Victrola Revolution GO VSC-750SB

Quick Start Guide

Function Knob - Basic Operation

POWER: Press and hold for 1-2 seconds to turn the unit ON or OFF.

VOLUME: Rotate to raise or lower volume.

Function Knob - To Cycle Through Features

VINYL: Press to enter record player function mode.

VINYL STREAM: Press to connect the unit to an external Bluetooth speaker.

BLUETOOTH: Press to pair the unit with a Bluetooth device (smartphone).

Battery Voice Prompts:

When the unit is disconnected from a power source, battery level will prompt as needed.

• >80%: “Battery Full”
• 26%-79%: “Battery Medium”
• <25%: “Battery Low”
• <10%: “Low Battery”

Overview

Top View

Key components visible from the top include:

• Turntable Platter
• Speaker
• 45 RPM Adaptor
• Lift Lever
• Speed / Auto Stop Switches
• Tone Arm
• Tone Arm Stylus
• Function Knob

Rear View

Components on the rear of the unit:

• Charging LED
• RCA Line Out Jack
• Headphone (3.5mm) Jack
• DC Power Input Jack
• Unit Reset

Bottom View

The bottom view shows the:

• Portable Charging Cable Storage Area

Setup and Operation

Simple Setup

Getting Started:

• Remove the needle cover by gently pulling towards the front of the unit.
• Carefully plug in the unit and remove any accessories from the platter.

It is recommended that this product should be operated only from the type of power source indicated on the power adaptor.

Basic Operation

• Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON or OFF.
• Cycle through the Function Knob to select from the following playing modes:
  • VINYL: Playing a Vinyl record.
  • VINYL STREAM: Connecting to an external Bluetooth speaker or headphone.
  • BLUETOOTH: Connecting and playing music from a Bluetooth device (smartphone).
• VOLUME: Rotate to raise or lower the volume.
• RCA LINE OUT: Use the red & white plugs on the back of the unit to connect to an amplifier/stereo device. Be sure to first reduce the volume to a minimum level on the record player.
• HEADPHONE: Use the headphone jack on the back of the unit to connect your headphones/earbuds. Be sure to first reduce the volume to a minimum level on the record player.

Record Holder Lid

The lid can be removed and used as a record holder:

1. Remove record from unit & lower the lid at a 45° angle.
2. Apply light pressure to the bottom sides of the lid.
3. While lid is still at 45°, pull straight upward to remove.

The lid is now an awesome record holder.

Please note the icons for single or double LPs:

• [Single LP Slot Icon]
• [Double LP Slot Icon]

Follow the steps above in reverse to reattach the lid.

Guitar Strap Carry Handle

To attach the guitar strap:

1. Slide the carry strap over both side knobs.
2. Make sure the strap is secure on each side knob.
3. Adjust the strap length if needed and enjoy!

Playing Modes

Vinyl Playing

VINYL: Playing a Vinyl record.

• Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON.
• Simply press the Function Knob to make sure it is in Vinyl mode (the dial will illuminate white).
• Remove the needle cover by gently pulling towards the front of the unit.
• Select the proper record speed. If using a 45 RPM record, use the included 45 adaptor.
• Release the Tone Arm from the holder and gently place on the record using the lift lever.
• Rotate the Function Knob to adjust the volume if needed.

- Make sure to only touch the center or edges of the record to avoid damage to the vinyl grooves.
- If no sound is playing, the unit may be in Vinyl Stream mode; cycle through the function knob to make sure it is in Vinyl mode.

Auto and Manual Stop Selection Switch:

• If this switch is turned ON, the record will start spinning when the tone arm moves over the record and will stop automatically when playback is finished.
• If this switch is OFF, the record will automatically begin to spin when the unit is in “VINYL” function mode and will continue to spin after playback is finished.

Needle Replacement

How to Replace the Turntable Stylus (Replacement Stylus # ATN3600L)

Removing the Stylus from the Cartridge

1. Place your fingers at the tip of the stylus and push down to the direction “A”. WARNING: When applying force to stylus, too much may damage or break the cartridge.
2. Pull the stylus out toward the direction “B”.

Installing the Stylus

1. Hold the tip of the stylus and insert the other edge by pressing toward direction “C”.
2. Push the stylus up toward direction “D” until it locks at the tip.

Caution:

• Do not remove or bend the stylus needle.
• Do not touch the needle to avoid injury to your hand.
• Turn off the unit's power before you replace the stylus.
• Keep out of reach of children.

The stylus should last about 300 hours under normal use. It is recommended that the stylus be replaced as soon as you notice a change in sound quality. 78 RPM records may accelerate stylus wear and may have to be changed sooner.

Vinyl Stream™

VINYL STREAM: Playing a Vinyl record on an external Bluetooth speaker or headphones.

• Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON.
• Simply press the Function Knob to make sure it is in Vinyl Stream mode (the dial will flash white).
• Turn ON your external Bluetooth speaker or headphone, and set to pairing mode.
• Wait a few seconds for the unit to find your device.
• The unit will chime and say “Connected”, while the Function Knob will remain white.
• Use your external device to control the volume.

- In Vinyl Stream mode, internal speakers will be disengaged.
- We recommend placing the Bluetooth device within 1m (3.3') of the product when initially pairing.
- Make sure the unit is within 10m (33ft) from your external device for the strongest connection.
- Vinyl Stream is only compatible with vinyl record playback.
- The product stays in the pairing mode for 30 seconds. If pairing is not properly completed, follow the above steps again from the beginning after turning all devices OFF.

Bluetooth Pairing

BLUETOOTH: Connecting and playing music from a Bluetooth device (Smartphone).

• Using the Function Knob, press and hold for 1-2 seconds to turn the unit ON.
• Simply press the Function Knob to make sure it is in Bluetooth mode (the dial will flash blue).
• On your device, turn Bluetooth ON. Then search for and select “REVOLUTION GO” in the settings menu.
• The unit will chime and say “Connected”, while the Function Knob will remain blue.
• Use your external device to control playback.
• Rotate the Function Knob to adjust the volume if needed.

- Make sure the unit is within 10m (33ft) from your external device for the strongest connection.
- If no sound is playing, the unit may be in Vinyl Stream mode; cycle through the function knob to make sure it is in Bluetooth mode.

Maintenance and Safety

Warning

• Always follow basic safety precautions when using this appliance, especially when children are present.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not damage the power cord, do not place heavy objects on it, do not stretch or bend it. Do not attach extension cables. Damage to the power cord may cause fire or electric shock.
• If the supply cord is damaged, it must be replaced by the manufacturer, a service agent or similarly qualified persons to avoid a hazard.
• Ensure the unit is plugged into an AC 100-240V 50/60Hz power outlet. Using higher voltage may cause the unit to malfunction or catch fire.
• If the power plug does not fit your outlet, do not force it into an electrical socket.
• Turn off the unit before unplugging it from the power source to completely switch it off.
• Do not disconnect or connect the power cord with wet hands, as it may cause an electrical shock.
• Ensure the main plug is always easily accessible.
• This product does not contain any user-serviceable parts. In case of a fault, contact the manufacturer or authorized service department. Exposing internal parts may endanger your life. The manufacturer's guarantee does not extend to faults caused by unauthorized third-party repairs.
• Ensure this product is used in moderate climates only (not in tropical/subtropical climates).
• Place the product on a flat, stable surface that is not subject to vibrations.
• Ensure the product and its parts are not overhanging the edge of the supporting furniture.
• To reduce the risk of fire, electric shock, or damage, do not expose it to direct sunlight, dust, rain, or moisture. Never expose it to dripping or splashing, and do not place objects filled with liquids on or near the product.
• Do not place objects filled with liquids, such as vases, on the apparatus.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Do not place the product where humidity is high and ventilation is poor.
• Do not mount this product on a wall or ceiling.
• Do not place the unit near TVs, speakers, or other objects that generate strong magnetic fields.
• Do not leave the unit unattended when in use.
• Allow at least 30cm clearance from the rear and top, and 5cm from each side. Always ensure ventilation openings are not covered with items like newspapers, tablecloths, curtains, etc.
• NEVER let anyone, especially children, push anything into holes, slots, or any other openings in the unit's casing, as this could result in a fatal electric shock.
• Storms are dangerous for all electric appliances. If the main or aerial wiring is struck by lightning, the appliance might get damaged, even if turned off. Disconnect all cables and connectors before a storm.
• Excessive sound pressure from headphones can cause hearing loss.
• Do not cover ventilation openings; this is not intended to be used on soft support.

Maintenance

• Unplug the power cable from the power source before cleaning the appliance.
• Use a soft clean rag to clean the outside of the unit. Never clean it with chemicals or detergent.

Battery Warnings

CAUTION: WARNING TIPS OF BATTERY:

1. Risk of explosion if the battery is replaced by an incorrect type.
2. High or low extreme temperatures that a battery can be subjected to during use, storage, or transportation; and low air pressure at high altitude.
3. Replacement of a battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types).
4. Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
5. Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
6. A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

Condensation Warning

When the unit is moved from a cold or warm place, or is used following a sudden temperature change, water vapor may condense on the unit, preventing proper operation. In such cases, leave the unit for 1-2 hours after plugging it into an AC outlet to allow it to stabilize at the temperature of its surroundings.

Outdoor Warning

Be careful using the unit in direct sunlight or wet weather conditions. This unit cannot get wet in any way, and direct sunlight can damage some vinyl records during playback. Always check weather conditions before taking the unit or vinyl records outside.

Auto Stand-By Mode

After 15 minutes without any audio input, the device will automatically switch into stand-by mode. Please follow up the instruction manual to resume operations.

Safety Instructions

Power Adapter:

• To disconnect the unit from the main supply, unplug the lead from the main socket.
• Only use the supplied main adapter, as failure to do so may result in a safety risk and/or damage to the unit.

The main plug of the power adapter is used as the disconnect device. The socket-outlet shall be installed near the equipment and shall be easily accessible.

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Please read these safety instructions and respect the following warnings before the appliance is operated:

• [AC Voltage symbol] AC Voltage
• [DC Voltage symbol] DC Voltage
• [Class II equipment symbol] Class II equipment
• [Indoor use only symbol] For indoor use only
• [Energy Efficiency marking symbol] Energy Efficiency marking with level VI
• [Polarity of D.C power connector symbol] Polarity of D.C power connector

The symbols above appear on electrical and electronic equipment (or the packaging) to remind users of this.

Users are requested to use existing return facilities for used equipment and batteries.

Specifications

General

• Power Adaptor: 9V/1.5A
• Power Consumption: 13.5W
• Power Output: 2 x 5W
• Operating Temperature: 0°C - +35°C

Record Player

• Speeds: 33-1/3, 45 & 78 RPM

Bluetooth

• Bluetooth Version: Bluetooth V5.0
• Bluetooth Profile: A2DP, AVRCP
• Bluetooth Frequency Range: 2.40GHz-2.480GHz
• Bluetooth Transmitter Power: ≤10dbm
• Operating Distance: 10 meters (33 ft.)

Adaptor

• Manufacturer: DONGGUAN HP-POWER TECHNOLOGY., LIMITED
• Model: HP18A-0901500-AI

Included:

• Revolution Go with Removable Lid, Guitar Strap, Slipmat, Power Adaptor, 45 RPM Adaptor, Instruction Manual

WEEE and CE Statements

Declaration of Conformity

[CE logo] This device complies with the essential requirements and other relevant provisions of below:

• RED directive: 2014/53/EU
• Low voltage directive: 2014/35/EU
• ROHS directive: 2011/65/EU

You can download the complete EU conformity declaration from www.victrola.com/eudoc.

[SGS logo] [UKCA logo]

The New Recast WEEE Directive (DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and electronic equipment (WEEE).

[WEEE symbol] 1. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities.

2. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health.

3. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service.

Importer information / informations sur l'importateur / Informationen zum Importeur / informazioni sull'importatore / informação do importador / información del importador / Geïmporteerd door / Importer:

www.victrola.com/importer

Model Number: VSC750SBEU-110221