Instruction Manual for BenQ models including: GW2491, GW2491E, GW2491T, BL2491, BL2491T, BL2491T LCD Monitor, LCD Monitor, Monitor
a) Tear out tapes and mylar, then disconnect all the cables. b) Release all the screws. c) Lift up main frame and disconnect cable to remove it.
This treatment may only be performed in authorized handling plants. Product Name: LCD Monitor. Model No.: GW2491,GW2491E,GW2491T,BL2491,BL2491T. Page 2. 1 ...
Recycle Disassemble Instruction (Dismantled Information) Requirements according to ANNEX VII of DIRECTIVE 2012/19/EU on waste electrical and electronic equipment (WEEE) Materials and components with hazardous content LCDs may contain hazardous substances like Pb and BFRs which are covered by exemptions under the RoHS directive. However, the majority is present in the printed circuit boards assembly. In order to reduce emissions as much as possible, a complete disposal of the old appliance is required. This treatment may only be performed in authorized handling plants. Product Name: LCD Monitor Model No.: GW2491,GW2491E,GW2491T,BL2491,BL2491T 1.Disassembly Tools Tool Philips Screwdriver for M3 Screw Nosed Pliers Diagonal Cutting Pliers Slotted screwdriver Six Point Sockets Philips Screwdriver for M2.5 Screw Knife picture 2.Product exploded view Item Description 1 Deco 2 Panel 3 Mylar 4 Screw 5 Screw 6 Rubber lens-cover 7 Lens 8 Key board 9 Power board 10 Main board 11 Main frame 12 Screw 13 Screw 14 Rear cover 15 Screw 16 Hinge 17 Screw 18 Stand 19 Base 20 Screw Table 1 Disassembly parts list Item Description 21 Foot pad 3.External cable External cable Item Description Qty Unit P1 Power cable 1 PCS P2 HDMI cable 1 PCS 4.Product Disassembly Place the monitor face down on a smooth surface first. 1. Remove the stand and base. a) Hold the both protruding clips located on the base and squeeze them inward without releasing, at the same Time, use your thumb with the other hand against the base, push it downward until the base detached. b) Use the sharp object to press the protruded object, and hold the stand with the other hand to push it downward until the stand detached. 2. Remove the back cover. a) Release the screws first. b) Use the tool (not provided) starting from the opening to open all the latches of back cover slowly and carefully. c) Disconnect cable to remove back cover. 3. Remove main frame from the panel. a) Tear out tapes and mylar, then disconnect all the cables. b) Release all the screws. c) Lift up main frame and disconnect cable to remove it. 4. Take out bezel from panel. 5. Separate the board from the main frame. Turn over the main frame, remove mylar and release all the screws to separate boards from main frame. 6. Take out the key board from back cover. Do not miss the part remarked in yellow 5.Recycle characteristics Recycle characteristics Part Reuse Recycle WEEE annex VII Recovery Disposal No. 1,3,4,5,6,7,11,12,13,14,15,16,17,18,19,20,21 2,8,9,10, P1~P2 - 6.Disassembly Time Total time: 30 minutesMicrosoft: Print To PDF