KÄRCHER QuickStart

A. Assembly

1. Insert the handle into the main unit until it clicks into place. Ensure it is securely fastened.

B. Initial Setup & Charging

1. Place the device on its base.
2. Insert the cleaning rollers into the designated slots on the floor head. Push them in until they are fully seated.
3. Connect the charging cable to the device's charging port (1.) and then plug the power adapter into a wall socket (2.).
4. Allow the device to charge for approximately 4 hours. The battery indicator lights will progressively illuminate, showing the charge status (empty, quarter, half, three-quarters, full). A fully charged battery is indicated by all lights being solid (100%).
5. Once fully charged, disconnect the charging cable from the wall socket (1.) and then from the device (2.).
6. To remove the rollers for storage or transport, pull the handle back to tilt the device, then pull the rollers out.
7. Open the fresh water tank lid (1.), then lift the tank out (2.). Open the tank cap (3.).
8. Fill the fresh water tank with water up to the 'MAX' mark. Close the tank cap securely (2.) and reinsert the tank into the device (1.).
9. Close the fresh water tank lid.

C. Operation

1. To turn the device ON, press the 'ON' button (1.). To turn it OFF, press the 'OFF' button (3.). When operating, move the device back and forth to clean the floor (2.).
2. Allow the rollers to moisten for approximately 2 minutes before starting to clean. The indicator lights will show the moistening progress.

D. Cleaning & Maintenance

⚠ Do not rinse the device directly under running water (e.g., shower) or immerse it in a bucket of water. This can damage the electronics.

1. Remove the dirty water tank from the device.
2. Empty the dirty water tank (1.). Rinse the tank thoroughly with water (2.) and clean the filter (3.).
3. Remove the rollers from the dirty water tank.
4. Remove the rollers from the device by pulling them out.
5. Rinse the cleaning rollers under running water (1.) to remove dirt. Squeeze out excess water (2.).
6. Remove the roller cover from the floor head. Clean the roller cover and the floor head area thoroughly.
7. Reattach the roller cover to the floor head (1.) and ensure it clicks into place (2.).
8. The cleaning rollers can be machine washed at 60°C. Do not bleach (⊗), do not tumble dry (⌫), do not iron (⍼), and do not dry clean (Ⓧ).
9. Reinsert the cleaned rollers into the floor head.
10. Ensure the rollers are properly seated (1.) and secure them by pushing them in until they click (2.).
11. Place the device back onto its storage station.
12. Allow the rollers to air dry on the storage station. The device may have a drying function that circulates air to assist this process.