Marine Shocker™ Instructions

Step-by-Step Instructions

1. Prepare the Cabin

   • Move the boat out of direct sunlight or block sunlight from entering the designated cabin space.

2. Open the Package

   • Open the container and remove all contents.
   • Carefully read all information on the foil packet.
   • Open the foil packet at the notched edge, being careful not to damage the contents inside.
   • Remove the CLO2DMG Technology™ white pouch and discard the small desiccant pouch. Save the foil packet until the treatment is complete.

3. Activate Marine Shocker™

   • Shake the CLO2DMG Technology™ white pouch thoroughly to mix ingredients.
   • Place the pouch back into the provided container.
   • Place the container in the designated treatment area. For added protection, place it on a plate or container lid to prevent possible spillage, staining, or bleaching.

4. Add Water

   • Using the provided measuring cup, add one full cup of cold water over the pouch to activate.
   • DO NOT replace the lid on the container until the treatment is complete and the product is ready for disposal.
   • Note: In some cases, the product may clump over time, which could cause a popping or sputtering effect. If you hear this, there's no need to be alarmed. The product will still activate and function as intended.

5. Secure the Cabin

   • Lock the cabin to prevent entry during treatment.
   • WARNING: Do not allow people or pets inside the cabin while the Marine Shocker™ is active.

6. Treatment Duration

   • Allow the Marine Shocker™ to work for 4 to 24 hours.

7. After Treatment

   • Open all doors for ventilation.
   • Place the lid back on the container and dispose of it in an outdoor waste container.
   • Allow the cabin to ventilate for at least 30 minutes before re-entry.

Tips for Best Results

• Open all interior compartments (cabinets, glove box, armrests, etc.).
• Pull down all visors.
• Stand floor mats on their sides.
• Clean out ashtrays and remove trash.
• Replace air filters before use.
• Before proceeding to Step 7, set the fan to recirculate and run it for 15 minutes.
• For best results, the minimum temperature for activation should be: 50°F.

Additional Information

Safety Note:

• The product is safe and non-toxic when used as directed. It degrades into a saline solution. All components are biodegradable and eco-friendly.

WARNING:

• While Marine Shocker™ is non-toxic, Chlorine Dioxide can be an irritant. Avoid inhaling the Chlorine Dioxide directly. (Do not do a smell test.)
• To prevent spills or accidental inhalation of fumes, activate the product only at point of use.
• Do not walk with the product after activation from point A to point B, as this may result in exposure to concentration of fumes.
• For added safety, wear a mask and protective eyewear during handling or when ventilating the cabin.

Important:

• Ensure the lid is securely placed on the container before removing it from the cabin to avoid spills. Any spilled liquid may bleach surfaces it comes into contact with.
• If the carpets have been washed, make sure they are completely dry before use. Moisture in the cabin will extend the presence of chlorine dioxide molecules.

Money-Back Guarantee

Retain the foil packet and visit our FAQ page on www.BiocideSystems.com.

Contact Us

1-877-RX BIOCIDE / 1-877-792-4624

www.BiocideSystems.com

Proudly Made in the USA!