Installation Instructions
Note: Installation should only be performed by persons with electro-technical knowledge and experience. Not suitable for installation at locations near the sea or in other environments with a corrosive atmosphere.
- Ensure the main power source is turned off. Secure the power source to prevent accidental reactivation.
- Connect the device to the mains supply using the terminal block. Connect Live (Brown or Black), Neutral (Blue), and Ground (Green/Yellow) wires to the designated terminals.
- Make sure that all cables are connected securely to the terminals on the device.
- After installation is complete, reactivate the power source and test the function.
Notes on Disposal
This product is designated for separate collection at an appropriate collection point. Do not dispose of the product with household waste. For more information, contact the retailer or the local authority responsible for waste management.
Care Instructions
Before cleaning, disconnect the unit from other components if necessary. Do not use aggressive cleaning agents.
The unit has been carefully checked for defects. If you have a complaint, please return the product to the retailer where you purchased it, along with your proof of purchase. Ledvion is not liable for damage arising from incorrect handling, improper use, or wear and tear. Technical modifications for product improvement are reserved.
General Safety
- Read the manual carefully before use. Keep this manual for future reference.
- Use the product only for its intended purposes.
- Do not use this product if any part is damaged or defective. Replace the product immediately if damaged or defective.
- This product shall not be used by children without adult supervision. Children shall not play with the device.
- Do not modify the product in any way.
- Do not expose the product to water or moisture (IP 20). Do not immerse the product in water (IP 44-IP 67).
- Keep the product away from heat sources.
- Do not block the ventilation openings.
- Do not look directly into the LED lamp.
- Maintain a minimum distance of 1 meter between the lamp and the surface being illuminated.
Electrical Safety
- To reduce the risk of electric shock, this product should only be opened by an authorized technician when service is required.
- Do not use the product if the cable or plug is damaged or defective. It must be replaced by the manufacturer or an authorized repair agent.
- Before use, always ensure that the voltage matches the rating plate of the device.
- Make sure the cable does not hang over the edge of a worktop and cannot be accidentally caught or tripped over.
Warning
- The light source contained in this luminaire shall only be replaced by the manufacturer, their service agent, or a similarly qualified person.
- Caution: Risk of electric shock.
- The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire must be destroyed.
Disclaimer
Designs and specifications are subject to change without notice. All logos, brands, and product names are trademarks or registered trademarks of their respective holders and are hereby recognized as such. Please visit www.ledvion.com for more information about Ledvion and its products.
Documentation
This product has been manufactured and supplied in compliance with all relevant regulations and directives valid for all member states of the European Union. It complies with all applicable specifications and regulations in the country of sales.
Formal documentation, including the Declaration of Conformity, Material Safety Data Sheet, and product test report, is available upon request.
CE Declaration
This product complies with the following directives:
- LVD: 2014/35/EU
- EMC: 2014/30/EU
- RoHS: 2011/65/EU
- For products with Radio transmitter units: RED: 2014/53/EU
The complete Declaration of Conformity (DOC) can be found on the Ledvion website.
