Evenflo Journey Stroller/Travel System

Important Information & Safety Warnings

READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS! FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH!

• NEVER leave child unattended. ALWAYS keep child in view while in the stroller.
• Adult assembly required. Handle unpacking and assembly with care; contains small parts and items with sharp edges.
• To prevent a choking hazard, remove and discard packing material before use.
• ALWAYS use waist restraint to avoid serious injury from falling or sliding out.
• DO NOT carry or roll stroller on stairs or escalators with child in it.
• DO NOT hang items on the handle bar or place them on the canopy, as this can tip the stroller and injure the child.
• Ensure the stroller is fully assembled and locked in the unfolded position before use.
• ALWAYS exercise care when going over curbs or steps. Never use the stroller for anything other than transporting your child.
• Push stroller at a normal walking pace only; faster strolling can cause loss of control and injury.
• DO NOT load console or pockets with over 2.5 lbs (1.1 kg) total.
• DO NOT load the main cargo basket with over 10 lbs (4.5 kg) total.
• DO NOT load side/rear cargo pockets with over 2 lbs (0.9 kg) per side/rear. Stroller may become unstable and tip over.
• DO NOT place hot liquids in the console; spills can burn your child.
• DO NOT raise or recline the seat with the child in the stroller.
• DO NOT use the stroller if any parts are missing or broken.
• DO NOT allow the child to climb on, into, out of, or around the stroller.
• DO NOT allow the child to stand on the footrest; the stroller may tip over and injure the child.
• DO NOT carry additional children, goods, or accessories in or on this stroller except as advised in these instructions. The stroller is intended for one child occupant and specified additional weights.
• Exercise care when folding or unfolding to prevent finger injury in hinge areas.
• NEVER leave the stroller on a hill or incline, even with brakes set; it may tip and injure the child.
• ALWAYS set brakes when the stroller is not being pushed to avoid accidental rolling.
• AVOID STRANGULATION:
• DO NOT suspend strings or toys from the canopy.
• DO NOT place the stroller near cords from window blinds, draperies, phones, etc.
• DO NOT place items with a string around your child's neck (e.g., hood strings, pacifier cords).
• When making adjustments, ensure all parts of the child's body are clear of any moving parts.
• The canopy is not intended to provide UV protection.
• Sharp or heavy objects in pockets may damage the stroller or injure the child.
• If not properly secured, the child may slip into leg openings and strangle.
• Only use the Evenflo Embrace™ infant car seat with this stroller. Other infant car seats or carriers may not fit and could cause serious injury.
• Refer to your infant car seat manufacturer's instructions for safety and keep them available.
• DO NOT lift the stroller by the infant car seat handle when installed.
• If unable to securely attach the infant car seat, remove it and contact Evenflo ParentLink.
• Ensure the infant car seat is securely snapped onto the child's tray and secured with the car seat stabilizer strap.
• Remove any blanket/boot options from infant car seats for proper attachment.

Child Requirements

• Maximum weight: 40 lbs (18 kg)
• Maximum height: 38 in. (96 cm)

Features

• Canopy
• Parent's handle
• One-hand auto fold
• Reclining seat back
• Pivoting child's tray
• Parent's console
• Car Seat Stabilizer Strap
• Child's seat
• Waist restraint
• Footrest
• Swivel wheels
• Cargo basket
• Brakes

Note: Not all features shown are available for all models. Some models may have extra zipper access to the cargo basket, larger wheels, rear suspension, carriage position, and wheel swivel locks.

Assembly Instructions

Step 1: Attach Parent's Handle

Place the folded stroller on the floor with the parent's console visible. Hold the parent's handle facing upward, then push it onto the stroller until it locks with audible clicks. Pull upward on the handle to ensure it is securely locked.

Step 2: Attach Cargo Basket

Lift the tubes at the rear of the cargo basket and push them into the stroller tubes until they lock with audible clicks. Pull upward on the basket to ensure it is securely locked.

Step 3: Unfold Stroller

Unlock the fold latch, then grab the parent's handle and pull upward to unfold the stroller. Ensure the stroller locks in the open position.

Step 4: Attach Footrest

*Slide the footrest downward and lock it into place. (This feature may not be on all models).

Step 5: Assemble Rear Wheels

Discard all packaging. Slide one wheel and a steel washer onto the axle. Insert a clevis pin through the end of the axle to secure the wheel, ensuring brake housings face the same direction. Install the hub cap by aligning its notch with the tallest rib in the wheel hub and pushing until it snaps into place. Repeat for the other side. (Extra clevis pin and steel washer are included).

Step 6: Attach Frame and Rear Axle Assembly

Turn the stroller upside down. Install the H-frame to the stroller frame legs until they lock with audible clicks. Hold the rear wheel/axle assembly with brake levers facing the handle and console. Slide the brake housings onto the H-frame until they lock. Pull upward on the assembly to ensure it is locked securely.

Step 7: Attach Front Wheels

Slide the front wheel assembly over the front frame leg until the locking tab clicks into place. Pull on the assembly to ensure it is locked securely. Repeat for the other side. To remove swivel wheels, press the locking tab and slide the wheel off.

Step 8: Attach Canopy

Insert the canopy support tubes into the canopy hinges until they lock with audible clicks. Pull upward on the tubes to ensure they are locked securely.

Step 9: Attach Parent's Console

Bring the parent's console up to the parent's handle. Gently pull out the side of the console and guide the hole over the post. Repeat on the other side.

Using Your Stroller

Canopy Operation: Pull the canopy hoop forward to extend it. Push the canopy toward the handle to close it.

Brakes: Step on the rear brake levers to lock the rear wheels. Lift the brake levers to release them.

Child Tray: To open the child's tray, slide the button on either side and lift the tray upward. The tray can be opened from either side.

Seat Recline/Raise:

• To recline the seat: Move the adjuster tab all the way to the left and lower the seat back.
• To raise the seat: Pull the D-ring to the right.

DO NOT raise or recline the seat with the child in the stroller.

Harness System:

• For 3-point or 5-point restraint: Lock the rear brakes. Place the baby in the seat. Bring the crotch panel up between the child's legs. Fasten each buckle and pull the straps to tighten the waist and shoulder restraints (shoulder restraints for 5-point only) for a snug fit.
• To loosen straps: Push the release button on the buckle and pull up.
• Once the child is properly restrained, close and lock the child's tray.

Changing Harness (5-point to 3-point): Remove each harness strap from each buckle. Remove both harness straps from the stroller seat back. Store the shoulder harness strap for future use.

Folding and Unfolding:

Care must be taken when folding or unfolding to prevent finger injury in hinge areas.

• To fold: Lock rear brakes, close canopy, remove child. Locate and raise the release handle. Hold the release handle and parent's handle and pull upward to unlock. Place one foot on the basket and push downward until folded. Lock the fold latch. The stroller will stand by itself.
• To unfold: Unlock the fold latch, grab the parent's handle, and pull upward.

Using with an Infant Car Seat

Only use the Evenflo Embrace infant car seat with this stroller. Other car seats/carriers may not fit and could cause serious injury.

Installation Steps:

1. Fully recline the seat back (refer to assembly step 8, or usage step 4 for recline).
2. Ensure the child's tray is securely latched.
3. The infant car seat MUST be rear-facing. Lower the infant car seat onto the child's tray and press down until it snaps into place.
4. Secure the front of the infant car seat with the car seat stabilizer strap. Lift the stabilizer strap over the hook.
5. Pull up on the car seat handle to test the lock.

To Remove Infant Car Seat: Disconnect the stabilizer strap and disengage the seat release handle on the back of the infant car seat.

Installation Checklist:

• Ensure infant car seat is rear-facing.
• Ensure infant car seat is securely locked onto the child's tray and secured with the stabilizer strap.
• Pull up on the car seat to test proper locking.

Care and Maintenance

• Clean minor spills and stains on cloth, vinyl, or plastic with cold water and mild soap. Air dry.
• Metal and plastic parts can be wiped with a soft damp cloth and dried with a soft cloth. DO NOT use abrasive cleaners or solvents.
• Occasional drops of vegetable oil may reduce wear on moving parts.

Limited Warranty

Evenflo warrants this product against defects in material or workmanship for 90 days from the original purchase date. Repair or replacement is at Evenflo's option. Proof of purchase is required. This warranty is extended only to the original purchaser and is not transferable. Contact Evenflo ParentLink for service.

Implied warranties of merchantability or fitness for a particular purpose are disclaimed to the extent permitted by law. Evenflo is not liable for incidental, consequential, special, or punitive damages.