RV SHOCKER™ Instructions

Steps for Use

1. 1. Prepare the Vehicle:

   Place the RV out of direct sunlight (e.g., in a carport or garage).

2. 2. Unpack the Contents:

   Open the container and remove all items inside.

3. 3. Prepare the Pouch:

   • Read all information on the foil packet.
   • Carefully open the packet at the notch edge to avoid damaging the contents.
   • Remove the CLO2DMG Technology™ white pouch and discard the small desiccant.

4. 4. Activate the Pouch:

   • Shake the CLO2DMG Technology™ white pouch thoroughly to mix the ingredients.
   • Place the pouch back into the provided container.

5. 5. Position the Container:

   • Place the container on a stable, flat surface in the center of the space to be treated.
   • For added safety, place it on a plate or container lid to prevent damage from spillage, staining, or bleaching.
   • Avoid placing the container directly on carpet or using it when carpets are wet.

6. 6. Add Water:

   • Using the provided measuring cup, add one full cup of cold tap water over the pouch to activate it.
   • Note: In some cases, the product may clump over time, which could cause a popping or sputtering effect. If you hear this, there's no need to be alarmed. The product will still activate and function as intended.
   • DO NOT put the lid back on the container until the treatment is over and the product is ready to be discarded.

7. 7. Seal the Vehicle:

   • Close all doors and windows, and lock the vehicle to prevent entry while the product is working.
   • WARNING: Under no circumstances should any person or pet be in the vehicle while the product is active.

8. 8. Duration of Treatment:

   Leave the product working for a minimum of 4 hours and up to 24 hours.

9. 9. Post-Treatment Ventilation:

   • At the end of the treatment, open all doors, windows, and vents for ventilation.
   • Place the lid back on the product and dispose of it in an outdoor waste container.
   • Allow the vehicle to ventilate for 30-60 minutes before re-entering.

Tips for Optimal Performance

• Preparation: Ensure all interior compartments (e.g., glove box, armrest compartments, and cabinets) are open.
• Visors: Pull down all visors.
• Floor Mats: Place floor mats on their sides.
• Clean Up: Clean out ashtrays and remove any trash.
• Filters: Change air filters.
• Fan Setting: Before step 9, set the fan to recycle mode and run it for 15 minutes.

Temperature Requirement: Ensure the temperature is at least 50°F for effective operation.

Additional Information

Safety Note:

• The product is safe and non-toxic when used as directed. It degrades into a saline solution. All components are biodegradable and eco-friendly.
• WARNING: While RV Shocker™ is non-toxic, chlorine dioxide can be an irritant. Avoid inhaling the gas directly. (Do not do a smell test.)
• To prevent spills or accidental inhalation of fumes, activate the product only at point of use.
• Do not walk with the product after activation from point A to point B, as this may result in exposure to concentration of fumes.
• For added safety, wear a mask and protective eyewear during handling or when ventilating the vehicle.
• Important: Ensure the lid is securely placed on the container before removing it from the vehicle to avoid spills. Any spilled liquid may bleach surfaces it comes into contact with.
• If the carpets have been washed, make sure the carpets are completely dry before use. Moisture in the RV will retain the chlorine dioxide molecules for a longer period of time.

Money-back Guarantee: Retain the foil packet and visit our FAQ page at www.BiocideSystems.com.