BISSELL ICON TURBO CORDLESS VACUUM

This document provides the user guide for the BISSELL ICON TURBO Cordless Vacuum, Model 3175N.

What's in the Box

• Main vacuum unit
• Extension tube
• Floor nozzle
• Crevice tool
• Charging cradle
• Power adapter

Wall Mount Installation

Follow these steps to install the charging cradle on a wall:

1. Align the charging cradle with the mounting bracket.
2. Secure the bracket to the wall using screws.
3. Slide the charging cradle onto the mounted bracket.
4. Place the vacuum unit onto the charging cradle.
5. Ensure the vacuum is securely docked.
6. The vacuum unit is now mounted and ready for charging.

Charging the Vacuum

To charge the vacuum:

1. Plug the power adapter into a wall outlet.
2. Connect the power adapter to the charging port on the vacuum unit or charging cradle.
3. The charging indicator will show the charging status. A full charge typically takes 4 hours.

Operating the Vacuum

To operate the BISSELL ICON TURBO:

1. Attach the desired accessory (e.g., floor nozzle) to the extension tube or directly to the main unit.
2. Press the power button [power button] to turn the vacuum on.
3. Press the Turbo button to activate maximum suction power. The indicator lights will show the selected mode.
4. The vacuum offers different runtime levels: up to 50 minutes in standard mode, 18 minutes in Turbo mode, and 5 minutes in maximum Turbo mode.
5. Press the power button [power button] again to turn the vacuum off.

Usage Notes:

• The vacuum can be used with or without the extension tube.
• The vacuum has an operating range of approximately 5 meters.
• Ensure the battery is charged before first use.

Maintenance and Cleaning

Emptying the Dustbin

To empty the dustbin:

1. Press the release button to detach the dustbin from the main unit.
2. Open the dustbin lid and empty the contents into a trash receptacle.
3. Close the dustbin lid.
4. Reattach the dustbin to the main unit until it clicks into place.

Cleaning the Filter

The filter should be cleaned regularly for optimal performance:

1. Remove the filter assembly from the dustbin.
2. Disassemble the filter components.
3. Rinse the filter components under cold water. Do not use detergents.
4. Allow the filter components to air dry completely for at least 24 hours before reassembling and reinstalling.
5. Reassemble the filter and place it back into the dustbin.
6. Reattach the dustbin to the vacuum.

Cleaning the Brush Roll

To clean the brush roll:

1. Ensure the vacuum is turned off and unplugged.
2. Remove the floor nozzle from the extension tube.
3. Locate the brush roll cover on the floor nozzle.
4. Use a coin or screwdriver ?️ to turn the locking mechanism counter-clockwise to release the brush roll cover.
5. Remove the brush roll.
6. Remove any tangled hair, fibers, or debris from the brush roll and the nozzle housing.
7. Reinsert the brush roll, ensuring it is properly seated.
8. Replace the brush roll cover and secure the locking mechanism by turning it clockwise.