BLUETTI EP800 Installation Confirmation
EP800 SN: ____________________
Battery 1 SN: ____________________
Battery 2 SN: ____________________
Battery 3 SN: ____________________
Battery 4 SN: ____________________
Installation Date: ____________________
| Step | Task | Requirement | Checked (√) |
|---|---|---|---|
| Pre-installation | 1. Check the open circuit voltage and Max. MPPT current of PV arrays | Voc < 500V, Current < 12.5A/25A | |
| 2. Confirm the installation condition and environment | Refer to the User Manual. | ||
| 3. Check the packaging and unpack the EP800 System | Refer to the User Manual. | ||
| 4. Stack up the base and EP800 System units | Refer to the User Manual or YouTube channel: BLUETTI support. | ||
| Electrical connection | 1. Connect the grounding cables | Refer to the User Manual or YouTube channel: BLUETTI support. | |
| 2. Connect the GRID and BACKUP cables | |||
| 3. Connect the battery power cables between EP800 and B500 | |||
| 4. Connect the communication cable between EP800 and B500 | |||
| 5. Connect the battery expansion cables between B500s | |||
| 6. Connect the communication cables between B500s | |||
| 7. Install the IoT controller | |||
| Inspection | 1. Circuit inspection | Refer to the User Manual. | |
| 2. Power on the EP800 System (Keep System Switch OFF in the app) | Refer to the User Manual. | ||
| App test | 1. Firmware upgrade | Refer to the EP800 System App User Manual. | |
| 2. Advanced settings | Refer to the User Manual. | ||
| 3. Powering on the EP800 System (Turn System Switch ON in the app setting) | Refer to the User Manual or YouTube channel: BLUETTI support. | ||
| 4. EP800 System function testing | Test Grid charging/Backup UPS. | ||
| 5. App training for customers | Refer to the EP800 System App User Manual. |
Notice for installation
- Installation must be done by a licensed electrician.
- Improper installation may result in personal injury or death and property damage.
- Prepare the necessary tools and accessories before installation.
- Please read the EP800 Energy Storage System User Manual.
- Check whether the open circuit voltage of the solar array is lower than 500V and the cable connection condition.
- Make sure the router is set to IEEE 802.11 b/g/n 2.4GHz and disable the 5GHz band.
- Make an App training for customers and tell them the attention items.
- Keep the total load connected to the EP800 BACKUP terminal within the specified range: 3800W for single-phase and 7600W for split-phase installations.
- Do not connect the grid cables to the EP800 BACKUP terminal.
Contact Information
More information: Website: https://www.bluettipower.com | Email: service@bluettipower.com
