Installation Instructions

Step 1

Illustration showing the lamp body being attached to a ceiling mount with wires hanging down.

Step 2

Illustration showing expansion screws being hammered into the ceiling, with a hammer.
[Expansion Screws]

Step 3

Illustration showing the ceiling mount with wires, including a yellow ground wire connected to a screw.
The ground wire is connected to the screw and connected to the household ground wire.

Step 4

Illustration showing wires being threaded through accessories from above the ceiling panel and secured with nuts and screws.
Thread the wires through the accessories that fix the wires and exit from above the ceiling panel. Secure the top with a nut and tighten the transparent screw that fixes the wires below.

Step 5

Illustration showing wires being tied together with insulating tape.
Tie the wires of the same color tightly with insulating tape.

Step 6

Illustration showing the ceiling plate being screwed and tightened with a nut.
Screw through the ceiling plate and tighten with a nut.

The Lamp Instruction

Important Symbols and Guidelines:

[Indoor use only] [General warning] [Voltage compatibility check] [Voltage compatibility check] [Earth connection required] [Class II Double insulated] [Product certification mark] [Not dimmable] [Do not use in damp/wet locations] [Avoid chemical solvents] [Do not strike] [Do not cut] [Do not spray] [Do not plug in] [Turn off power before maintenance] [Not for outdoor use]

Note: Installation distances may apply (e.g., 3m, 2.25cm). Refer to specific product specifications if provided elsewhere.

Maintenance and Precautions