setting a channel to manual mode, a green '+' symbol appears next to it, indicating it's ready for manual camera addition. The example shows clicking the '+' next to CH1.

Step 4: Initiate Camera Search

The IP Camera Addition screen will appear. Left-click the 'Search' button.

Visual Description: A new window titled "IP Camera Addition" is displayed. The user is prompted to click the 'Search' button to find cameras on the network.

Step 5: Select Camera from Search Results

Left-clicking 'Search' will display cameras found on the same network in the table above. Once the IP address is displayed, left-click the IP address or other relevant information part of the camera you wish to add.

Visual Description: The "IP Camera Addition" window shows a table listing detected cameras with their IP addresses, ports, manufacturers, etc. The user selects a camera from this list by clicking on its details. Below the table are input fields for manual camera configuration.

Step 6: Configure Camera Details and Add

After selecting a camera, its information will be populated in the fields at the bottom of the screen. Configure the camera details as follows:

• Port: 80
• Protocol: Onvif
• Connect Mode: General (全般)
• Username: admin
• Password: 'admin123.' (If a password error occurs, try 'admin')

After entering all details, left-click the 'Add' button.

Visual Description: The user fills in the camera's network details: Port (80), Protocol (Onvif), Connect Mode (General), Username (admin), and Password. The example password is 'admin123.', with a fallback to 'admin'. The 'Add' button is then clicked.

Step 7: Verify Successful Addition

When the camera information is displayed for the selected channel (e.g., CH1) and the status indicator (playback mark) turns green, the addition is successful.

Visual Description: The main channel screen is shown again. For CH1, the camera's details are now listed, and a green indicator (likely a play symbol ▶️) signifies that the camera has been successfully added and is online.