TOOLPORT Tent Safety Instructions and User Guide
Introduction
Congratulations on the purchase of your new TOOLPORT tent. Our customer service department or authorized sales representative is available to answer your questions and provide valuable instructions. Your new tent offers the flexibility to plan many activities, serving as a shelter for parties, protection from the sun, a simple canopy, storage, and much more. Please follow the instructions below to ensure you enjoy your tent for a long time.
Important Information
Please read these assembly instructions carefully before using the tent and keep them for future reference.
Safety Guidelines
The tent has not been tested for wind and snow loads, unless explicitly stated by the manufacturer. Therefore, these loads are not covered by the warranty. Please monitor weather forecasts to properly secure or disassemble the tent when necessary.
⚠ Warnings
- Tents are intended for temporary accommodation and should be taken down in adverse weather conditions.
- Always maintain adequate distance from water pipes, gas lines, and electrical wiring to prevent damage. Consult local authorities for information on the location of these utilities.
- When using suitable heaters (information available from specialist retailers), maintain a minimum distance of 1.2 meters from any tarp material. Never use open fires or heaters with open flames (e.g., patio heaters, gas heaters) inside the tent.
- The person setting up the tent is responsible for its proper anchoring and overall safety. Anchoring must be checked regularly to ensure the tent's safety, prevent damage, and protect others. Correct anchoring extends the lifespan of the tent's components and the structure as a whole.
- Always wear a helmet, gloves, and sturdy footwear during setup. Heavy metal parts may have sharp edges and can be oily due to rust prevention treatment.
- During snowfall, it is crucial to regularly and promptly remove snow from the tarp. The same applies to heavy rainfall or loads from other materials.
- Keep spare parts out of reach of children.
⚠ Caution!
- Ensure the ground base is suitable for your intended use. Choose a level surface for the tent. Use only the provided materials. Do not touch or handle the tarps with sharp objects.
- Rubber straps are wear parts and should be replaced when worn. The tent can be used in temperatures slightly below freezing. However, the tarps must be stored at a minimum temperature of 10°C for a sufficient period and unfolded at this or a higher temperature to prevent cracking at folds.
- Each country has its own regulations for setting up mobile (tents) and immovable structures. Inquire with local authorities about any necessary permits for your intended use; in some countries, tent size is a determining factor for permits.
Before First Use
Unpack the boxes and check against the packing list to ensure all parts are present. Metal parts are protected by a thin layer of lubricant from the manufacturer. If parts are excessively oily, wipe them with a cloth. Please allow ample time for the initial setup; subsequent setups will be quicker. The assembly principle is simple; follow the illustrated steps. Securely screw the pipes to the connectors manually using a hex key or an electric screwdriver set to a maximum of level 2 to avoid material wear. Handle materials carefully.
Cleaning and Storage
Do not use aggressive cleaning agents for the tarps; mild alkaline water is best. Do not fold or pack the tent while it is wet; dry it thoroughly first. Do not modify the metal structure of the tent (e.g., by adding loads, welding, cutting, or deforming parts). Handle individual components with care. During disassembly, use the packing list again to check for completeness, ensuring all parts are available for the next setup. When storing the tent, ensure no other items are placed on top of it. The tent is for outdoor use only and should be stored outdoors only.
Environmental Protection
Help protect the environment: do not dispose of the tent or its parts with household waste. Take them to an official recycling point or contact the manufacturer or an authorized dealer. They will gladly assist you in recycling the tent correctly.
Guarantee and Customer Service
For more information or to order replacement parts and accessories, please contact TOOLPORT by email or phone. Our staff is happy to help. Please provide the article number when asking questions. The product is manufactured with great care and under constant control. If you find a defect, please contact our customer service by phone or email. Our service staff will coordinate the next steps with you as soon as possible. Please have your invoice ready.
