Victrola Revolution GO VSC-750SB

Quick Start Guide: Basic Operation

Function Knob - Basic Operation

POWER: Press and hold for 1-2 seconds to turn the unit ON or OFF.

VOLUME: Rotate to raise or lower volume.

Function Knob - To Cycle Through Features

VINYL: Press to enter record player function mode.

VINYL STREAM: Press to connect the unit to an external Bluetooth speaker.

BLUETOOTH: Press to pair the unit with a Bluetooth device (smartphone).

Operation Ring Color & Voice Prompt

• WHITE: POWER ON (Press and hold 1-2 seconds), POWER OFF (Press and hold 1-2 seconds). Unit returns to last used function mode on power ON.
• WHITE: VINYL PLAYING: "Vinyl" prompt.
• WHITE FLASHING: VINYL STREAM: "Vinyl Stream" prompt. Dial flashes when searching. "Connected" prompt and solid dial when connected. Internal speakers disengaged in this mode.
• BLUE FLASHING: BLUETOOTH: "Bluetooth" prompt. Dial flashes when searching. "Connected" prompt and solid dial when connected.
• VOLUME ADJUSTMENT: Rotate dial CLOCKWISE to RAISE VOLUME (dial brightens). Unit chimes at MAX volume. Rotate dial COUNTER-CLOCKWISE to LOWER VOLUME (dial brightens).

Battery Level Prompts: When disconnected from power, prompts indicate battery status: "Battery Full" (greater than 80%), "Battery Medium" (26%-79%), "Battery Low" (less than 25%), "Low Battery" (less than 10%).

Revolution GO Overview

Top View

Features include the Turntable Platter, Speaker, Function Knob, Tone Arm with Stylus, Lift Lever, Speed / Auto Stop Switches, and the 45 RPM Adaptor.

Rear View

Includes Charging LED, DC IN 9V power input, Unit Reset button, RCA Line Out Jack (R/L), and a Headphone Jack (3.5mm).

Bottom View

Contains a Portable Charging Cable Storage Area.

Record Holder Lid & Carry Handle

Record Holder Lid

To remove the lid: Remove the record from the unit, lower the lid to a 45-degree angle, apply light pressure to the bottom sides of the lid, and pull straight upward. The lid then serves as a record holder with slots for double LPs or two single LPs. Reattach by reversing the steps.

Guitar Strap Carry Handle

To attach the strap: Slide the carry strap over both side knobs, ensuring it is secure on each. Adjust the strap length as needed.

Simple Setup & Basic Operation

Getting Started

Remove the needle cover by gently pulling towards the front. Carefully plug in the unit and remove any accessories from the platter. It is recommended to operate the product only from the indicated type of power source.

Basic Operation

Use the Function Knob: Press and hold for 1-2 seconds to turn the unit ON or OFF. Cycle through modes by pressing the knob:

• VINYL: For playing vinyl records.
• VINYL STREAM: For connecting to an external Bluetooth speaker or headphone.
• BLUETOOTH: For connecting and playing music from a Bluetooth device (smartphone).

VOLUME: Rotate the knob to adjust volume.

RCA LINE OUT: Use the red and white plugs on the back to connect to an amplifier/stereo device. Reduce volume to minimum before connecting.

HEADPHONE: Use the headphone jack on the back to connect headphones/earbuds. Reduce volume to minimum before connecting.

Battery Information

Rechargeable Battery Life: Estimated playing times vary by play mode and volume level:

Battery Specification Information:

• Charge time: 4 Hours to fully charge.
• Rechargeable Li-ion Battery: TPS 18650/2S, 18wh; 7.2V 2500mA.
• Pole: Red wire + Black wire -.
• Caution: Risk of fire and burn. Do not open, crush, or heat above 60°C.
• Manufacturer: Shenzhen Topshes Technology Co., Ltd.

Charging LED: The Charging LED on the back is RED when charging and turns OFF when charging is complete.

Vinyl Playing

Vinyl Mode

Ensure the unit is ON and the Function Knob is set to Vinyl mode (dial illuminates white). Remove the needle cover. Select the correct record speed (use the 45 RPM adaptor for 45 RPM records). Release the Tone Arm from its holder and gently place it on the record using the lift lever. Adjust volume using the Function Knob. Avoid touching records by their grooves; handle by the center or edges.

Auto Stop On/Off Switch

ON: The record starts spinning when the tone arm moves over it and stops automatically at the end of playback.

OFF: The record spins automatically when the unit is in "VINYL" mode and continues spinning after playback finishes.

Needle Replacement

How to Replace the Turntable Stylus (Replacement Stylus # ATN3600L)

Removing the Stylus from the Cartridge:

1. Place fingers at the tip of the stylus and push down in "direction A". (Caution: Excessive force may damage or break the cartridge.)
2. Pull the stylus out in "direction B".

Installing the Stylus:

1. Hold the tip of the stylus and insert the other edge by pressing toward "direction C".
2. Push the stylus up toward "direction D" until it locks at the tip.

Caution: Do not remove or bend the stylus needle. Do not touch the needle to avoid injury. Turn off the unit's power before replacing the stylus. Keep out of reach of children. The stylus typically lasts about 300 hours; replace when sound quality changes. 78 RPM records may accelerate wear.

Vinyl Stream™

Connecting to External Bluetooth Speaker/Headphones

Ensure the unit is ON and the Function Knob is set to Vinyl Stream mode (dial flashes white). Turn on your external Bluetooth speaker or headphone and set it to pairing mode. Wait for the unit to find the device. A chime and "Connected" prompt will sound, and the dial will turn solid white. Use the external device to control volume. Internal speakers are disengaged. For initial pairing, place the Bluetooth device within 1 meter (3.3 ft). Maintain a connection within 10 meters (33 ft). Vinyl Stream is only compatible with vinyl playback. If pairing fails, turn off all devices and restart the process.

Bluetooth Pairing

Connecting to a Bluetooth Device (Smartphone)

Ensure the unit is ON and the Function Knob is set to Bluetooth mode (dial flashes blue). Turn on Bluetooth on your device, then search for and select "REVOLUTION GO" in settings. A chime and "Connected" prompt will sound, and the dial will remain blue. Use your device for playback control. The Function Knob can also adjust volume. Maintain a connection within 10 meters (33 ft). If no sound plays, ensure the unit is in Bluetooth mode, not Vinyl Stream.

Warnings & Safety Instructions

General Safety Precautions

• Follow basic safety precautions, especially when children are present. Supervise children to ensure they do not play with the appliance.
• Do not damage the power cord (heavy objects, stretching, bending). Do not attach extension cables. Damaged cords can cause fire or electric shock. If damaged, it must be replaced by the manufacturer or qualified personnel.
• Ensure the unit is plugged into an AC 100-240V 50/60Hz outlet. Higher voltage may cause malfunction or fire.
• Do not force a plug into an electrical socket if it does not fit.
• Turn off the unit before unplugging.
• Do not connect or disconnect the power cord with wet hands.
• Ensure the main plug is always easily accessible.
• The product contains no user-serviceable parts. Contact the manufacturer or authorized service department for faults. Exposing internal parts can be dangerous. Unauthorized repairs void the guarantee.
• Use in moderate climates only (not tropical/subtropical).
• Place on a flat, stable, vibration-free surface. Ensure parts do not overhang furniture edges.
• To reduce fire/shock risk, do not expose to direct sunlight, dust, rain, moisture, dripping, or splashing. Do not place liquid-filled objects on or near the product.
• Do not place heat sources (radiators, stoves, amplifiers) near the product.
• Avoid high humidity and poor ventilation areas.
• Do not mount on a wall or ceiling.
• Keep away from strong magnetic fields (TVs, speakers).
• Do not leave the unit unattended when in use.
• Maintain at least 30cm clearance from the rear/top and 5cm from sides. Ensure ventilation openings are not covered.
• NEVER let anyone, especially children, push objects into openings, as this could result in a fatal electric shock.
• Disconnect all cables before a storm to prevent damage from lightning strikes.
• Excessive sound pressure from headphones can cause hearing loss.
• Do not cover ventilation openings; not intended for use on soft surfaces.

Maintenance

Unplug the power cable before cleaning. Use a soft, clean rag for the exterior; never use chemicals or detergents.

Battery Warnings

• Risk of explosion if battery is replaced with an incorrect type.
• Avoid extreme temperatures during use, storage, or transportation, and low air pressure at high altitudes.
• Replacement with incorrect battery type can defeat safeguards.
• Do not dispose of batteries in fire or hot ovens; crushing or cutting can cause explosion.
• Leaving a battery in extremely high temperatures can cause explosion or leakage.
• Battery subjected to extremely low air pressure may result in explosion or leakage.

Condensation Warning

If the unit is moved from a cold to a warm place, or experiences sudden temperature changes, condensation may form. Allow the unit 1-2 hours after plugging into an AC outlet to stabilize before use.

Outdoor Warning

Use caution in direct sunlight or wet weather. The unit cannot get wet. Direct sunlight can damage vinyl records during playback. Check weather conditions before outdoor use.

Auto Stand-by Mode

The device automatically switches to standby after 15 minutes of inactivity. Follow the instruction manual to resume operations.

Note: Product design and specifications are subject to change without notice due to continual improvements.

Bluetooth is a registered trademark of Bluetooth SIG, Inc. Other trademarks and trade names are those of their respective owners.

MADE IN CHINA.

California Prop 65 Warning

WARNING: This product can expose you to chemicals including Lead (known to the State of California to cause cancer) and Bisphenol A (BPA) & Phthalate (known to cause birth defects or other reproductive harm). For more information, go to www.P65Warnings.ca.gov.

Safety Instructions

Power Adapter

• To disconnect from the main supply, unplug the lead from the main socket.
• Only use the supplied main adapter to avoid safety risks and unit damage.

The main plug of the power adapter is the disconnect device. The socket-outlet should be installed near the equipment and be easily accessible.

TO PREVENT FIRE OR SHOCK HAZARD: DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Please read and respect these warnings before operating the appliance:

• AC Voltage
• DC Voltage
• Class II equipment
• For indoor use only
• Energy Efficiency marking with level VI
• Polarity of the D.C. power connector

These symbols appear on electrical and electronic equipment to remind users. Users are requested to use existing return facilities for used equipment and batteries.

Specifications

General

Record Player

Bluetooth

Adaptor

Included

Revolution Go with Removable Lid, Guitar Strap, Slipmat, Power Adaptor, 45 RPM Adaptor, Instruction Manual.

FCC Warnings & Statements

Caution

The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Device Compliance

This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

French Translation: Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de license. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Interference

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC & IC Radiation Exposure Statement

This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

French Translation: Cet équipement est conforme aux limites d'exposition aux radiations définies par le Canada pour des environnements non contrôlés. Cet équipement doit être installé et utilisé à une distance minimum de 20cm entre l'antenne et votre corps. Cet émetteur ne doit pas être installé au même endroit ni utilisé avec une autre antenne ou un autre émetteur.

Warranty

Victrola is a registered trademark of Innovative Technology Electronics, LLC.

United States

Victrola warrants to the original retail purchaser that this product will be free from defective materials and workmanship for one (1) year from the date of purchase, subject to limitations. To obtain replacement, contact the dealer with your original receipt or victrola.com/contact for assistance. If the product proves defective, Victrola will replace it at no charge. If the model is unavailable, a merchandise credit for the purchase price to be redeemed at victrola.com will be issued.

Limitations:

• Does not cover failure from improper installation, storage, transportation, misuse, abuse, accident, neglect, mishandling, unauthorized repair, modification, or wear from ordinary use or environmental deterioration.
• Does not cover cosmetic damage or consequential damage to other components or premises.
• Null and void for products not used in accordance with Victrola's instructions.
• Terminates if the original purchaser sells or transfers the product.
• Null and void for defects or damage caused by installation or repair by non-Victrola authorized personnel.

This warranty grants specific legal rights, which may vary by location. Implied warranties of merchantability and fitness for a particular purpose are limited to the warranty term. Some locations do not allow exclusion or limitation of implied warranties, so this limitation may not apply.

Victrola's liability for malfunctions and defects is limited to replacement or repair. Victrola is not liable for special, punitive, consequential, or incidental damages or losses, including third-party claims or unavailability of products. Maximum liability is the amount paid for the product. Some locations do not allow exclusion or limitation of these damages, so this may not apply.

Canada and US Territories

Warranty complies with applicable law. Contact the dealer or distributor with your original receipt for service. If assistance is impossible, contact customer service at victrola.com/contact. Victrola will replace defective products at no charge. If the model is unavailable or irreparable, Victrola may replace it with a current model of equal or greater value.

Outside the U.S, Canada, and US Territories

Warranty complies with applicable law. Contact the dealer or distributor with your original receipt for service.