SKN by Conair Cryoadvanced™ Cryotherapy Facial Brush
Instruction Manual
Important Safety Instructions
When using electrical appliances, especially when children are present, basic safety precautions should always be taken, including the following:
READ ALL INSTRUCTIONS BEFORE USING THE CRYOADVANCED™ CRYOTHERAPY FACIAL BRUSH
- 1. Close supervision is required when this product is used on, by or near children or people with certain disabilities.
- 2. Use product only for its intended use as described in this instruction booklet. Do not use attachments not recommended by the manufacturer.
- 3. Keep the cord away from heated surfaces.
- 4. Never use while sleepy or drowsy.
- 5. Never operate if the product is damaged.
- 6. Do not operate the charger if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged or if it has been dropped into water.
- 7. Do not place or store the charging base where it can fall or be pulled into a tub or sink.
- 8. Do not immerse charging base in water or any other liquids.
- 9. If charging base falls into water or another liquid, unplug immediately.
- 10. Not for use by children. Keep this product out of the reach of children.
- 11. Avoid contact with eyes.
- 12. Plug the adapter into the main outlet after checking that the voltage matches the listed technical data for the main outlet to be used.
- 13. Unplug from outlet when not in use and before servicing.
- 14. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- 15. Do not handle plug or appliance with wet hands.
The SKN by Conair Cryoadvanced™ Cryotherapy Facial Brush handle and charger have no serviceable parts. If the charger cord is damaged, it must be unplugged and replaced. Call 1-800-3-CONAIR for instructions or to purchase replacement parts.
SENSITIVITY AND CAUTIONS
SPECIAL CAUTIONS FOR SENSITIVE SKIN
The SKN by Conair Cryoadvanced™ Cryotherapy Facial Brush is a face cleansing device intended to help you achieve clean and healthy-looking skin. It is not a medical device and is not intended to treat any medical conditions, including acne.
If you are under a doctor's care for any skin condition or if you believe you have very sensitive skin, please consult your physician before use.
We recommend starting on the LOW setting and gradually increasing speed based on your skin's reaction to treatment. If rash or irritation occurs, discontinue use.
We recommend not sharing the brush head. Each user should have their own brush head.
NOTE: Removing makeup may cause the brush head to discolor. However, this will not affect performance, and the brush head can be used for its entire recommended life of 90 days.
If you experience any pain or discomfort during use, stop using the device and consult your physician.
OPERATION TIPS
Moisten your face and apply cleanser. Apply a small amount of cleanser to the moistened brush head. Do not apply pressure with the brush to the face; allow the vibration to perform the cleansing. When finished, rinse with water and dry your skin with a clean towel.
SAVE THESE INSTRUCTIONS
Get to Know Your Cryoadvanced™ Cryotherapy Facial Brush
SILICONE BRUSH: Provides gentle cleansing to remove dirt & oil from clogged pores.
POWER ON/OFF AND VIBRATION SETTING BUTTON: Controls power and vibration levels.
COOLING ON/OFF BUTTON: Activates the cooling feature.
COOL-TOUCH METAL PLATE: Helps to soothe inflammation, reduce puffiness & revitalize skin in minutes.
SKN by Conair Cryoadvanced™ Cryotherapy Facial Brush Features
2 TREATMENT OPTIONS
Two switches on the handle of your Cryoadvanced™ Cryotherapy Facial Brush allow you to customize facial treatments to suit your individual needs.
1: Vibration
2: Cooling
Press the power ON/OFF button once for the LOW setting, twice for MEDIUM, and three times for HIGH. The unit safely shuts off in 60 seconds.
SILICONE BRUSH: Reduces areas of dry skin and oily patches.
COOL-TOUCH METAL PLATE: Provides a 2.5-minute cryo facial for refreshed, radiant skin. The cooling feature safely shuts off after 2.5 minutes of operation.
NOTE: Your SKN by Conair Cryotherapy Facial Brush may include specific attachments. For replacement parts, brushes, or attachments, call 1-800-3-CONAIR or visit www.trueglowbyconair.com.
WATERPROOF
The SKN by Conair Cryotherapy Facial Brush is waterproof and can be used in the shower. It cannot be submerged in water.
RECHARGEABLE
The SKN by Conair Cryotherapy Facial Brush is cordless and requires a full charge before use. After a full charge, it can provide up to 30 minutes of use without recharging.
Charging the Cryoadvanced™ Cryotherapy Facial Brush
- Before using the Cryoadvanced™ Cryotherapy Facial Brush for the first time, it must be fully charged for 3-4 hours. Plug the USB cord from the charger base into a wall adapter (not included), then mount the facial brush onto the charger base to begin charging. The LED will pulse BLUE, indicating that the unit is charging.
- The charging indicator around the button will pulse BLUE during charging. Once fully charged, the light will turn solid BLUE. Always ensure the charging light illuminates when placing the sonic facial brush in the charging stand.
- The BLUE light will flash when the unit's battery capacity is low during operation.
- To maintain optimum battery capacity, give the sonic facial brush a full 3-4 hour continuous charge every 3 months.
- Unplug the adapter from the wall and the base when not in use. Do not unplug the adapter from the wall while it is still connected to the unit, as this will discharge the battery.
Starting the Cryotherapy Facial Brush and Selecting Speeds
Press the power ON/OFF button once to activate the unit. Press the cooling ON/OFF button once to activate the cryotherapy treatment.
Press the Cooling ON/Off button or the power ON/OFF button for more than 1 second to turn the cooling off.
****This will complete one cycle*****
To repeat the cycle, press the switch again.
Note: After 1-2.5 minutes into the second cycle, the cool plate temperature may be slightly higher due to heat generated in the first cycle. After two treatment cycles, the unit must cool down for 2 hours before repeating another two cycles.
VIBRATION FEATURE:
Press the power ON/OFF button once for LOW setting, twice for MEDIUM, and three times for HIGH setting.
STOPPING THE CRYOTHERAPY FACIAL BRUSH
At any time, the Cryotherapy Facial Brush can be stopped by pressing and holding the power ON/OFF button for more than 1 second.
TURNING OFF THE COOL-TOUCH METAL PLATE
At any time, the Cool-Touch Metal Plate can be turned off by pressing and holding the Cooling ON/OFF button for more than 1 second.
Operating Instructions
1. Wet your face and apply sufficient cleanser. Apply a small amount of cleanser to the wet brush head.
2. Turn the brush on and select the desired vibration setting. Press the power ON/OFF button once for LOW, twice for MEDIUM, and three times for HIGH.
3. Do not press the brush hard against your skin, as this will reduce its motion and effectiveness. Keep the brush in light contact with the skin.
4. Move the brush in a slow, circular motion around your face. Let the vibration perform the cleansing. NOTE: Do not apply treatment close to the eyes to avoid the risk of injury.
5. Press the cooling ON/OFF button once for a 2.5-minute cryo facial treatment.
6. Apply the plate to the 6 facial cleansing areas for 20 seconds each.
User Maintenance Instructions
Caring for Your SKN by Conair™ Cryotherapy Facial Brush
- After each use, wipe the brush handle with a damp cloth to remove any cleanser residue. Ensure charging contacts are clean by wiping with a damp cloth or alcohol wipes for proper charging.
- Once a week, clean the charger base to prevent cleanser buildup.
- Thoroughly clean the unit weekly by rinsing under warm, soapy water. Wipe with a dry cloth and store in its box or a clean, dry place.
- Rinse the facial brush under warm, soapy water to remove accumulated residue. Allow brush heads to air-dry. Store in a clean, dry place.
- Do not use abrasive cleaners.
- Do not place the unit in a dishwasher.
Troubleshooting Guide
THE CRYOTHERAPY FACIAL BRUSH IS NOT CHARGING.
NO ILLUMINATING BLUE LIGHT.
THE CHARGING LIGHT DOES NOT TURN SOLID BLUE.
- Ensure the contacts on the unit and base are clean. Refer to User Maintenance Instructions for cleaning procedures.
- Verify the adapter and USB plug are properly connected.
- Check the power outlet; ensure it is active. Most bathroom outlets have test/reset buttons. Press the reset button and recheck the outlet.
THE CRYOTHERAPY FACIAL BRUSH WILL NOT TURN OFF.
You must press and hold the ON/OFF button for more than 1 second to turn the unit off.
Battery Disposal
Contains Lithium-Ion batteries. Must be collected, recycled, or disposed of properly. Do not dispose of in municipal waste.
Under various state and local laws, it is illegal to dispose of this battery in the municipal waste stream. The EPA-certified RBRCTM battery recycling seal on the Lithium Ion batteries indicates Conair's voluntary participation in an industry program to collect and recycle these batteries at the end of their useful life. The RBRCTM program offers a convenient alternative to discarding used Lithium Ion batteries in trash or municipal waste, which may be illegal in your area. Please call 1-800-8-BATTERY for information on Li-ion battery recycling and disposal restrictions in your area. Conair's participation is part of our commitment to environmental preservation and conserving natural resources.
RBRCTM is a trademark of Rechargeable Battery Recycling Corporation.
The batteries are sealed inside the SKN by Conair Cryoadvanced™ Cryotherapy Facial Brush handle and cannot be easily removed for recycling. The entire SKN by Conair Cryoadvanced™ Cryotherapy Facial Brush handle must be returned for battery recycling.
Limited One-Year Warranty (U.S. and Canada Only)
Conair will repair or replace (at its option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the listed service center with proof of purchase. California residents need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. Without a purchase receipt, the warranty period is 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE 12-MONTH DURATION OF THIS WRITTEN WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.
WARNING
IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU'RE WRONG. KEEP AWAY FROM WATER
Electricity and water are a dangerous combination. An electrical appliance remains live even when switched off if plugged in. Always unplug appliances when not in use.
ALWAYS UNPLUG SMALL APPLIANCES
FCC MARKINGS
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly approved by Conair Corporation, the manufacturer of this product and the party responsible for compliance, could void the user's authority to operate the equipment.
SUPPLIER'S DECLARATION OF CONFORMITY
Brand: SKN by Conair™
Model No.: SFB12CRX
Description: Cryoadvanced™ Cryotherapy Facial Brush
Responsible Party: Conair LLC, 1 Cummings Point Road, Stamford, CT 06902 (203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation.
DATE OF ISSUE: 09/06/2022
Please register this product at register.conair.com
SERVICE CENTER
CONAIR LLC
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
Visit us on the web at www.conair.com
©2022 Conair LLC Glendale, AZ 85307