TL-LD260-F Instruction Manual

This safety light is designed for mounting on a bicycle handlebar to improve visibility of oncoming vehicles and pedestrians during night cycling.

Battery Replacement

Insert a coin into the groove on the rear of the light and twist to remove the upper body (Figure 1).

Insert three AAA batteries, observing the polarity markings on the body.

Attach the upper body back on (Figure 2).

Figure 1: Shows the ON/OFF/Mode switch, LED indicator, and battery compartment access.

Figure 2: Illustrates inserting AAA batteries and reattaching the cover.

Diagram showing battery insertion: "AAA Dry Batteries"

Bicycle Mounting

Attach the mounting band along with the rubber pad to the handlebar. If a secure fit cannot be achieved, use the two included rubber pads of different thicknesses to adjust for various pipe sizes. Secure the bracket with the screw, then click the main unit into the bracket until it is firmly in place.

Note: Mount the unit in a location that does not interfere with riding.

To remove the unit, press the lever on the bracket and slide it off.

Diagram showing mounting band and bracket: "Bracket Mounting Band: SP-5"

Diagram showing rubber pads: "Compatible with handlebar diameters Ø23.5 - 27.2 mm using the included 2 types of rubber pads."

Precautions

• This product is not fully waterproof. After use in rain, wipe off any moisture promptly to prevent damage.
• Turn the light ON/OFF only when the bicycle is stopped.
• Be careful not to forget to turn off the switch.
• AAA alkaline batteries are recommended.
• Ensure correct battery polarity (positive and negative terminals).
• Do not mix old and new batteries or batteries of different types.
• Periodically clean the battery contacts to prevent poor light output.
• If the product will not be used for an extended period, remove the batteries to prevent leakage and potential damage. Store the batteries separately.
• The included batteries are for monitoring purposes and may not reflect the specified continuous usage time.
• If the included mounting band (SP-5) is damaged, lost, or does not fit, do not force it. Instead, consider purchasing optional parts (refer to the table).

Optional Parts (Sold Separately)

Mounting bands (Please use a size that fits your handlebar pipe).

Specifications

• Usage Time: Approximately 200 hours (flashing mode) / Approximately 100 hours (steady mode) ※Alkaline batteries used.
• Size: 80×48×28mm
• Weight: 48g (including batteries, excluding bracket)
• Light Source: White LED x 1
• Battery: AAA Dry Batteries x 3
• Material Specifications:
• Body: ABS
• Lens: Polycarbonate
• Bracket: Polyamide

Specifications and external appearance are subject to change without notice for product improvement.