Morris MPH-10331 Air to Water Heat Pump - Technical Data
This document provides the technical specifications for the Morris MPH-10331 Air to Water Heat Pump.
General Information
| Model(s): | MPH-10331 |
| Air-to-water heat pump: | yes |
| Water-to-water heat pump: | no |
| Brine-to-water heat pump: | no |
| Low-temperature heat pump: | no |
| Equipped with a supplementary heater: | yes |
| Heat pump combination heater: | no |
| Declared climate condition: | average / warmer / colder |
| Parameters are declared for low-temperature application. | |
Technical Parameters - Heating
| Item | Symbol | Value | Unit | Item | Symbol | Value | Unit |
|---|---|---|---|---|---|---|---|
| Rated heat output (*) | Prated | 9 | kW | Seasonal space heating energy efficiency | ηs | 199 | % |
| Declared capacity for heating for part load at indoor temperature 20 °C and outdoor temperature Tj | Declared coefficient of performance or primary energy ratio for part load at indoor temperature 20 °C and outdoor temperature Tj | ||||||
| Tj = -7°C | Pdh | 8.0 | kW | Tj = -7°C | COPd | 2.99 | - |
| Tj = + 2°C | Pdh | 5.0 | kW | Tj = + 2°C | COP | 4.97 | - |
| Tj = + 7°C | Pdh | 3.1 | kW | Tj = + 7°C | COP | 6.78 | - |
| Tj = + 12°C | Pdh | 2.0 | kW | Tj = + 12°C | COP | 9.10 | - |
| Tj = bivalent temperature | Pdh | 8.0 | kW | Tj = bivalent temperature | COP | 2.99 | - |
| Tj = operation limit temperature | Pdh | 7.3 | kW | Tj = operation limit temperature | COPd | 2.72 | - |
| For air-to-water heat pumps: Tj = – 15°C (if TOL < -20°C) | Pdh | N/A | kW | For air-to-water heat pumps: Tj = – 15°C (if TOL < -20°C) | COPd | N/A | - |
| Bivalent temperature | Tbiv | -7 | °C | For air-to-water heat pumps: Operation limit temperature | TOL | -10 | °C |
| Cycling interval capacity for heating | Pcych | N/A | kW | Cycling interval efficiency | COPcyc | N/A | - |
| Degradation co-efficient (**) | Cdh | 0.9 | - | Heating water operating limit temperature | WTOL | 65 | °C |
Power Consumption and Other Items
| Item | Symbol | Value | Unit | Item | Symbol | Value | Unit |
|---|---|---|---|---|---|---|---|
| Power consumption in modes other than active mode | Supplementary heater | ||||||
| Off mode | POFF | 0.014 | kW | Rated heat output (**) | Psup | 1.7 | kW |
| Thermostat-off mode | PTO | 0.024 | kW | Type of energy input | Electric | ||
| Standby mode | PSB | 0.014 | kW | ||||
| Crankcase heater mode | PCK | 0.000 | kW | ||||
| Other items | |||||||
| Capacity control | variable | For air-to-water heat pumps: Rated air flow rate, outdoors | 4500 | m³/h | |||
| Sound power level, indoors/ outdoors | LWA | -/61 | dB | For water- or brine-to-water heat pumps: Rated brine or water flow rate, outdoor heat exchanger | - | N/A | m³/h |
| Annual energy consumption | QHE | 3702 | kWh | For heat pump combination heater: | |||
| Declared load profile | Water heating energy efficiency | ηwh | N/A | % | |||
| Daily electricity consumption | Qelec | N/A | kWh | Daily fuel consumption | Qfuel | N/A | kWh |
| Annual electricity consumption | AEC | N/A | kWh | Annual fuel consumption | AFC | N/A | GJ |
| (*) For heat pump space heaters and heat pump combination heaters, the rated heat output Prated is equal to the design load for heating Pdesignh, and the rated heat output of a supplementary heater Psup is equal to the supplementary capacity for heating sup(Tj). (**) If Cdh is not determined by measurement then the default degradation coefficient is Cdh = 0.9. | |||||||
Technical Parameters - Cooling
| Item | Symbol | Value | Unit | Item | Symbol | Value | Unit |
|---|---|---|---|---|---|---|---|
| Model(s): | MPH-10331 | ||||||
| Outdoor side heat exchanger of chiller: | Air to water | ||||||
| Indoor side heat exchanger chiller: | Water | ||||||
| Type: | compressor driven vapour compression | ||||||
| Driver of compressor: | Electric motor | ||||||
| Rated cooling capacity | Prated,c | 8 | kW | Seasonal space cooling energy efficiency | ηs,c | 212 | % |
| Declared capacity for cooling for part load at given outdoor temperature Tj | Declared energy efficiency ratio for cooling for part load at given outdoor temperature Tj | ||||||
| Tj = + 35°C | Pdc | 8.1 | kW | Tj = +35°C | EERd | 3.16 | - |
| Tj = + 30°C | Pdc | 6.6 | kW | Tj = + 30°C | EERd | 4.38 | - |
| Tj = + 25°C | Pdc | 4.3 | kW | Tj = + 25°C | EERd | 6.18 | - |
| Tj = + 20°C | Pdc | 1.9 | kW | Tj = + 20°C | EERd | 8.17 | - |
| Degradation co-efficient of chiller (*) | Cdc | 0.9 | - | Power consumption in modes other than "active mode" | |||
| Off mode | POFF | 0.014 | kW | Crankcase heater mode | PCK | 0.000 | kW |
| Thermostat-off mode | PTO | 0.024 | kW | Standby mode | PSB | 0.014 | kW |
| Other items | |||||||
| Capacity control | variable | For air-to-water comfort chillers: air flow rate, outdoor measured | - | 4500 | m³/h | ||
| Sound power level, indoors/ outdoors | LWA | -/61 | dB | For water/brine-to-water chillers: Rated brine or water flow rate, outdoor side heat exchanger | - | N/A | m³/h |
| Emissions of nitrogen oxide (if applicable) | NOx(**) | mg/kWh input GCV | GWP of the refrigerant | 675 | kg CO2 eq (100 years) | ||
| Standard rating conditions used | Low temperature application | ||||||
| (*) If Cdc is not determined by measurement then the default degradation coefficient of chillers shall be 0.9. (**) From 26 September 2018. | |||||||
Contact Information
For contact details, please refer to the back cover of the manual.
Kalliopi Karyda & Co., LP
87A, 17is Noemvriou str.
55535, Pylea, Greece
Tel. 2316 006600
www.morris.gr
Καλλιόπη Καρύδα & ΣΙΑ Ε.Ε
17ης Νοεμβρίου 87Α,
55535, Πυλαία, Ελλάδα
Τηλ. 2316 006600
www.morris.gr
