Samsung VS15A60**** Cordless Stick Vacuum Cleaner

Product Overview

The Samsung VS15A60**** is a cordless stick vacuum cleaner designed for efficient home cleaning.

Components

• Dustbin & Filter: Washable microfilter, Metal mesh filter, Dustbin.
• Main Unit: Handle, Power button, Suction power control button, Dustbin release button, Fine dust filter, Dustbin, Pipe, Battery level indicator, Battery charger, Battery release button, Battery.
• Wall Mount: Charging part, Accessory holder, Battery charger.
• Accessories: Charger, Pipe, Battery, Extension Crevice Tool, Motorized Tool, Wall Mount (includes screws and anchors), Jet Fit Brush, Combination Tool, Motorized Mini Tool.

Installation

Wall Mount Installation

The wall mount should be installed so its top edge is 113 cm from the floor.

1. Connect the charging cable to the vacuum cleaner's charging port.
2. Insert the charging cable into the wall mount.
3. Mark drilling points. Insert wall plugs (anchors) into the wall.
4. Secure the wall mount to the wall using screws.

Note: For detailed information, scan the QR code.

Operation

Battery Charging and Usage

• Charging: Charge the battery when the indicator shows the lowest level and blinks. Ensure proper connection to the charger. The vacuum cannot be used while charging. The battery level indicator lights up during charging and turns off approximately 30 minutes after completion.
• Battery Removal/Installation: Press the release button on the handle to remove the battery. Insert the battery fully until it clicks into place.
• Desktop Charger: The battery can also be charged using the desktop charger. Insert the battery fully until it clicks.

Vacuum Cleaner Operation

• Power Button: Press to start the vacuum in 'MID' mode.
• Suction Power Control: Use the '+' button to increase suction power and the '-' button to decrease it.

Using Attachments

Various attachments can be connected to the pipe or main unit. Ensure they click securely into place.

• Jet Fit Brush: For various floor types and carpets.
• Motorized Mini Tool: For cleaning bedding.
• Combination Tool: For cleaning curtains, furniture, sofas, etc.
• Extension Crevice Tool: For cleaning window frames, gaps, and corners.

Accessory Disassembly

To detach the pipe or brush, press the release button located at the rear of the part.

Note: Before disassembling, run the vacuum on 'MAX' for 10 seconds to clear residual items.

Maintenance

Cleaning the Dustbin and Filters

1. Remove the dustbin by releasing the lever.
2. Empty the dustbin.
3. Remove the filter assembly.
4. Clean the metal mesh filter.
5. Clean the washable microfilter and fine dust filter.
6. Reassemble the dustbin and filters.

Notes:

• Do not pull the rubber gasket attached to the metal mesh filter.
• After emptying, clean and dry the dustbin and filters in the shade. Exposure to high temperatures may cause deformation.

Washable Microfilter & Fine Dust Filter

• Wash these filters monthly to maintain efficiency.
• After washing, dry them completely in the shade for at least 24 hours before reuse.

Cleaning Attachments

• Clean attachments as needed. For the Jet Fit brush, if dirt is stuck, use scissors to remove it carefully.

Note: If the brush roll is blocked by debris, turn off the vacuum, remove the debris, and turn it back on. If it still doesn't work, repeat the power cycle. Be careful not to pinch your fingers when cleaning the brush.

Troubleshooting

• Vacuum not working: Check battery charge, ensure it's powered on, check for blockages in the pipe, dustbin, or nozzle, and ensure filters are installed correctly. Charge the battery if it hasn't been used for a long time. Replace the battery if its lifespan is exhausted.
• Reduced suction / Vibrating sound: Check for blockages in the nozzle, dustbin, or pipe. Empty the dustbin if full. Clean the filter if dirty.
• Charging impossible: Check if charging contacts are dirty and clean them. Ensure the vacuum is on and the battery indicator is lit.
• Rotating brush not working: If the brush lock indicator is on, turn off the vacuum and remove any foreign objects from the brush roll. Turn it back on. If the vacuum overheats with the Jet Fit brush, allow it to cool for about 30 minutes.
• Unpleasant smell: Regularly clean the dustbin and filters. A slight smell may occur initially.
• Small particles falling out: After cleaning, run the vacuum for at least 10 seconds to collect residual particles.
• Vacuum stops during cleaning: This may be due to overheat protection if the dustbin is full, a clogged inlet/nozzle, or prolonged use of the crevice tool. Resolve the issue and restart the vacuum.
• Static electricity: This can occur with certain carpet materials. Rub the brush on the floor several times to discharge static before cleaning.

Technical Specifications

Manufacturer: Samsung Electronics Co., Ltd.

Country of Manufacture: Vietnam

Service Life: 7 years (under normal usage conditions)

Safety Precautions

⚠️ WARNING:

• Read all instructions before use.
• Do not use on wet surfaces or outdoors.
• Keep away from heat sources and flammable materials.
• Do not use for picking up liquids, hot ashes, or sharp objects.
• Supervise children and do not allow them to play with the device.
• Unplug by pulling the plug, not the cord.
• Do not disassemble the battery or the device.
• If the power cord is damaged, contact Samsung service for replacement.
• Do not immerse the device in water for cleaning.
• Do not use the vacuum cleaner without the dustbin or filters installed.
• Avoid blocking air inlets or outlets.
• Do not step on or drop the device.
• Be careful not to pinch fingers during assembly or operation.
• Do not use near flammable aerosols or volatile substances.
• If the device emits unusual sounds, smells, or smoke, turn it off immediately and contact Samsung service.
• Do not use the vacuum cleaner for collecting toxic materials like bleach or drain cleaner.
• Do not use the vacuum cleaner to pick up burning or smoking items like cigarettes or hot ash.
• Do not use the vacuum cleaner in areas with high concentrations of flammable dust or explosive vapors.
• Do not use the vacuum cleaner to collect spilled drinks or pet waste.
• Do not use the vacuum cleaner in direct sunlight or high temperatures.
• Do not use the vacuum cleaner in areas with high humidity or water-covered surfaces.
• If the device malfunctions, unplug it and contact Samsung service.
• Do not use extension cords or outlets with insufficient power rating.
• Do not charge disposable batteries.
• Do not break or incinerate batteries; they may explode.
• Do not attempt to open the wall mount. Repairs should only be performed by qualified Samsung service personnel.
• Do not expose the wall mount to high temperatures or moisture.
• Do not touch charging contacts with metal objects.
• Ensure battery contacts do not touch conductive materials.
• Do not allow liquids to enter the vacuum or wall mount.
• Use the wall mount only as intended.
• Do not step on or hit the unit; risk of injury or damage.
• Do not block air intake/exhaust; risk of overheating.
• Hold the vacuum with both hands during operation.
• Do not use on scratchable surfaces like monitors or stainless steel.
• Do not store the vacuum in a car.
• Do not use water to clean the vacuum while it is in use.
• Do not use the vacuum cleaner in dry locations only.
• Do not use the vacuum cleaner in areas with high humidity or water-covered surfaces.
• Do not use the vacuum cleaner to collect spilled drinks or pet waste.
• Do not use the vacuum cleaner in areas exposed to direct sunlight or high temperatures.
• Turn off the device before cleaning or performing maintenance.
• Clean the exterior with a dry cloth. Do not spray water directly onto the body. Do not use volatile substances like benzene, solvent, or alcohol for cleaning.
• If water enters the device, turn it off and contact Samsung service.
• Clean the wall mount after disconnecting the device.
• Do not use alkaline, acidic, or industrial detergents, air fresheners, or vinegar for cleaning washable parts. These can damage plastic parts, cause deformation, or fading.
• Do not lean on the vacuum when it is in the wall mount; risk of injury or damage.
• Do not allow children to hang on or lean on the wall mount.
• If taking a break, lay the vacuum on the floor.
• Do not charge the vacuum near windows, heaters, or bathrooms.
• Place the vacuum securely in the wall mount or on the floor after use.
• Do not lean the vacuum against a wall or table.
• Do not let children ride on or play with the vacuum.
• Turn off the vacuum before plugging or unplugging the wall mount.
• Be careful not to get injured by moving or rotating parts.
• Do not let body parts like hair get sucked into the nozzle.
• Hold the device with both hands when cleaning walls or ceilings.
• If the brush roll is blocked by debris, turn off the vacuum, remove the debris, and turn it back on. If it still doesn't work, repeat the power cycle. Be careful not to pinch your fingers when cleaning the brush.
• If the vacuum overheats, allow it to cool down.
• If the battery is not charging or discharges too quickly, replace it.
• Use only manufacturer-supplied wall mounts and batteries.
• The vacuum may not operate below 5°C or above 45°C to protect the motor and battery.

Disposal Information:

The product and its accessories should not be disposed of with household waste. Recycle them properly. Contact local authorities for disposal information.