INSMY Clip-S Clip-On Speaker

Button Functions

Power On/Off: Hold the power button for 2 seconds to turn on, and hold for 4 seconds to turn off.

Auto off: No connection for 10 minutes. Auto disconnect: No music playing for 30 minutes after wireless connection.

Pairing Mode: Press the power button for 2 seconds to enter pairing mode. The device can be paired within a 10m (free space) range.

Connection Status: When the connection is successful, the white indicator light is on. When playing music, the white indicator light is off. When disconnected, the white indicator light flashes.

Volume Control: Press the '+' button to increase volume, press the '-' button to decrease volume.

Track Control: Press the next track button (>) to skip to the next track. Press the previous track button (<) to go to the previous track.

Play/Pause/Call: Press the play/pause button (▶/||) once to play or pause music. Press once to answer or end a call. Press twice to redial the last number. Press three times to reject an incoming call.

TWS Pairing: Press the TWS button twice to activate stereo pairing mode.

Stereo Pairing Mode

1. Turn on both speakers and the indicator light will flash.
2. Double-tap the power button on either speaker.
3. A tone sounds and the indicator light stops flashing.
4. Turn on your Bluetooth device and search for INSMY CLIP S.

Note: Double-tapping the power button will disconnect the pairing.

Restore Factory Settings

Hold the power button for 5 seconds to reset the device. The white light will stay on for 2 seconds to indicate a successful reset. Power the speaker off and on again to start the new pair.

If the INSMY-Clip-S is not connecting correctly with your devices, you may need to reset it. After resetting, delete the paired "INSMY-Clip-S" from your device and re-pair it.

Forget Device: On your Bluetooth device, navigate to Bluetooth settings, find "INSMY-Clip-S" under your devices, and select "Forget this device".

Charging Instructions

LED Indicator:

• During charging: Red indicator is on.
• Fully charged: Red indicator is off.
• Charging time: Approximately 1.5 hours for 0%~100% charge.

Input: DC 5V @ 1A

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Customer Support

To Our Valued Customer,

Thank you for your purchase. If there is any quality issue of the speaker, please feel free to contact INSMY via Amazon message service or email at service@insmy.com. We will follow up within 24 hours.

Sincerely,
INSMY

CE FC ROHS

FCC ID: 2BA4Q-CLIP-S Made in China