Installing Stacking Holders for Projectors
This supplement provides additional information regarding the installation of stacking holders for projectors. The projector main unit does not come with stacking holders; instead, it includes rubber caps. When stacking projectors, it is essential to install the four (4) stacking holders onto the projector body as described below. If not stacking the projector, there is no need to install the stacking holders.
Important Notes
- Please contact your dealer for details on installing stacking holders on the projector and for information on stacking projectors.
- This projector includes four (4) stacking holders, four (4) large screws, and four (4) small screws. These are not listed in the included parts list in the projector's "Important Information," "User Manual," or "Installation Manual."
Tools Required: The following tools are necessary for installing and removing the stacking holders:
- Hex wrench (8mm opening) (commercially available)
- Phillips head screwdriver (commercially available)
The illustrations in the projector's "User Manual" and "Installation Manual" show the stacking holders already installed (see image below).
Projector with Stacking Holders Installed: [Diagram showing a projector with four stacking holders attached to the bottom.]
Projector without Stacking Holders Installed: [Diagram showing a projector without stacking holders, only rubber caps.]
When installing the projector using eye bolts (commercially available), ensure that the stacking holders are attached. For instructions on installing eye bolts, please refer to the projector's installation manual.
Installing Stacking Holders
Before stacking projectors, install the four (4) stacking holders on the top surface of the projector that will be placed at the bottom. Additionally, retract the four (4) tilt feet of the upper projector.
Tilt Feet: [Diagram showing the tilt feet of the projector.]
Stacking Holders: [Diagram showing the stacking holders.]
Four Locations: [Diagram indicating the four mounting points for the stacking holders on the projector.]
Steps
-
Remove Rubber Caps and Screws (Four Locations):
- Using your fingernail or tweezers, lift and remove the rubber caps. Store the removed rubber caps properly.
- Turn the screws counterclockwise to remove them. Store the removed screws properly.
-
Install Stacking Holders (Four Locations):
- Place the stacking holders onto the screw holes.
- Using the hex wrench, tighten the included large screws clockwise.
- Using the Phillips head screwdriver, tighten the included small screws clockwise.
For Reference
- To remove the stacking holders, follow the reverse of the installation steps above.
- After removal, store the four (4) stacking holders and four (4) screws properly.
