[FOXEER Logo]
[FALKOR Logo]
Foxeer Falkor Series FPV Cameras
Models: Falkor Mini, Falkor Micro, Falkor G-WDR Camera
Introduction
This document provides instructions for connecting and configuring the Foxeer Falkor series of FPV cameras, including the Falkor Mini, Falkor Micro, and Falkor G-WDR Camera.
Important Information
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury.
⚠️ Age Recommendation: Not for children under 14 years. This is not a toy.
NOTICE: This product is only intended for use with unmanned, hobby-grade, remote-controlled vehicles and aircraft. FOXEER disclaims all liability outside of the intended purpose and will not provide warranty service related thereto.
SUPPORT: Visit www.foxeer.com to get more information.
Camera-Video Transmitter Connection
To connect the camera directly to the video transmitter, plug the 3-pin wiring harness from the video transmitter into the camera, or you can power the camera by other devices such as PDB, FC, or battery.
Camera-OSD Switch Connection
3 Pin To Video Transmitter
This connector typically carries the VBAT+ (Voltage Battery Positive) signal.
2 Pin To OSD Switch board
This connector is for the OSD switch board, allowing control of menu navigation (UP, DOWN, LEFT, RIGHT, MENU).
5 Pin Harness
Details of the 5-pin harness connected to the camera:
| Pin | Function/Color | Description |
|---|---|---|
| VCC | DC 5-40V in (Red) | Power input for the camera. |
| GND | Ground Wire (Black) | Ground connection. |
| VID | Video out (Yellow) | Video signal output. |
| VSEN | Voltage Sensor (Blue) | Connect the VSEN cable wherever you want to detect the voltage. |
| OSD | OSD (White) | OSD signal for menu control. |
CAUTION: If you are using ESCs with active braking, we recommend powering the camera system through a BEC or voltage regulator.
