Maverick R BRP GO Sub/RCA Output Harnesses
Part #: UTVS-GO-SUB-OUT, UTVS-GO-RCA-OUT
Parts List:
- BRP GO Sub Harness: x1
- BRP GO RCA Harness: x1
Tips:
- If you lose audio, for example when doing software updates, revert back to steps 1 & 2.
- If your Bluetooth won't connect, "Forget Device" from your phone, then try resetting the headunit and repeat steps 1 & 2.
Attention:
Make sure your software is at least version 3.1.1 or newer.
To Update:
- Connect the vehicle to Wifi.
- Go to Settings > Preferences > General Settings > Software Update.
Recommended Products:
Rocker Switch Bass Knob (Part #: UTVS-RKR-BASS-KNOB) *Sold Separately
Scan to watch the Installation Video! ?
These Settings Are Required to Activate Audio Output:
- Start by going to Settings > Preferences.
- On the Audio tab, tap "Audio Output".
- Change the Audio Output to "Speakers" (Default is set to Headset).
- Tap "Audio Configuration".
- Select "Level 5". *You will be prompted to restart the vehicle.
- Restart the ignition.
Installation Steps:
- Open the side panel as shown.
- Remove the T-25 screw & remove the A-pillar cover.
- Remove the 10mm bolt & T-30 screw.
- Remove the hood piece.
- Remove the dash panel.
- Remove both 10mm bolts.
- Remove the Panel.
- Locate the OEM plugs.
- Remove the OEM caps on both plugs.
- SUB OUTPUT: Plug in the white harness plug into the SMALLER OEM plug.
- RCA OUTPUT: Plug in the white harness plug into the LARGER OEM plug.
- Connect the remote (blue) wire.
- Connect the remote (blue) wire.
- Run RCA's & Remote Wire to Amp(s).
Support:
We are here to help! Reach out to us at info@utvstereo.com or call us at 480.616.2299.
