Yard Force LX PS1200 1000W Portable Power Station
Original Instructions / Original-Bedienungsanleitung / Manuel d'origine
Safety Symbols
Safety symbols are used to draw your attention to possible dangers. They require your careful attention and full understanding. These warnings do not, by themselves, eliminate any danger and are not a substitute for proper accident prevention measures.
WARNING: Read and understand all safety instructions in this manual, including all safety alert symbols such as “DANGER,” “WARNING,” and “CAUTION,” before using this tool. Failure to follow all instructions listed below may result in electric shock, fire, and/or serious personal injury.
SAFETY ALERT SYMBOL: Indicates DANGER, WARNING, or CAUTION. May be used in conjunction with other symbols or pictographs.
This chapter depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate.
- Read the instructions for use before use! [!]
- Batteries contain Li-ion. Do not dispose of waste batteries in domestic waste. Contact local authority to find out how to dispose of batteries. [♻️]
- WEEE symbol. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice. [?️]
- Do not throw into water. [??]
- Do not throw to fire. [??]
- Do not subject the battery to strong sunlight over long periods of time. Do not leave on a heater (max. 45°C). [☀️➡️?]
- Do not expose to rain or water. [?️?]
The product complies with the applicable European directives and an evaluation method of conformity for these directives was done. [CE]
General Safety Warnings
IMPORTANT SAFETY INSTRUCTIONS
- WARNING! Keep dry and do not expose to high heat.
- WARNING! Never disassemble, puncture, shock, crash, short, or incinerate.
- WARNING! Recycle and dispose in accordance with local regulation.
When using this product, basic precautions should always be followed, including the following:
- Please read the instruction manual before using this product.
- To reduce the risk of injury, close supervision is necessary when using this product near children.
- Do not put fingers, hands, or any body part into the product.
- Use of an unrecommended attachment or third-party power station manufacturer may result in a risk of fire, electric shock, or injury.
- Do not use a damaged or modified battery pack or appliance.
- Do not operate the power station with a damaged cord, plug, or output cable.
- When service or repair is required, do not disassemble the power pack yourself. Take the unit to a qualified service provider. Incorrect reassembly may result in a risk of fire or electric shock.
- In order to reduce the risk of electric shock when the product fails, disconnect the portable power station from the power supply before performing any instructive maintenance operations.
- Charge the internal battery in a well-ventilated area. Do not restrict ventilation.
- Under harsh conditions, liquid may be ejected from the battery. Avoid contact with the battery and liquid. If contact accidentally occurs, flush with water. If liquid contacts eyes, seek additional medical help.
- Do not expose the unit to fire or excessive heat.
- Have servicing performed by a qualified repair person only.
SAVE THESE INSTRUCTIONS
Description of Product
The Yard Force LX PS1200 features a charging interface with ports for DC 6530 (10-25V, 100W), Anderson, Type C (100W and 18W), USB-A (18W x3), and a car charger (12V 120W).
The device has a button to switch it ON/OFF (press for 3s) and to activate the AC function. It also includes a light with 3 selectable modules.
The display shows:
- Battery Level Indicator: Shows the remaining battery percentage. It blinks when the battery is low.
- Time display: Shows remaining charge time (input) and remaining working time (output).
- Power indicator: Shows current input and output power levels.
- Function indicator: Indicates if AC or DC USB-A output is active.
- 50Hz: Indicates that the AC output function is active.
The power station supports pure sine wave output at 1200W, 230V - 50/60Hz (2 ports). It can support devices up to 2400W with X-boost.
Technical Data
| Model | LX PS1200 |
|---|---|
| Dimension | 25x 19 x 24 cm |
| Capacity | 974.4 Wh (22,4 V) |
| Net weight | 11.5 kg |
| Input port DC 6530 | 10-30 V, 7 A, Max 210 W |
| Anderson port | 10-30 V, 8 A, Max 240 W |
| AC output | Pure sine wave, 1200 W, 230 V -50/60 Hz (2 ports) |
| Max power devices supported by X-boost | 2400 W |
| USB-A QC | 5-12 V 18 W (3 ports) |
| Type C PD | Max 100 W (1 port) |
| Type C | Max 18 W (1 port) |
| Car charger | 12V 120 W (1 port) |
Operation
Charging the device
Charge the device with original adaptor:
- Connect the power plug with the adaptor.
- Charge the device by inserting the 6530 interface to the port.
- NOTE: only use the original charging adaptor!
- The display will show the current charging status when well connected.
Charge the device with Car cigarette lighter:
- Connect the wire with the 12V port in the vehicle.
- Charge the device by inserting the 6530 interface to the port.
- NOTE: only use the original charging adaptor!
- The display will show the current charging status when well connected.
Charge the device with the solar panel (sold separately):
- Charge the device by inserting the 6530 interface to the port.
- Charge the device by inserting the Anderson interface to the port.
- NOTE: please pay attention to the inlet limitation of the port for each model: DC 6530 port: 10-30 V, 7 A, Max 210 W; Anderson port: 10-30 V, 8 A, Max 240 W.
Switch ON the device
Press the button for 3s to switch on the device. DC output will be activated accordingly. When the device is powered ON, all the DC ports are ready to use.
Active the AC function
Press the AC button, the "AC" mark will light on in the display, which means the 2 AC ports are ready to use.
Maintenance and Storage
CLEAN
Caution! Protect the product from direct contact with water, and make sure that water doesn't get the opportunity to get in.
- Always clean the product thoroughly after each use with a damp cloth, sponge, or brush.
- Avoid oil and grease contamination (especially to gripping parts).
- If contamination should occur, wipe the product with a damp cloth moistened with soapy water.
- Never use aggressive cleaning agents, solvents, or chemicals for cleaning. Permanent damage to plastic parts could occur.
STORAGE
- Store the machine out of reach of children.
- Do not store the product in direct sunlight for long periods.
- For safety reasons, worn or damaged parts should be replaced.
- Store in the original packaging (if possible) in a clean, dry, dark, and frost-free place protected from dust and out of reach of children.
- Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting rust and corrosion.
- The ideal storage temperature is between 5°C and 30°C.
DISPOSAL
- Dispose of your device, accessories, and packaging in accordance with the requirements of environmental protection into the recycling collection center.
- This machine does not belong to the household waste. Save the environment and take this device to designated collection points where it will be received for free. For more information, please contact your local authority or nearest collection point. Improper disposal may be punished according to national regulations.
- The battery contains toxic substances. Toxic materials must be disposed of in a specified manner in order to prevent contamination of the environment. Take used batteries to a recycling center. Do not throw the battery into household waste, fire, or water.
To obtain the best life from the battery
- Never allow the device to completely discharge before recharging. The device should be placed on the charger whenever the battery pack is noticeably running down or the tool no longer performs a task it previously performed.
- Avoid conducting short charges. Make sure that the device is fully charged each time by allowing the adaptor to complete its full charging cycle.
- Avoid allowing loose items like screws or nails etc. to be stored with the device as these or similar items can short the device and cause a fire or explosion.
- Always unplug the device when not in use and store in a dry and secure place.
- Avoid charging or storing your device in temperatures below 5°C and above 45°C.
- After use, allow the device to cool down for approximately 30 minutes before attempting to recharge.
Declaration of Conformity
MEROTEC GmbH, Otto-Brenner-Str. 8, 47877 Willich, Germany, declares that the product: Machine Description: Power station LX PS1200/NV1000 complies with the essential health and safety requirements of the following directives: Low Voltage Directive 2014/35/EU, Electromagnetic Compatibility Directive 2014/30/EU, EC Directive 2011/65/EU and its amendment Directive (EU) 2015/863 (RoHS).
Standards and technical specifications referred to: EN 62368-1:2020+A11+2020, EN 55032:2015+A1:2020+A11:2020, EN IEC 61000-3-2:2019+A1:2021, EN 61000-3-3:2013+A1:2019+2019+A2:2021.
Date: 04.11.2022, Place: Willich, Name: Roland Menken, General Manager.
