Paulmann TUBS Outdoor Wall Light

Product Overview

This document provides installation and safety instructions for the Paulmann TUBS outdoor wall light series.

Model 946.48 (with PRI sensor)

Features a built-in motion sensor (PRI sensor).

Model 946.49 (without PRI sensor)

Requires an external motion sensor or switch.

Both models support an E27 bulb, maximum 15W, and are rated IP44 for outdoor use. Mounting hardware is included.

Installation Guide

Step A: Mounting the Base

Securely attach the mounting bracket to the wall or desired surface.

Step B: Prepare Mounting Holes

If necessary, break the pre-defined mounting holes on the bracket to accommodate your installation.

Step C: Mount the Fixture

Attach the main fixture body to the prepared mounting bracket. Ensure correct orientation (↑UP).

Follow Safety Instructions: Nr. 1-7, 10. The fixture is IP44 rated.

Step D: Wiring

Connect the electrical supply wires. The diagram shows cable entry points suitable for 7mm and 14mm cables.

[Diagram shows electrical connections]

Step E: Install Bulb and Close Fixture

Install the appropriate E27 light bulb (max. 15W). Close the fixture securely.

A checkmark (✔️) indicates correct installation; a cross (❌) indicates an error.

Step F: Bulb Specification

Use an E27 bulb with a maximum power of 15W.

Sensor Settings (Model 946.48)

The model 946.48 features an integrated motion sensor with adjustable settings.

Motion Detection Range

Detection range is up to 8 meters with a 120° detection angle.

Time Adjustment

The duration the light stays on after motion is detected can be adjusted from a minimum of 5 seconds to a maximum of 8 minutes.

Daylight Sensitivity

Adjust the lux level (e.g., 10 Lux) to control when the sensor activates. The light will activate only when ambient light is below the set threshold (e.g., <10 Lux).

Icons indicate actions: "move" (motion detected) and "leave" (no motion detected).

Recommended mounting height for optimal sensor performance: 1.5m - 2m.

Component Replaceability

The following components can be replaced without permanent damage to the luminaire:

• Component 1 (Light source) or Component 4 (Operating device) can be replaced by the end user.
• Component 2 (Light source) or Component 5 (Operating device) can be replaced by a qualified electrician.
• Component 3 (Light source) or Component 6 (Operating device) is not replaceable; the luminaire must be replaced.

Disposal Information

Old electrical appliances (♻️) must not be disposed of in household waste. They can be handed in at collection points of disposal organizations.

Old batteries (?) and rechargeable batteries (?), as well as lamps that can be removed from the old appliance without damage, must be separated from the old appliance before disposal at a collection point.

Retailers are obliged to take back this product free of charge. End-users of old appliances are responsible for deleting personal data on the old appliances to be disposed of.

For more information, visit www.paulmann.com.