Introduction
This product is not suitable for primary heating purposes. It is intended for well-insulated spaces or occasional use.
Safety Instructions
Read these instructions thoroughly before using the appliance. Keep this manual for future reference.
- Ensure mains voltage matches the rating label and the wall outlet is grounded.
- Do not cover air inlet or outlet openings. Maintain a minimum distance of 0.5 m from all sides to objects or walls.
- Do not insert objects into ventilation openings, as this may cause electric shock, fire, or damage.
- Do not use in dusty environments or near heat sources, flammable substances, or wet surfaces. Avoid contact with water or other liquids.
- The product's surface may reach high temperatures; use the handle to move it.
- Never touch an appliance that has fallen into water; unplug immediately.
- Regularly inspect the power cord for damage. If damaged, it must be replaced by authorized service to avoid danger.
- This appliance is for household use only, not commercial or industrial purposes.
- Do not allow the cord to contact hot surfaces.
- Do not attempt to repair, disassemble, or modify the appliance. It contains no user-serviceable parts.
- Do not use to dry clothes or leave unattended while operating.
- Do not immerse the cord, plug, or any part of the appliance in water or other liquids. Ensure hands are dry before handling the plug or switching on.
- Do not place the appliance immediately below a socket-outlet.
- Do not use in bathrooms, laundry areas, or similar humid locations. Avoid placing where it may fall into a bathtub or be exposed to water.
- Remote control contains a lithium battery; keep out of reach of children. Seek medical advice if swallowed. Remove battery if not in use for extended periods.
- Appliance not for children under 8. Can be used by children 8+ with continuous supervision.
- Can be used by children 8+, and persons with reduced capabilities or lack of experience if supervised and instructed on safe use.
- Supervise children to ensure they do not play with the appliance. Strict supervision is necessary when used by or near children.
- Battery Instructions: Keep batteries away from children and animals. In case of ingestion, seek medical assistance. Avoid contact with battery acid if leaked. Wash affected areas immediately with water and contact a doctor. Ensure battery contacts are clean before inserting. Use only specified battery types. Replace all batteries simultaneously. Pay attention to polarity (+/-). Remove batteries when discharged or if the device is unused for a long time. Batteries must not be recharged, dismantled, thrown into fire, or short-circuited.
Parts and Components
Front View (Fig. 1):
- 1. Housing
- 2. Outlet
- 3. Display
- 4. Base
- 5. Safety push button
Back View (Fig. 1):
- 6. Filter
- 7. Power switch
Remote Control (Fig. 3):
- 1. On/Off
- 2. Mode
- 3. Temperature Increase
- 4. Timer
- 5. Temperature Decrease
- 6. Oscillation
Battery Replacement (Fig. 4): The remote uses a Lithium Button Cell Battery (CR2025). If unresponsive, turn remote upside down, slide tab A to the right, remove battery tray B, and insert a new battery of the same type, positive side up.
Before Use
Remove the product from the box and all packaging materials. Inspect for visible damage; contact Cecotec Technical Support if any is found. Place the heater on a flat, stable surface. Set the power switch to "0" and plug into an earthed power supply.
Note: A slight odor may occur during the first few minutes of use or after storage; this is normal and will dissipate.
Operation
The device can be operated via the control panel or the remote control.
Power Switch: Located on the back of the unit to turn it on/off.
Control Panel (Fig. 2):
- 1. Oscillation: Press to activate/deactivate oscillation. The indicator light will turn on, and airflow will move left to right.
- 2. Mode/On/off: Press once to turn on. Press again to select one of three modes: Fan, Low, High. The corresponding light stays steady. To turn off, press until Fan mode is selected, the light flashes, and a 30-second countdown appears on the display.
- 3. Timer: Press repeatedly to increase operating time by 1-hour intervals (1-12 hours). The display shows remaining time, and the timer light illuminates. Press repeatedly to cancel (display shows 00).
- 4. Temperature: Press repeatedly to increase room temperature from 15 to 40°C. Digits flash for 3 seconds after setting, then display shows ambient temperature. The device automatically switches modes when the selected temperature is reached.
Safety Feature: A safety push button on the base automatically shuts off the device if accidentally tilted.
Mobile App (for 05371 ReadyWarm 8400 Bladeless Connected): Download the EnergySilence app. Register or sign in. Select "ReadyWarm Bladeless". Turn on the device until a beep and flashing LED. Enter Wi-Fi password (2.4 GHz network required). Linking starts automatically. If it fails, repeat with slow blinking LED, then re-enter Wi-Fi password.
Cleaning and Maintenance
- Turn off, unplug, and allow to cool before cleaning.
- Do not use abrasive scouring pads, powders, or cleaners. Use a soft, damp cloth for the exterior. Be careful not to touch heating elements.
- Dust and fluff accumulation can cause overheating. Regularly vacuum air vents and grilles.
- For long periods of non-use, store in a dry, safe place protected from dust.
- To remove the filter: press the two rear tabs, remove the protective grille, shake out the filter, and clean with a cloth. Do not wash the filter.
Troubleshooting
- No Power: Check power cord connection, socket power, and rear power switch position (ensure it's ON).
- Unusual Odor: New units may emit a slight motor odor during first use, which dissipates within a week. No action required.
- Vibrations and Noise: Ensure the unit is on a flat surface. Place an anti-vibration mat underneath if necessary. If damaged, discontinue use and contact Cecotec Technical Support.
Technical Specifications
Model: ReadyWarm 8200 Bladeless
Reference: 05370
Power: 1500 W
Voltage: 220-240 V~/50-60 Hz
Model: ReadyWarm 8400 Bladeless Connected
Reference: 05371
Power: 1500 W
Voltage: 220-240 V~/50-60 Hz
Disposal of Old Electrical Appliances
Dispose of this product according to European directive 2012/19/EU (WEEE). Do not dispose of with municipal waste. Collect separately for recovery and recycling. If the product contains batteries, remove them separately for disposal. Contact local authorities for proper disposal information.
Warranty and Technical Support (SAT)
This product has a 2-year warranty from the date of purchase, provided proof of purchase is submitted, the product is in perfect condition, and used as instructed. The warranty does not cover misuse, damage, unauthorized repairs, or normal wear and tear.
For any issues or queries, contact Cecotec Technical Support Service at +34 963 210 728.
