Air Innovations Clean Mist Top-Fill Sensa Touch Humidifier
Model: MH-902
Instruction Manual and Warranty Information
No More Dry Air
Thank you for choosing the Air Innovations® Clean Mist® Top-Fill Sensa Touch™ Humidifier with Crisp Sound™ Bluetooth Speaker & Aroma Tray. This humidifier uses Ultrasonic Top-Fill Technology to create humidity instantaneously, working silently to erase the discomforts of dry air.
Unpacking
- Remove the Dual Directional Mist Nozzle.
- Carefully remove the humidifier from the box by pulling the Base of the unit. Do not take the unit out of the box by pulling the tank.
- Remove the plastic bag from the humidifier.
*Follow directions to fill and operate the humidifier.
Specifications
| Product Model | Power Consumption | Rating Voltage | Tank Capacity | Dimensions | Weight |
|---|---|---|---|---|---|
| MH-902 | 30W | 110-120V~60Hz | 6.1L / 1.6G | 10.5"W x 8"D x 18"H | 4 Lbs. |
Parts & Contents
- 1. Dual Directional Mist Nozzle
- 2. Water Tank Lid / Finger Lift (2a. Lid, 2b. Finger Lift)
- 3. Water Tank
- 4. Base with Built-In Crisp Sound™ Bluetooth Speaker
- 5. Sensa Touch™ Control Panel
- 6. Air Outlet
- 7. Cleaning Brush
- 8. Water Reservoir
- 9. Ultrasonic Nebulizer
- 10. Water Sensors
- 11. Water Inlet
- 12. Ceramic Filter
- 13. Silicone Plug (for cleaning ONLY)
- 14. Aroma Tray (located on the rear of the unit)
Filling The Water Tank
WARNING: Never turn Water Tank upside down when full.
WARNING: DO NOT use extremely cold water, since it may temporarily reduce the mist output.
WARNING: NEVER fill with hot/warm water or use additives as this could damage the unit and void the warranty.
WARNING: If you have hard water, use our Humidifier Demineralization Filters (available at www.Air-Innovations.com) or use ONLY filtered/distilled water.
- Ensure the Water Tank is firmly seated on the Base so there is no visible gap between Water Tank and Base.
- Use the Finger Lift to open the Water Tank Lid.
- Fill the Water Tank using clean, cool water. Note: Do not fill past the MAX fill line.
- Close the Water Tank Lid. NOTE: DO NOT block air holes as this will affect the performance of the unit.
- Attach the Dual Directional Mist Nozzle to the top of the Water Tank. To easily control the direction of the mist, simply separate the Dual Directional Mist Nozzle and position as desired.
Operating Instructions
Plug unit into a standard (120V AC) electrical outlet.
ON/OFF: Touch the Sensa Touch™ power button to turn the humidifier on. NOTE: During the first use, the waterless indicator may illuminate before mist appears; allow up to 15 minutes for the water in the tank to transfer to the base.
Mist Output: When you turn the unit ON, it will default to the Low mist setting and one white LED light will be lit. Touching the power button again will increase the output, indicated by additional white LED lights. Touch once for Medium, twice for High, three times for the Supreme setting. Touching the power button a fourth time will turn the humidifier off.
- Low: 1 LED lit
- Medium: 2 LEDs lit
- High: 3 LEDs lit
- Supreme: 4 LEDs lit
Auto LED Dim: After approximately 30 seconds, the LED light will automatically turn off. Touching the power button on the unit will illuminate the light again but will not change the setting. Touch the power button a second time to alter the setting. The humidifier is factory set to silent mode and will only beep to indicate the unit is out of water.
Extra Features
Crisp Sound™ Bluetooth Speaker: The humidifier has a built-in speaker compatible with all Bluetooth audio devices. The speaker can be enjoyed with the humidifier turned On or Off.
Pairing Your Device
- Go to settings on your device.
- Tap the Bluetooth option.
- Turn on Bluetooth.
- A list of available devices will appear.
- Tap "AI 902" to pair your device with the speaker.
Note: The speaker automatically reconnects to the last device used. To disconnect, tap "AI 902" and choose "disconnect." Trouble connecting? Refer to page 7, "Troubleshooting."
Auto Safety Shut-Off: When the Tank is out of water, the Waterless indicator will illuminate, and the automatic safety shut-off will turn the unit OFF. The unit will beep three times before turning off.
Aroma Tray: By inserting an Air Innovations Aroma Pad into the built-in Aroma Tray, you can transform your humidifier into an easy-to-use fragrance dispenser. Visit www.Air-Innovations.com to purchase additional Aroma Pads.
Weekly Cleaning & Care
WARNING: Before cleaning, always turn power off and unplug the unit from the outlet.
WARNING: DO NOT rinse Base under faucet. To clean, wipe the Base with a soft cloth.
WARNING: DO NOT use any solvents or aggressive cleaning agents. Keep water away from the Air Outlet.
WARNING: DO NOT tamper with the Water Sensor.
About White Dust
Use of high-mineral content water may cause a white mineral residue to accumulate on room surfaces near the humidifier, commonly referred to as "White Dust". The higher the mineral content, the greater the potential for White Dust. This is not a defect but due to minerals suspended in tap water. WARNING: If you have hard tap water, STOP using tap water and visit www.Air-Innovations.com to purchase Humidifier Demineralization Filters or use ONLY filtered/distilled water.
Tank Cleaning
Unplug unit & remove the Mist Nozzle from the top of the Water Tank, then remove the Water Tank from the unit. Turn the tank upside down and drain any water. Wipe the tank with a soft damp cloth, then rinse it with warm water inside and out.
Base Cleaning
- Unplug unit.
- Use the enclosed Silicone Plug and place it over the water inlet.
- Clean the Base by gently wiping with a soft damp cloth.
Using Silicone Plug: Apply the enclosed plug during cleaning ONLY to avoid debris entering the pump. NOTE: The plug MUST be REMOVED for normal operation and filling.
White Dust Cleaning
If mineral deposits are evident around the Ultrasonic Nebulizer and Water Sensor, clean these surfaces with a soft cloth and a small amount of undiluted white vinegar. If necessary, mix a solution of 50% white vinegar and 50% water and fill the Base with enough solution to cover the Ultrasonic Nebulizer. Allow it to soak for an hour, then use the provided brush to gently loosen buildup. Put 1 cup of water in the Base and wipe clean with a soft cloth.
WARNING: DO NOT rinse Base under faucet.
WARNING: When emptying the Water Reservoir in the Base, make sure that the water is poured away from the Air Outlet. If water is poured into the outlet, it may damage the humidifier.
Ceramic Water Filter Cleaning
- Unplug unit and empty water from Tank.
- Lift Water Tank Lid and place hand inside the Tank. Moderately grasp the Ceramic Water Filter and unscrew by twisting counterclockwise.
- Rinse the Ceramic Filter with running tap water for approximately 20-30 seconds.
- Replace filter inside Water Tank by twisting clockwise until secure.
Surface Cleaning
Clean all surfaces of the unit with a clean damp soft cloth.
Storage
- Follow all cleaning instructions prior to storage.
- Dry all parts, including the inside of the Water Tank.
- Preferably store in its original box, in a dry place away from high temperatures.
- Follow all cleaning instructions after long periods of storage.
Troubleshooting
| Problem | Solution |
|---|---|
| My device will not connect to Bluetooth Speaker. | Bluetooth is not on: Go to Settings and turn Bluetooth on, then search for "AI 902." Device is out of range: Move the device closer to the humidifier. Your device should stay connected up to 75 feet, depending on surroundings. A different device is connected: Disconnect the current device and re-connect with another (see pg. 5, "Pairing Your Device"). |
| Weak or no mist output. | The water in the unit is too cold: Replace with cool but not cold water or set output to High and wait 10-15 minutes. The surface of the Ultrasonic Nebulizer is dirty: Clean the Ultrasonic Nebulizer (see pg. 6 “White Dust Cleaning”). Ultrasonic Nebulizer is not working: See Warranty. Air Holes in Lid are blocked: Do not cover or block air holes. |
| White dust is forming on nearby furniture. | Hard tap water may deposit a certain amount of dust. Visit our website (www.Air-Innovations.com) to purchase Humidifier Demineralization Filters or use distilled water. |
| Water is leaking. | Water Tank Installation: Make sure the tank is correctly attached (see pg. 4 "Filling the Water Tank"). Humidifier is not on a level surface: Place on a level surface. |
| Condensation is forming around humidifier or windows. | Mist output level is too high for room size: Decrease the mist output. Direction of Rotating Mist Nozzle: Change the direction of the nozzle. |
| 4 LED lights continuously flash for more than one minute. | Unit is in Alert Mode: Unplug and restart the humidifier. If the problem continues, call our Customer Service Center for assistance. |
| Missing parts. | Call toll free at: 844-600-1370, Monday thru Friday 8:30am to 5pm EST. Please reference model: MH-902. |
Try These Other Great Products For Your Life!
Available at: www.ForLifeProducts.com, www.Air-Innovations.com, www.Pursfection.com, www.RejuvenateProducts.com
Product Categories: Ultrasonic Humidifiers, Air Purifiers, Fans
Brands: Air Innovations, Pursfection, Rejuvenate
1-YEAR WARRANTY - MH-902
Air Innovations® Clean Mist™ Top-Fill Sensa Touch™ Humidifier with Crisp Sound™ Bluetooth Speaker & Aroma Tray comes with a 1-year manufacturer's warranty. If this unit should become defective within 1-year from the date of purchase, or if you have any questions or comments regarding replacements for any of our products, please contact us directly:
Contact Us:
Call toll free at: 844-600-1370 (Monday thru Friday 8:30 AM to 5:00 PM EST.)
Visit us on the web at: www.Air-Innovations.com
E-mail us: sales@air-innovations.com
Or write us:
Great Innovations, LLC
Att: Quality Assurance Dept.
2301 SW 145th Ave.
Miramar, FL. 33027 USA
Please fill out the warranty card and mail back to the above address. Or, register your warranty online today by going to: www.Air-Innovations.com
Warranty Registration Form:
- NAME:
- ADDRESS:
- CITY:
- STATE:
- ZIP:
- TELEPHONE:
- E-MAIL:
- DATE OF PURCHASE:
- PLACE OF PURCHASE:
Please check here if you would not like to receive any solicitations from our company.
Warranty Conditions:
In the first year, all repairs will be performed free of charge or the unit will be replaced. This warranty is not transferable; it is valid only for the original purchaser. This warranty will be voided if the unit is subjected to unauthorized repair or impact damage. If you have any questions, please call toll free: 844-600-1370. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
