Philips Hue Centris Smart Spotlight
User Manual
Product Overview
This document provides instructions for the Philips Hue Centris smart spotlight, a versatile lighting solution for your home. The product is branded as Philips Hue and is part of their personal wireless lighting system.
Hue Serial Number: Refer to the product label for the specific serial number.
Included in the Box
- A: Philips Hue Centris smart spotlight fixture.
- B: Mounting hardware kit.
Required Tools (Not Included)
- Drill
- Pencil
- Screws and wall plugs (appropriate for your mounting surface)
- Phillips head screwdriver
- Flat head screwdriver
Safety Precautions and Installation Guidelines
⚠️ Important: Always ensure the power supply is turned OFF at the main circuit breaker before beginning installation.
The fixture is designed for indoor use and should not be exposed to moisture. Ensure a minimum clearance of 5cm from the ceiling for proper ventilation.
The spotlight heads can be tilted up to a maximum of 45 degrees.
The fixture uses GU10 LED bulbs with a maximum wattage of 6W per bulb.
Observe correct electrical connections: Live (L), Neutral (N), and Earth (ground).
The product is rated for 230V.
[Energy Efficiency Class G] [Energy Efficiency Class E]
[Not suitable for wet locations] [Earth Ground Symbol]
Installation Steps
- Power Off: Turn off the main power supply at the circuit breaker. [Hand switching off breaker]
- Preparation: Place the fixture on a stable surface, ensuring it is properly supported. [Fixture on table]
- Attach Brackets: Attach the mounting brackets to the fixture using two screws. [Diagram showing bracket attachment]
- Wire Connection: Connect the wires to the terminal block, ensuring correct polarity (L, N, Earth). [Diagram showing wire connection]
- Mount Fixture: Mount the fixture to the ceiling track or surface using the provided hardware. Follow the indicated mounting method for secure attachment. [Diagram showing ceiling/track mounting]
- Final Wiring: Connect the mains wiring to the terminal block, observing Live (L), Neutral (N), and Earth (ground) connections. [Detailed wiring diagram]
- Adjust Angle: Adjust the spotlight head to the desired angle, not exceeding a maximum tilt of 45 degrees. [Diagram showing tilt adjustment]
- Secure Fixture: Secure the fixture to the mounting points. [Diagram showing securing with screws]
- Attach Cover: Attach the protective cover. [Diagram showing cover attachment]
- Connect to Power: Connect the fixture to the power supply or track system. [Diagram showing track connection]
- Install Bulbs: Insert the GU10 LED bulbs into the sockets. Twist gently to lock or unlock. [Diagram showing bulb insertion]
- Final Check: Perform final checks to ensure all connections are secure. [Diagram showing connection check]
- Power On: Turn the main power supply back ON at the circuit breaker. [Hand switching on breaker]
Bulb Replacement and Adjustment
The spotlight heads can be rotated approximately 350 degrees horizontally and 90 degrees vertically to direct light as needed.
To install or remove a GU10 bulb, twist it gently to lock or unlock it in the socket.
Support and Information
For more information and support, visit the Philips Hue website:
You can also find product setup information at: www.philips-hue.com/connectproduct
