Bosch Dishwasher Installation Instructions
This document provides comprehensive instructions for the installation of your Bosch dishwasher.
Before You Begin
Ensure you have all the necessary parts and tools. The estimated installation time is 2-3 hours.
Parts Included
The package contains various screws, brackets, and connectors. Specific screw types include Ø4x36, Ø4x30, and Ø4x15. Tools required include Torx screwdrivers (T15, T20), a hammer, a spirit level, a jigsaw, a drill with a 2mm bit, and wrenches (SW13, SW10).
Installation Steps
- Preparation: Unpack all components and verify against the parts list.
- Water Connection: Connect the water inlet hose (max. 1.1 m length, min. 280 mm from the floor) to the water supply. Ensure the water pressure is between 0.05 - 1 MPa (0.5 - 10 bar) and the water temperature is below 60°C. The inlet connection is G 3/4".
- Drainage Connection: Connect the drain hose to the sink's drainage system. The hose should have a minimum diameter of 18 mm and a maximum length of 2.2 m. Ensure the hose is secured with a clamp.
- Electrical Connection: Connect the power cord to a properly grounded electrical outlet. The power cord is 5 meters long.
- Unit Placement: Position the dishwasher in its designated location. Ensure adequate space around the unit for ventilation and access. Recommended clearances are 550 mm width, 815-875 mm height, and 600 mm depth.
- Securing the Unit: Use the provided brackets and screws to secure the dishwasher to the surrounding cabinetry. Follow the diagrams carefully to ensure correct placement and fastening.
- Adjustments: Make any necessary adjustments to the leveling feet to ensure the unit is stable and level. The installation may involve securing the unit to countertops or side panels using specific brackets and screws.
- Cable Management: Ensure all cables are neatly managed and not pinched. The diagrams show how to route cables to prevent damage.
- Final Checks: Perform a leak test on the water connections and ensure all electrical connections are secure. Check for proper operation of the dishwasher.
Important Notes:
- Do not pinch any cables or hoses during installation.
- Ensure all connections are tight and secure.
- Refer to the specific diagrams for precise measurements and component placement.
- The unit requires a minimum clearance of 10 mm for water connections.
- Maximum torque for water connections is 10 Nm.
- Water flow rate should be at least 10 l/min.
Troubleshooting and Adjustments
The installation guide includes steps for adjusting the door hinges and ensuring proper alignment. Specific measurements are provided for door adjustments (min. 70 mm, max. 120 mm). The unit may require securing with screws (Ø4x36) and using a Torx T20 screwdriver.
For precise alignment, follow the detailed diagrams showing how to measure and position components. Some steps involve using a spirit level and measuring tape for accuracy.
The final steps involve checking the unit's stability and ensuring all parts are correctly installed. The installation process may involve securing the unit to the floor or cabinets using specific brackets and screws.
Product Information
Part numbers mentioned include ET-Nr. 00350564 for hoses and ET-Nr. 12022522 for the power cord. Other part numbers like ET-Nr. 00622456 and ET-Nr. 11029813 are also referenced in relation to specific components or installation steps.
The installation may require specific tools such as a 2mm drill bit for pilot holes and a measuring tape for accurate placement.
