Foxeer Arrow 600TVL/700TVL CCD Mini FPV Camera
Instruction Manual
⚠️ WARNING
Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property, and cause serious injury.
Age Recommendation: Not for children under 14 years. This is not a toy. ?
NOTICE: This product is only intended for use with unmanned, hobby-grade, remote-controlled vehicles and aircraft. FOXEER disclaims all liability outside of the intended purpose and will not provide warranty service related thereto. ℹ️
SUPPORT: Visit www.foxeer.com/support to get more information. ❓
Connections
CAMERA-OSD SWITCH CONNECTION
Diagram shows a 7-pin harness connecting to the camera back. The pins are labeled VCC (5-35V DC), GND, VID (Video Out), AUD (Audio Out), OSD, GND, and VSEN (Voltage Sensor). A separate 4-pin connector is for the Video Transmitter. A 2-pin connector is for the OSD Switch board.
The OSD Switch Front is depicted with four buttons labeled UP [⬆️], DOWN [⬇️], LEFT [⬅️], RIGHT [➡️], and a central MENU [☰] button.
CAUTION: If using ESCs with active braking, power the camera system via a BEC or voltage regulator.
CAMERA-VIDEO TRANSMITTER CONNECTION
Diagram shows a 4-pin harness connecting from a Video Transmitter to the Camera. The OSD pin on the camera is left unconnected.
FPV OSD Setup
The OSD (On-Screen Display) can be configured to show information like user name, time, and voltage.
- User Name Setup: Long press the left button [⬅️]. The user name will flicker, allowing you to move its position. Press the center button [☰] to save.
- Time Setup: Long press the right button [➡️]. The time will flicker, allowing you to move its position. Press the center button [☰] to save.
- OSD Info Enable/Disable: Long press the top button [⬆️] to set the user name. You can also enable or disable OSD info separately. Press EXIT [❌] to save.
- Voltage Setup: Long press the bottom button [⬇️]. The voltage display will flicker, allowing you to move its position. Press the center button [☰] to adjust the voltage if it differs from the actual power. Press the center button [☰] again to save.
The OSD displays a character set including numbers (0-9), uppercase letters (A-Z), and common symbols like parentheses, colon, slash, and greater/less than signs. Font size, Name display, Time display, and Power display can be set to ON/OFF.
